Tender For Supply Installation And Fixing Of Decorative Poles On Gurugram Road Upto Amit Deswal Chowk,Bhadurgarh Road Upto Flyover And Maharaja Aggarsain Chowk To Ramesh Gas Agency In Mc Jhajjar., Jhajjar-Haryana
TDR : 55924293
Tender Notice
BOQ
8 Days Left
Jhajjar
Haryana
Tender For Supply Installation And Fixing Of Decorative Poles On Gurugram Road Upto Amit Deswal Chowk,Bhadurgarh Road Upto Flyover And Maharaja Aggarsain Chowk To Ramesh Gas Agency In Mc Jhajjar.
Name of Work:- Supply installation and fixing of decorative poles on Gurugram road upto Amit Deswal chowk,Bhadurgarh road upto flyover and Maharaja Aggarsain chowk to Ramesh gas agency in MC Jhajjar.
Sl. No.
Item Description
1
[2.B1152] B1152. G.I. back (jam) nuts 25 mm dia [Rate]
2
[23.1.6.1]COPPER WIRING IN MS CONDUIT (SURFACE/RECESS) 6.1. Wiring main ,sub mains and Circuit wiring in two single core for phase and neutral wire and one single core for earth wire PVC insulated Copper conductor cable 1100 Volts grade in MS Conduit etc as required. 1 run of Size 1.50 Sqmm(1/1.40mm) [Through Rate]
3
[24.2.2.2]LT CABLE 2.2. Laying of underground cable 0.75 metre below ground level covered with sand and bricks including excavation and refilling of trenches.:- 16 Sq mm to 35 sqmm 2 to 4 Core [Through Rate]
4
[24.4.4.4]STREET LIGHT 4.4. Erection of street light fitting on the pole including the cost of petty material required (irrespective of height/length of bracket) At Pole above 9 metres [Through Rate]
5
[24.5.2.1]MISCELLANEOUS ITEMS 2.1. S/E mark double walled corrugated (DWC) HDPE, pipe 10 Kg/Cm2 ,laid 0.75 Metre below ground level including digging and refilling of earth including cost of suitable size socket/coupler for HDPE pipe including the cost of labour and material required to complete the job in all respect up to the entire satisfaction of Engineer in charge of the work. DWC/HDPE pipe 40/32 mm outer dia/ inner dia [Through Rate]
6
9mtr The decorative pole MFMD - 009 made of Durable Mild steel witha total height of 9 mtr. above ground level, pole bottom base section shallbe 350x200x20mm, 4mm thickness column with predesigned laser cutpattern to illuminate the surroundings in 20w with noticeable mode, next-section of double pipe of size 76x7500x3mm to work together to formunique design with mid section of Illuminated in warm white 60w doublearm bracket of 3900mm long. The base plate of pole shall be size550x350x12mm. Provision for inside termination box with 4wayconnector and 1 nos. 6AMPS MCB for local isolation. The pole isprimarily coated with primer, secondary epoxy resin and top coated withUV stabilized PV Paint. The decorative pole is suitable for outdoorlighting application, pole light is complete in all aspects with allaccessories without foundation bolts.
7
Supply and Erection of 120W LED street light made of pressuredie cast aluminium housing with proper heat sink and clear high qualitypolycarbonate diffuser. The luminaire shall have minimum 110 LPW systemefficacy (not at chip level), power factor ) 95, THD 70 and CCT of 5600-6000K. Both Luminaire and driver shall have BIS and the 2 Luminaire shallbe IP 66 and IK08 protected. The fitting shall have bottom opening seperatedriver compartment and the driver should be potted. The LED shall haveaverage life of L70B50 at 50000hrs. Operating voltage range shall be 100-300V. LM79 and LM80 reports from in-house NABL accrediated LAB shallbe available for the fitting from the OEM. (Make - Havells, Crompton andHelonix) Please Enable Macros to View BoQ information
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
