Tender For Stand Alone Solar Pv, 6 Mtr. Height Pole With 1No Panel, 100 Ah, 12.8V Lithium Ferro Phosphate Battery, 1 Led 30W (1) At Near Pouskali Baroari Math, Benali High School Para, Booth No. 193, Mayurhat-Ii Gp/Hanskhali Block (04 Pc), (2) At Nea, Nadia-West Bengal
TDR : 55764830
Tender Notice
BOQ
12 Days Left
Nadia
West Bengal
Tender For Stand Alone Solar Pv, 6 Mtr. Height Pole With 1No Panel, 100 Ah, 12.8V Lithium Ferro Phosphate Battery, 1 Led 30W (1) At Near Pouskali Baroari Math, Benali High School Para, Booth No. 193, Mayurhat-Ii Gp/Hanskhali Block (04 Pc), (2) At Nea
Name of Work:- Stand Alone Solar PV, 6 mtr. Height pole with 1no panel, 100 Ah, 12.8V Lithium Ferro phosphate battery, 1 LED 30W (1) At near Pouskali Baroari Math, Benali High School Para, booth no. 193, Mayurhat-II GP/Hanskhali Block (04 Pc), (2) At near Peratikamari Mahakal Math, Purba Bergramn, Mayurhat-II GP/Hanskhali Block (04 Pc), (3) At Natungram Primary School Math, Mayurhat-II GP/Hanskhali Block (02 Pc), (4) At Benali Board Primary School Shishu Udyan, Mayurhat-II GP/Hanskhali Block (02 Pc), (5) At booth no. 36, Malighata Purbapara, Taldaha Mazdia GP/ Krishnaganj Block (02 Pc), (6) At Shyamnagar Puratanpara (Kalatala Road), Gazna GP/Hanskhali Block (02 Pc), (7) At Booth no. 247, Sonatanpur Atirpar, Gazna GP/Hanskhali Block (02 Pc), (8) At Booth no. 180, near Halder Babur Bagan, Betna Gobindapur, GP/Hanskhali Block (02 Pc) in the Nadia District.
Sl. No.
Item Description
1
Module- 100 WP( (ERTL and Flash Tested) (Supplying and erection) of moduler panel.Supply of 100wp Poly/ Mono crystaline module with IEC 61215, IEC6173-1,2 compliarnce withI. The PV module shall contain crystalline silicon solar cells and must have a certificate of testing conforming to IEC 61215 EditionII. The power output of the module(s) under STC Would be a minimum of 75 Wp at a load voltage* of 16.4 + 0.2 VIII. The open circuit voltage* of the PV modules under STC would be 21.0 VoltsIV. The module efficiency would be 14.5%V. SPV module shall be highly reliable, lightweight and shall have a service life of more than 25 years. SPV modules shall have a limited power loss of not more than 10% of nominal output at the end of 10 years and not more than 20% at the end of 25 yearsVII. The solar module shall be able to withstand the following environmental conditions normally encountered at site - Temp.extremes ranging from -100 C to +850 C Wind load- 150 km/h Maximum mean hourly rainfall of 40 mm Humidity level upto 95%, (HR/ Vikram/Any MNRE Approved)VIII. Strip must contain the following detailsa) Name of Manufacturerb) Model or type numberc) Serial No.d) Year of make(Including cost of Panel mounting structure)
2
Supplying and fixing 30W Luminaries comparise of :a) 30W, LED (Philips/Osram/equivalent reputed make with BIS Certificatete)b) Charge controller and it should have over charge protection, deep discharge protection, Batterys reversed polerty protection, Load short circuit protection, Open circut protection, panel evers polarity protection. Over temperature prolectionc) Automatic dusk to dawn controlling system to monitor the LED operation.
3
Supply and commissioning of LiPo4 Baltery. LITHIOM PERRO Batteries 12,8V, 42AH, (The batteries having BIS Certificate. The battary should have battery management System (BMS) with higher life expectancy, longer cycle life, low discharge rate and charge faster facilities. (MAKE- (OKAYA/ Warree /ARTECH ENERGY/ AMTEK ) Battary must have 5 years warranty period.
4
Supply and installation of G.I pole 6 mn long, ,100mm outer dia 3.6mm thick conforming to IS 1161: 2014 with corrosion proof galvanisation conforming IS 2629-1965 with pole cap at top and base plate 200mm x 200mm x 10mm with CC foundation having 600mm X 600mm X 150mm thick CC (4:2:1) Base block below base plate with metal including CC with metal chips (6:3:1) of size 600mm X 600mm X 1000mm below the ground level surrounding the pole and muffing 300mm dia. and 300 mm hight above ground level including 3mm thick neat cement finishing an dGI earth bolt after making drilled holes etc on pole & carrage of pole at work- site including including filling up the ecavatted earth pit with shifted soil and remaining properly
5
Cable & LugsProviding Cables (including cables from pole top to Panels on Roof top) and other electrical fixtures.2.5 sq mm copper standard pvc insulated and unsheathed wire will be used. (MAKE- MESCAB/POLYCAB/KEI) & Lugs as per requirement
6
Installation of solar panel including connection of lighting fixture, batteries and panel with commissioning and testing of the system
7
Sypplying, fixing & fixing display board or murblae Stone with suitable brick worksas per G.S.
8
Comprehensive maintenarnce (At least three comprehensive maitenance per year)
9
Sub Total
10
GST 18%
11
CESS 1% Please Enable Macros to View BoQ information
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
