|
| 1 | earthwork |
| 2 | Earth work in excavation by mechanical means (Hydraulic excavator)/ manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, for all lift, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. |
| 3 | 230 mm Brick masonary work in 1:4 ratio |
| 4 | Half brick masonary work 1:4 ratio |
| 5 | Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level. |
| 6 | Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level. Panel foundation |
| 7 | Centering and shuttering including strutting, propping etc. |
| 8 | Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete |
| 9 | upto plinth level |
| 10 | Supplying, fitting & fixing pipes with all necessary fittings in exposed or in trenches including trenching and refilling the same etc complete as directedb) ITC / NEZONE / Bansal / Jindal (Medium) 150 mm Heavy |
| 11 | Construction of gravel/soil aggregate base by providing well graded material, spreading in uniform layer. |
| 12 | Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complet |
| 13 | Supplying, fitting and fixing chain link fencing of 10 S.W.G, G.I. Wire 50mm x50mm mesh fitted to M.S angle iron post at 2000mm apart of specification detailed below including supplying, fitting and fixing hooks, eye bolts with nuts, staples and bolts including three horizontal lines of G.I wire 10 S.W.G at top,middle and bottom and with one vertical line to each fencing post for keeping the fencing tight and erect complete,including one coat of primer painting to M.S angle iron post in P.C.C base |
| 14 | Providing corrugated G.S. sheet roofing including vertical/ curved surface fixed with polymer coated J or L hooks, bolts and nuts 8 mm diameter with bitumen and G.I. limpet washers or with G.I. limpet washers filled with white lead, including a coat of approved steel primer and two coats of approved paint on overlapping of sheets complete (up to any pitch in horizontal/ vertical or curved surfaces), excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.0.63 mm thick with zinc coating not less than 275 gm/ m2 |
| 15 | 12 mm plaster of mix 1:4 |
| 16 | Painting enamel paint of approved brand. |
| 17 | whenever required as per specifications, drawings and instructions of Engineer-in-Charge. |
| 18 | Supplying & Fitting GI Slip on Flange 150 mm / 150# |
| 19 | Supplying & Fitting Gate Valve 150 mm / 150# |
| 20 | Supplying & Fitting Swing Check Valve (NRV) 150 mm /150# |
| 21 | Supplying & installation of GI Bend 90 degree, 150 mm dia |
| 22 | Providing and fixing mild steel round holding down bolts with nuts and washer plates complete. Please Enable Macros to View BoQ information |
