|
| 1 | Dismantling of posts or struts (wood, steel or RCC) any section including taking out embeded portion and making good disturbed ground all as specified |
| 2 | Dismantling fencing wire mesh and ms iron fencing post any type. |
| 3 | Dismantling cast iron work / structural steel work of any description and in any position including doors, gates etc. complete all as specified and directed. |
| 4 | M & L for surface dressing nexc 15 cm deep, site clearance, to remove the bushes and making area workable. |
| 5 | Taking down cement plaster of any description built in cement mortar on brick or stone walls etc including racking out joints, hacking for Key, scrubbing down with water etc complete all as specified. |
| 6 | Excavation in post holes each not exceeding 0.5 Cum, getting out returning filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm watering and removing surplus soil to a distance not exceeding 50 M and making good surface all as specified. |
| 7 | M&L for cement concrete type C-1, 1:3:6 (40mm graded aggregate) as in foundation, filling and mass concrete all as specified |
| 8 | M &L for hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts;posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified & directed. |
| 9 | M&L for providing reinforced cement concrete type B-1, 1:2:4 (20mm graded aggregate) in precast post, fencing post, straing or terminal post, struts etc for fencing, average sectional area exc 100 and nexc 250 sq.cm, with or without chamfered angles and flat, splayed, rounded or mitred tops as directed and fixed all as specified |
| 10 | M & L for formwork to edges of concrete, opening in cocnrete walls, floors and roofs and side of RCC/PCC bands in walls and simillar work all exceeding 20 cm wide |
| 11 | M&L for TMT bars 6 to 8mm dia, cut to length, bent to shape required, including cranking, bending spirally for hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing clips |
| 12 | S&F Mild steel round bars 10mm dia and over as in strengthening bars for bending cranking spirallt for hooking for chain link, hooking end and welding with flats of chain link fencing Fe 410W (Gde E-250 ) quality -A or FE-290 (Gde E-165)complete all as specified . |
| 13 | S & F Galvanised 2 strand, steel barbed wire 2.24 mm dia barbed with with 2 mm dia barbs at 75 mm at spacing and straining and fixing to any type of standard rails straining bolts including securing or tying at crossings with land provision of galvanised mild steel pins etc as directed. |
| 14 | Supply only Chain link fencing incl line wires, any mesh, size and type to any standarards, rails straining bolts etc incl provn of binding wire.complete all as specefied and as directed. |
| 15 | Fixing only chain link fencing including fixing of line wires, any mesh, size and type to any type of staindard rails, straining bolts, etc. including provision of binding wire complete all as specified and as directed |
| 16 | S & F framed work such as grills, gratings, door etc with ends of bars shouldered and/riveted or forged into spikes; framed guard bars; barren iron doors; ladders; framed balusters,walk ways; railings and similar work incl cattle trap confirming to Fe.290.Gde-E-165. |
| 17 | M&L for two coats of synthetic enamel paint over a coat of Red oxide, Primer including preparation of surface over 10 cm width and girth etc |
| 18 | Dismantling of floor hearth wall tiling including cement mortar beddind but not backing removing serviceable material to store all as specified and directed. |
| 19 | 15-20 mm thick Granite (of any type) tiles machine cut, in skirting/ dado laid over cement screed and jointed with grey cement slurry, and pointed with white cement with admixture of pigment to match the shade ofgranite stone including grinding and polishing cement to match over 10 mm thick rendering in CM 1:4 complete all as specified and directed |
| 20 | M&L for coloured ceramic glazed tile (Premium quality), 7 to 8mm thick (square / rectangular) on vertical surfaces in Cement slurry and pointed in coloured cement to match over 10 mm thick rendering in CM 1:4 complete all as specified and directed |
| 21 | Demolition of cement concrete in ground floors and paving nexc 15cm thick above or below ground level all as specified. |
| 22 | M&L for 75mm thick cement concrete type C-2, 1:3:6 (40mm graded aggregate) as in plinth protection finished even and smooth without using extra cement complete all as specified |
| 23 | M&L 25 mm thick PCC 1:4:8 type D2 using 40mm graded stone agg as in filling Sub base/flooring complete all as specified and directed. |
| 24 | M &L chequered tiles (Cement) 20cm X 20cm x 25mm thick, set and jointed and pointed in neat cement slurry in floor with grey/coloured cement and pigment over & including 15mm thick screed bed in CM (1:6) Complete all as specified and directed. |
| 25 | M&L Providing and laying 60 mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50 mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sandt complete all as specified and directed. |
| 26 | M&L Providing and laying 80 mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50 mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sandt complete all as specified and directed. |
| 27 | Demolition of brick work/ stone boulder built in cement mortar or cement lime mortar and as directed. |
| 28 | M&L PCC type B1 1:2:4 (using 20mm graded curshed stone aggregate ) in lintels upto 1.5m clear span, cills, steps; seismic and other similar bands, plinth courses, string courses, lacing courses, parapets and railings upto 60 cm in height, copings, benching, kneelers, apex stones, bed plates, kerbs not provided for in Item 04028, water troughs and the like including weathering, slightly rounded or chamfered angles and throating, as directed |
| 29 | M&L for providing Pre cast cement concrete jalli 35 mm thick, in repairs type BO using 12.5 mm gradedaggregate, set in CM 1:4 all as specified |
| 30 | M & L Brickwork with fly ash bricks, straight or curved on plan exc 6m mean radius, built in cm (1:6), rise of hight for brick wall complete all as specified and as directed. |
| 31 | M& L, Brickwork, with subclass 'B' bricks in half brick thick honey comb work, built in CM 1:4. |
| 32 | M& L, Brickwork, with subclass 'B' bricks old size straight or curved on plan exc 6.M radius built in CM 1:6 but except Bricks etc complete all as specified and directed. |
| 33 | .-Ditto- but item No. 32 above but except brick |
| 34 | M&L walling of random rubble masonry uncoursed, well bonded, bedded and solidly hearted built in CM (1:6) all as specified |
| 35 | .-Ditto- but item No. 34 above but except stones. |
| 36 | M& L for 15mm thick rendering in CM 1:6 on fair faces of brick work or concrete surfaces, surface finished smooth and even without using extra cement etc complete all as specified and as directed. |
| 37 | M&L for preparation of New surfaces and applying two coats of cement base paint with roller with primer on New Surface complete all as specified and directed |
| 38 | Dismantling plain or corrugated steel sheeting , any gauge thickness including Nanital or similar pattern roof covering all as specified and as directed. |
| 39 | S&F, pre-painted galvatume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws /J hook complete all as specified and as directed. |
| 40 | Dismantling of timber scantling 40 sqcm and over for framed work and over in section, in any position |
| 41 | M&L Roof trusses,trussed, purlins, crane gantries, rails and fastenings and heavy bracket framing (Beam, tee, angle, channel or flat sections) including complete all as specified and directed. |
| 42 | M & L two coat of synthetic enamel paint over one coat of red oxide, zinc chrome primer on steel surfaces, surfaces of any description , over 10cm width or girth not other wise described complete all as specified and as directed. |
