|
| 1 | Rewinding of 40 HP VT motor & booster motor (centrifugal motor) Kirloskar make/equivalent make as per orignal winding 415 volt with super enamelled copper wire as per required guage complete all respect direction of E/I. It is also include the dismentling /refixing/cartage from site to workshp/ factory and vice versa. The old material will the property of contractor (Old material rate already deduct in) 40 HP, 1440 RPM |
| 2 | S/F Thrust bearing 7220 (Make SKF, Kayo, NTN or similar) (NSI-187) |
| 3 | S/F Ball bearing 6311 (Make :- SKF/Kayo, NTN or simillar) (NSI-188) |
| 4 | Supply & Fixing Flat Cable Finolex make. (AOR) |
| 5 | 35 Sqmm. 3 Core |
| 6 | 25 Sqmm. 3 Core |
| 7 | 16 sqmm 3 core |
| 8 | 10 sqmm 3 core |
| 9 | 6 sqmm 3 core |
| 10 | Supply & erection of overhead line with ACSR conductor on poles/service bracket including binding etc. complete in all respects. |
| 11 | Rewinding & Repairing of Transformer Kirlosker make/Equivalent make as per original winding 11/433 K/Volt with super enameled copper wire as required gauge complete all respect as per direction of Engineer in charge. It is also include the dismantling / Refixing /Cartage fromt site to workshop /factory and vice versa. The old material will the property of contractor. (Lod material rate already deducted in AOR) |
| 12 | 400 KVA |
| 13 | 250 KVA |
| 14 | Rewinding of 63 KVA transformer i/c changing of brunt coil, HT and LT coils bushing, gas kit, S/f required accessories complete with testing, dismantling and installation complete in all respect as per direction of E/I. AOR |
| 15 | Loading, unloading, cartage from site to workshop by crane and vice versa complete in all respect as per direction of E/I. AOR |
| 16 | S&F of 400 Amp. four pole change over switch on 50mm x 50mm x 6mm angle iron frame, including the cost of labour, T&P, painting and other material required for proper completion of the work as per direction and satisfaction of Engineer in charge. |
| 17 | Supply and laying of aluminium conductor PVC insulated armoured served sheathed cables 1100 Volts grade at a depth of 750 mm below ground level over a cushion of 75 mm thick sand all around and protected with burnt bricks on sides and on top. On surface the cable run shall be fixed on MS clamps etc. of suitable size or as directed by the Engineer in charge, complete in all respect. The armouring of the cable shall be properly connected with the earth conductor by clamps etc. (PS-501) |
| 18 | 400 sqmm 3½ core |
| 19 | 240 sqmm 3½ core |
| 20 | 70 sqmm 3½ core |
| 21 | 35 sqmm 3½ core |
| 22 | S/F of palm or pin type copper tin plated cable socket (lug) to the cable leads, insulating with tap and making connection etc. complete in all respect as per direction of E/I. |
| 23 | 400 Sqmm |
| 24 | 70 Sqmm |
| 25 | 35 Sqmm |
| 26 | 25 Sqmm |
| 27 | 16 sqmm |
| 28 | 6 sqmm |
| 29 | Supply and laying of 1800 mm x 900 mm x 12 mm thick chequered rubber matting of tested quality. |
| 30 | Supply and fixing of recess mounting round 15 to 18 Watt LED Down Lighter having Powder coated die cast aluminium housing with heat sink, diffuser/ Reflector and driver set complete in all respect. Catt-AAA |
| 31 | Supply and fixing of 36 Watt to 46 Watt indoor Recess mounting LED Square Fitting for Armstrong Ceiling having Powder coated die cast aluminium housing body with extended heat sink and diffuser of Special Polycarbonate meterial and driver set complete in all respect. Catt-AAA |
| 32 | Repairing of Fully Automatic Starter 50 HP as per following (Bassed on Approved Analysis) (AOR) |
| 33 | S/F of MNX 110 Amp. Contractor L&T Make |
| 34 | S/F of 125 Amp. MCCB L&T Make |
| 35 | S/F of Timer L&T Make |
| 36 | S/F of VPD Make Soft Hard |
| 37 | S/F of MPD Make Soft Hard |
| 38 | W/I C/Seal Moniter, Make Pump Care/Kishore |
| 39 | S/F of Control Transformer Make Electra Care/Pioneer |
| 40 | S/F Winding Temp. Relay Minilec Make |
| 41 | Auto Transformer suitable for 50 HP induction motor |
| 42 | Supply and fixing of LED Street light Fitting having die cast aluminium body and diffuser with driver set suitable for 45 watt to 50 Watt. Confirming to IP 66 protection complete in all respect. (CAT- AAA) |
| 43 | Supply and laying of 3 core standered aluminium conductor XLPE (Cross linked polyethylene) insulated PVC bedded, Galvanised flat steel strip armoured cables confirming to I.S. 7098 (Part-II with latest amendments) II KV grade at a depth of 900 mm below ground level over a cushion of 100 mm thick fine river sand all around and protected with well burnt bricks on sides and on top put across. The armouring of cable shall be properly connected with earth conductor by clamps etc. (120 sq. mm 3 core) |
| 44 | Combination fuse switches HRC Type (T.P.N.) S&F of 200 A. 415 V Metal clad TPN CFS complete with HRC fuse etc. on angle iron frame complete in all respect. (Cat.-B) |
| 45 | Combination fuse switches HRC Type (T.P.N.) S&F of 400 A. 415 V Metal clad TPN CFS complete with HRC fuse etc. on angle iron frame complete in all respect. (Cat.-B) |
| 46 | Painting of the electric pole with 2 coats of aluminium paint over red oxide primer complete in all respect. |
| 47 | S/F Submersible Motor pump CRI make. 7.5 HP |
| 48 | S/F Submersible Motor pump CRI make. 15 HP |
| 49 | S/F Submersible Motor pump CRI make. 20 HP |
| 50 | Supply & fixing steel tubular pole 9.50 Metre long designated 410 SP-35 in 1:3:6 cement concrete foundation including excavation back filling etc. complete in all respect. |
| 51 | S/F of M.S. specials such as Tee, bend, collars, pipe, tail piece, M.S. pipes etc. in required thickness of MS sheet complete in all respect as per direction by the E/I. |
| 52 | S/F of 3 Pole Power Contactor AC3 (MAKE- L & T. /SIEMENS/SCHNIEDER) |
| 53 | 70 Amp. |
| 54 | 95 Amp. |
| 55 | 110 Amp. |
| 56 | S/F of 11 KV TPMO Relco/Rama make 9 nos. insulator of Jai shree/BHEL/Rama/Rastriya make complete in all respects as per direction of E/I. |
| 57 | Supplying and making outdoor cable end termination with heat shrinkable jointing kit complete with all accessories including lugs suitable for following size of 3 core, XLPE aluminium conductor cable of 11 KV grade as required : |
| 58 | 70 sq. mm |
| 59 | 120 sq. mm |
| 60 | 240 sq. mm |
| 61 | supplying and making indoor cable end termination with heat shrinkable jointing kit complete with all accessories including lugs suitable for following size of 3 core, XLPE aluminium conductor cable of 11 KV grade as required : |
| 62 | 70 sq. mm |
| 63 | 120 sq. mm |
| 64 | 240 sq. mm |
| 65 | Supplying and making straight through cable jointing with cast resin compound, including ferrule and other jointing materials, for following size of 3 core, XLPE aluminium conductor cable of 11 KV grade as required : |
| 66 | 70 sq. mm |
| 67 | 120 sq. mm |
| 68 | 240 sq. mm Please Enable Macros to View BoQ information |
