|
| 1 | Dismantling of fencing, wire mesh of any type and in any position by unscrewing nuts fillets, clamps complete all as directed. |
| 2 | Dismantling posts or strut (steel or RCC fencing posts) any section and taking out embedded portion (post embedded in concrete) including making good to disturbed ground surfaces complete all as directed. |
| 3 | Dismantling structural steel work including doors, gates but excluding framed truss etc complete all as directed. |
| 4 | Excavating in post holes (or similar holes) in Hard/Dense soil each not exceeding 0.5 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25cm, watering, and removing surplus soil to a distance not exceeding 50m and making good surface complete all as specified and directed. |
| 5 | Material and labour for plain cement concrete 1:3:6 type C-2 (Using 40mm graded stone aggregate) as in foundation filling and mass concrete complete all as specified and directed. |
| 6 | Material and labour for framed work confirming to Fe-410 (Grade E-250) quality A as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete all as specified and directed. |
| 7 | Supply only Chain link fencing made out of 3.15 mm dia galvanised iron wire of mesh of size 50mm x 50mm made up to into mattress or cages complete all as specified and directed. |
| 8 | Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified and directed. |
| 9 | Supply and fixing of mild steel round bars 10mm dia and over of Fe-410 (Grade E-250) quality A or Fe 290 (Grade E-165), cut to length, bent to shape required, including cranking, bending for hooping as in securing bar complete all as specified and directed |
| 10 | Supply and fixing of mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, not exceeding 5cm long dia of shank diameter of neck in 11 to 15 mm complete all as specified and directed |
| 11 | Supply and fixing of posts and struts in fencing including cutting tops to shapes as directed, drilling holes notching for wire etc flat iron fillets (for securing wire mesh etc including all necessary drilling, bolting or riveting etc and similar work confirming to Fe-290 Grade E-165) complete all as specified and directed. |
| 12 | Material and labour for preparing new steel surfaces of any description over 10cm in width of girth not otherwise described and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed. |
| 13 | Material and labour for preparing new steel surfaces of any description not exeeding 10cm in width of girth not otherwise described and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed. |
| 14 | Demolition of brick work or stone boulder masonry built in cement mortar including all quins, arches, pillars etc. but excluding ashlar facings, dressed stone work and precast concrete articles complete all directed. |
| 15 | Material and labour for Pre-cast cement concrete block type C1, 1:3:6 (20 mm graded stone aggregate) masonry with solid blocks, exc. 10 cm in width and setting in cement mortar 1:6 complete all as specified and directed. |
| 16 | Taking down cement plaster of any description, any thickness from external surfaces of walls/soffits etc. including raking out joints, hacking for keys, scrubbing down with water etc complete all as specified and directed. |
| 17 | Material and labour for rendering 15 mm thick on fair faces of brick work or concrete surface in CM 1:4 finished even and smooth surface without using extra cement complete all as specified and directed |
| 18 | Supply only integral liquid water proofing compound complete all as specified and directed. |
| 19 | Material and labour for preparing new plastered surface of walls and applying two coats of cement-based paint over a coat of alkali-resistant priming paint complete all as specified and directed. |
| 20 | Supply and fixing in repair galvanised, 2 strands, steel barbed wire 2.24 mm dia, barbed with 2mm dia, barbs at 75mm spacing as in fencing and straining and fixing to any type of standard rails/ straining bolts including securing or tying at crossing with and provision of galvanised mild steel wire, staples or steel pins etc complete as specified and directed. (Note: Each line of wire to be measured separately). |
| 21 | Supply and fixing in repair of galvanised mild steel concertina coil fencing of 600mm dia, centre to centre barbs distance 48mm, thickness of strip 0.5mm, length of barbs 10.5mm, Dia of spring wire 2.5mm, No. of spiral (No of turn) 50/51 per coil clip per spiral 5 Nos, weight not less than 8.50Kg/coil (recommended coil stretch length 6 mtr) and confirming to IS and as per manufacturers instruction and laying and secured with barbed wire/iron angle by using necessary securing clips all as specified and directed.Note : Measurement taken on effective length of fencing and not length of coil. |
| 22 | Demolition of cement concrete (unreinforced) of any description and in any position not otherwise specifically provided for including disposal of debris, complete all as specified and as directed.(Note: All the demolished material shall be disposed off outside the MoD land. Rate quoted deemed to be inclusive). |
| 23 | Material and labour for 100 mm thick plain cement concrete 1:4:8 type D2 (using 40 mm graded stone aggregate) in sub base of flooring complete all as specified and directed. |
| 24 | Material and labour for 100 mm thick plain cement concrete type B-1, 1:2:4 (using 20 mm graded stone aggregate) as in flooring, finishing cement concrete surface even and smooth without using extra cement complete all as specified and directed. |
| 25 | Material and labour for forming contraction (dummy) joints 100 mm deep x 10mm wide for hardstanding and similar work, filled with sealing compound Grade 'B' complete all as specified and directed. |
| 26 | Material and labour for chequered tiles using with grey cement and pigment s of size 20cm x 20cm x 25mm, set in jointed and pointed in neat cement slurry in floors over and including 20 mm thick screed bed in CM 1:6, including dismantling of existing tiles complete all as specified and directed. |
| 27 | Material and labour for 60 mm thick M-35 grade machine pressed precast concrete interlocking paver block any shape and size conforming to IS-15658-2006, with grey cement and pigment complete all as specified and directed. |
| 28 | Material and labour for 80 mm thick M-40 grade machine pressed precast concrete interlocking paver block any shape and size conforming to IS-15658-2006, with grey cement and pigment complete all as specified and directed. |
| 29 | Material and labour for sand crushing /sand filling under floors (below paver blocks) including watering and consolidation complete all as specified and directed. |
| 30 | Material and labour for plain cement concrete type C1 1:3:6 (using 20 mm graded granite stone aggregate) as in cills, benching and other similar bands, plinth courses, parapets, copings, bed plates and the like including weathering, slightly rounded or chamfered angles, sides of interlocking tiles and throating etc as directed including use and waste of form work complete all as specified and directed. |
| 31 | M&L precast cement concrete type C-1, 1:3:6 (using 20mm graded aggregate) block masonary with solid blocks exc 10 cm in with and setting in cement mortar 1:4, incl dismantling of exiting Complete all as specified and as directed by Engr-in-Charge. |
| 32 | Material and labour for preparation of old decorated plastered surfaces of wall by brooming down or steel wire brushing and applying one coats of cement base paint complete all as specified and directed. |
| 33 | Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required complete all as specified and directed. |
| 34 | Material and labour for preparation of old painted surface of concrete surfaces/kerb stones/ of any description exceeding 10cm width or girth and applying one coat of Synthetic enamel paint complete all as specified and directed. Please Enable Macros to View BoQ information |
