|
| 1 | S&F Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa with AZ 150 as in roof covering/cladding to wall, fixed with self tapping screws at any height complete all as specified and directed.including dismantling of old AC sheet etc. |
| 2 | Dismantling structural steel work including doors, gates but excluding framed truss etc complete all as specified and directed. |
| 3 | M & L for rolled sections as in main and cross beams, hip and jack rafters; purlins where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates complete all as specified and directed. |
| 4 | S & F fe 410 Framed work as in doors or gates of angle or other section with gusset plates, rails,braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing, complete all as specified and as directed. |
| 5 | Mild steel, plain, black sheet 0.80mm th in,steel gates and similar work, cut to size, holes punched; including round headed screws, clout nails or rivets and fixed to wood or steel framing with plain 40 mm lap joints with riveted or welded seams, including bending or turning up, mitred angles, etc. as required, complete all as specified and as directed. |
| 6 | M&L preparation of new or previously untreated steel surface of any description not otherwise described over 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed. |
| 7 | M&L for preparation of old steel surfaces of any description and applying one coat of synthetic enamel paint of selected colour at any height complete all as specified and directed. |
| 8 | Demolition of Cement Concrete in ground floors and pavings n exc 15 cm thickness (below or above ground level) un-reinforced cleaning the premises and removal of rubbish out side the MD land complete all as specified and directed. |
| 9 | Demolition of brick work / Stone masonary / PCC block masonary build in cement morter of any description and cleaning the premises and removal of rubbish out side the MD land complete all as specified and directed. |
| 10 | M&L for precast concrete solid block masonry exc 10cm width with solid block of PCC (1:5:8) Gde D-5 and setting in CM 1:6 complete all as specified and directed. |
| 11 | M&L Walling of random rubble, uncoursed, well bonded, bedded and solidly hearted, built in cement mortar 1:4 including complete all as specified and as directed. |
| 12 | Extra over stone walling for hammer dressing with maximum depression 40 mm to face stones and dressing of face beds and joints, as specified, of random rubble walling, uncoursed or brought upto courses complete all as specified and directed. |
| 13 | M&L for raised pointing to random or polygonal rubble, uncoursed or brought upto courses in cement mortar 1:4 complete all as specified and directed. |
| 14 | M&L for plain cement concrete (1:4:8) Type-D2 (using 40mm graded crushed stone aggregate) as in levelling course / sub base of flooring complete all as specified and directed. |
| 15 | M&L provinding cement concrete (1:2:4) B-1 using 20mm graded aggregate as in copings /haunching/ bearing course over brick walls etc and like complete all as specified. |
| 16 | M&L for TMT bar 8mm dia and over cut to length bent to shape reqd incl cranking bending etc complete & binding with MS wire (annealed) not less than 0.9mm dia in reinforcement complete all as specified and directed. |
| 17 | M&L machine cut kota stone slab flooring 20- 25mm thick over 20mm screed bed CM(1:4)cement screed base laid and jointed with grey cement slurry mixed with pigment to match the shade of the slab including rubbing and mirror polishing complete all as specified and directed. |
| 18 | Mirror polishing on marble/ granite/ Kota stone/ stone work where ever required to give high gloss finish complete. |
| 19 | M&L for rubber moulded glossy chequered cement concrete coloured tiles 30cm x 30cm x 20mm thick, set, jointed and pointed in neat cement slurry in floors over and including 20mm thick screed bed in cement mortar 1:6 complete all as specified and directed. |
| 20 | Taking down cement or cement lime plaster, any description, on brick or stone walls, etc including raking out joints, hacking for key, scrubbing down with water etc complete all as specified and directed. |
| 21 | M&L rendering 15mm thick in CM 1:4 on brick /stone surfaces finished even and smooth without using extra cement |
| 22 | M&L rendering 15mm thick on stone masonary surfaces other than fair faces of brick surfaces work or stone surfaces in CM 1:6 finished even and smooth without using extra cement complete all as specified and directed. |
| 23 | M&L for preparing new plastered or unplastered surfaces of walls and applying two coats of oil bound distemper over a coat of primer of same make over 1.5mm thick wall care putty complete all as specified and directed. |
| 24 | M&L for preparation newly plastered surfaces of wall and applying two coats of cement base paint over a coat of primer of same make over external wall surfaces complete all as specified and as directed. |
| 25 | Complete removal of existing treatment of old plastered surface of walls and applying two coat of cement based paint complete all as specified and directed. |
| 26 | S&F Steel ventilator with Top hung shutters including projecting type hinges with steel handle, and steel peg stay, complete with glazing bars, dovetailed or welded complete all as specified and directed. |
| 27 | Taking down old unserviceable point wiring (light/fan/socket/power) complete, including fixtures and fittings such as switches, sockets, ceiling roses, pendants, regulators etc and making good the disturbed surfaces of walls, floors, ceiling etc.complete all as specified and directed. |
| 28 | Taking down Main switches/DBs of any make and type including teakwood board, MCBs/MCCBs etc. complete and making good the disturbed surfaces including colour wash complete all as specified and directed. |
| 29 | M&L for point wiring for one light point controlled by one, one-way switch of any length using approved colour coding as per IS with stranded copper conductor 1.5 Sq.mm (Nominal area), single core, PVC insulated and unsheathed stranded FRLS H cable 1100 volts grade, ISI - 694 marked in and including PVC casing caping 25mm wide/PVC Surface conduits of appropriate size as per specification as requirerd at site and as directed of heavy duty ISI marked including all accessories etc. with PVC modular boxes/PVC Sunken Boxes as required at site and as directed including modular frame/cover plate suitable for mounting switches/sockets etc. and PVC insulated stranded copper conductor 1.5 Sq.mm single core cable as earth and connecting to common earth dolly complete all as specified and directed for the followings :- |
| 30 | (a) One light point controlled by one one way switch complete all as specified and directed |
| 31 | (b) Two light point controlled by one one way switch complete all as specified and directed |
| 32 | (c) One 3 pin 5 Amps socket outlet point on same board complete all as specified. |
| 33 | S&F modular switch 6A SP one - way 230V 1 module white/ivory finish complete all as specified and directed. |
| 34 | S&F modular socket outlet 2/3 pin 6 Amps, multipurpose 2 module 230 Volts, single pole one way suitable for plug tops, complete all as specified and directed. |
| 35 | S&F ceiling rose surface type three terminals complete all as specified and directed. |
| 36 | Supply and fix LED Tube light fittings 20W Surface and wall mounted LED batten, integrated electronic driver complete including all accessories internally pre-wired and including connecting up with twin core twisted flexible copper conductor cable of suitable size from ceiling rose to connector complete all as specified and directed. |
| 37 | S&F MCB SPN DB 4 way, double door, with rated current capacity rated busbar 240V, all as specified |
| 38 | S&F in replacement MCB Single pole rated capacity 6 to 32 Amps, 240 V breaking capacity 10 KA, C- curve complete all as specified and directed. |
| 39 | S&F in replacement MCB double pole of rated capacity 32 Amps, 240 volts breaking capacity 10 KA, C-curve complete all as specified and directed. |
| 40 | S&F LED flood light 150 W flood light luminaire with ultra high sleek, light weight with secondary optics made of pressure die-cast housings with toughned glass and individual high power LEDs with secondary optics IP 66 rating alongwith connected accessories complete all as specified and directed.Note: Necessary ladder arrangement shall be made by contractor to change the lights at heights in sheds. |
| 41 | Excavation in trenches, not exc 1.5 mtr wide and not exc 1.5 mtr in depth for laying of LT UG cable etc in soft/loose soil and getting out complete all as specified. |
| 42 | All as per item No 38 above but in Hard/dense soil. |
| 43 | Returning, filling in soil, including spreading, leveling watering and well ramming in layers not exceeding 25cm all as specified and directed. |
| 44 | Removing excavated material not exceeding 50m and depositing where directed at a level not exceeding 1.5 m above the starting point for any type of excavation. |
| 45 | M&L for road cutting/ hard standing cutting and making good with PCC 1:3:6 type C-2 (using 40 mm graded stone aggregate) of 150mm X 100mm in respect of width and thickness complete all as directed by Engineer-in-charge |
| 46 | Supply and laying of DWC (Double Wall corrugated) HDPE pipe ISI marked of outer dia 50 mm and inner dia 38 mm polythylene including coupler and bend with smooth internal and profiled external surfae for non pressure under groundcable complete all as specified |
| 47 | Supply, lay/clamped on wall/floor of Cable XLPE insulated screened PVC bedded, Galvanized steel strip or wire armoured, electric power cables (heavy duty) 1100 Volts grade with stranded aluminium |
| 48 | Supply and lay Cable XLPE insulated screened PVC bedded, Galvanized steel strip or wire armoured, electric power cables (heavy duty) 1100 Volts grade with stranded aluminium conductor of size 35 sqmm 3.5 core complete all as directed. |
| 49 | Supply and fixing in replacement LT Pannel board outdoor type factory made out of 3.15 mm thick CRCA sheet totally enclosed conforming to relevant IS/IEC, CPRI type tested and suitable bus bar including angle iron frame made out of 40x40x 5 mm angle iron frame duly powder coated, grouted and fixed on wall with PCC complete all as specified and as directed comprising the following :-(a) MCCB TPN 100 Amps, 415 Volts, AC, 50 Hz, 10 KA rupturing capacity as incoming - 01 No(b) MCB SPN 16 Amps, 230 Volts, AC, 50 Hz, 10 KA rupturing capacity as outgoing - 05 Nos(c) Digital timer for controlling the contactor, single phase, 230 Volts AC(d) MCB SP 06 Amps, 230 Volts, AC, 50 Hz - 03 Nos (f) Switch socket combination multipurpose 2 Jin 1, 3 pin, 5 and 15 Amp flush type universal complete. 01 Nos(e) Indicator lamps (RYB) - 01 Set(f) Digital multi functional multimeter for showing Volts/Amps/PF etc alongwith suitable rating CT coil - 01 Set(g) Control wiring for automatic operation of street lights with by pass arrangement all as specifiedand as directed.(h) Incoming and outgoing terminals for suitable cable |
| 50 | M&L for earthing with galvanised steel earth plate electrode 60cm x 60 cm x 6.3 mm burried directly in ground earth pit not less than 3.25 mtr deep below normal ground level with top edge of the plate vertically to depth of not less than 1.5 mtr below ground level connected to and including Gl strip of size 32 x 6 mm 7.5 mtr beyond the earth pit as earthing lead including Gl protection pipe 40 mm bore (light grade) upto 7.5 mtr beyond the earth pit and connecting to equipments by means of earthing lead, Gl bolts, nuts & washer etc with provision of char-coal and salt etc all as per electrical plate No 3 of SSR Part - 1, 2009 including RCC cover and MS angle iron frame watering arrangements with Gl pipe 20 mm dia (medium grade) & MS funnel, concrete pit including excavation and earthwork and testing on completion etc complete all as specified and directed by Engr-in-charge.Note: Rate of item is deemed to be included for excavation in hard rock, by compressor machine to achieve required depth. |
| 51 | M&L MCCB 63A, 25kA, FP Please Enable Macros to View BoQ information |
