|
| 1 | Safe Carriage of following material from Electricty store center Hathras to Pit site of work through the Kacha and Pakka road including loading and unloading at the respective ends including the cost of arrangement of labour, T&P, etc. which required for proper completion of work.(Distance 00-50 Kms.) |
| 2 | 8.5/11 Mtr. long PCC Poles. |
| 3 | 9/11 Mtr. ST Poles |
| 4 | 11 KV X-Arms, weasal conductor, G.I wire,Disc Insulators, Pin insulators, clamps and other required line material, if any. |
| 5 | Replacement of damaged 8.5/11 Mtr. long PCC pole by digging of pits in kharanja/mettalic road and dismantling of all 11KV/LT accessories from the existing / damaged pole and errection of single new pole including Fixing of all accessories. |
| 6 | Replacement of damaged 9/11 Mtr. long ST pole by digging of pits in kharanja/mettalic road and dismantling of all 11KV/LT accessories from the existing / damaged pole and errection of single new pole including Fixing of all accessories. |
| 7 | Straightening of tilted single PCC Poles in the existing lines as per direction of supervising engineer. |
| 8 | Straightening of tilted single ST Poles in the existing lines as per direction of supervising engineer. |
| 9 | Straightening of tilted Double Poles in the existing lines as per direction of supervising engineer. |
| 10 | Replacement of following damaged accessories in 11 KV /LT line - |
| 11 | 11 KV X-Arms, 11 KV Pin Insulators with Pin & Nut & Bolt , 'F' Clamp |
| 12 | 11 KV Disc Insulator With Fiting |
| 13 | Fixing of T. Channel |
| 14 | Errection and grouting of stays as per RESPO Norms and as per direction of supervising engineer with Grouting material i.e. cement, sand, brick ballast/stone ballast etc. shall be arranged by the contractor at his own cost. |
| 15 | Laying, sagging and stringing and Nozzling / binding etc. of new & old ACSR Weasal conductor / GI in 11 KV / LT lines as per RESPO manual and as per direction of supervising engineer. |
| 16 | ACSR Weasel conductor |
| 17 | ACSR Dog/Racoon conductor |
| 18 | 50/95/120 sqmm. Areal Bunch Conductor |
| 19 | Removal of Damaged/Burned LT Distribution Boxes & fixing of New at already/Nwly errected pole for giving supply to consumer by connecting consumer cabels by using appropriated alumunium lugs tape N&B Provided by conractor as per requirement. |
| 20 | Re- sagging and stringing of existing following conductor in HT /LT line as per direction of supervising engineer. |
| 21 | ACSR Weasel conductor |
| 22 | 50/95/120 sqmm. Areal Bunch Conductor |
| 23 | ACSR Dog Conductor |
| 24 | Cutting, chopping, triming of tree branches to clear the line route to give 2 mtr. horizontal and vertical clearance to the line coming in the route of different feeders as per direction of supervising engineer |
| 25 | Re Guarding / Guarding of 11 KV line by laying, stringing, sagging and binding of 2 Nos. parallel GI wire 6 SWG after providing, fabrication and fixing of guarding angle and fabrication and fixing of X-guards (Tillis) of GI wire at distance of 3 Mtr. |
| 26 | Digging of proper size of pit for following work of damaged steel support with the provision of temporary support :- Then reinforcement of steel support by welding of 04 Nos. 2 feet long M.S. angle iron of 50x50x6 mm. at equal distance around each pole & also welding of these angle iron with each other by providing M.S. flat of size 35x6 mm. in round. |
| 27 | Construction of round plinth around the S.T. Poles / RS Joists / Rails will be done with cement, sand and concrete in 1:3:6 ratio of size 450 mm. dia & 600 mm height (300 mm. under the ground + 300 mm. the ground). The plinth should be plastered with ½ inch thick cement and sand of ratio 1:4 & taper rounding the upper most part of the plinth. The rate will include all cost of material, labour and T&P etc. for completion of the above work which will be provided by the contractor at his own cost. Please Enable Macros to View BoQ information |
