|
| 1 | Dismantling the damaged flooring ceramic tiles including all cost and conveyance of all other labour charges etc. |
| 2 | Paving the floor with best quality vitrified Tiles of following size and variety conforming IS 15622 with water absorbtion less than 0.08% of approved colour and shade laid over cement mortar bed of 20mm thick in cement mortar 1:3 (one cement and three crushed stone sand) with required Cement Slurry and Mortar Plasticizer in all floors and the top pointed with Water Resistant Tile Epoxy Grout etc., complete complying with standard specification and as directed by the departmental officers. (The make and brand of the tiles should be got approved by Executive Engineer before use on works) |
| 3 | Dining hall area |
| 4 | supplying and fixing in position best appored of BIS quality pvc waste water pipes having a pressure of 6kg /sqcm including cost of speical clamps,brass screws, nails etc. |
| 5 | a)63mm dia pipe |
| 6 | b)63mm dia Elbow |
| 7 | c)63mm dia Bend |
| 8 | supplying laying and jointing pvc pipes (having working pressure 10kg /sqcm) of approved quality and best variety conforming to bis of the following dia including cutting threading and fixing pvc speical using pvc adhesives and fixing into wall with teak |
| 9 | a )25mm dia pvc pipe |
| 10 | b)32mm dia pvc pipe |
| 11 | c)32mm dia pvc Elbow |
| 12 | Supplying , fixing and roofing with colour galvalume sheet of 0.47mm thick with all necessary accessories such as J/V bolt and nuts of suitable length with suitable bitumen washers complete complying with standard specification and as directed by the departmental officers. |
| 13 | Wiring with 2 x 1.5 sq.mm. PVC insulated SC unsheathed FRLS copper conductor cable of 1100V grade in suitable heavy gauge MS conduit pipe on wall and ceiling with MS accessories with switch box with 5A FT switch inflush with wall and covered with hylum sheet of 3mm thick with painting of suitable colour with continuous earth wire connection of 1.5 sq.mm copper wire for light point / fan point (for electronic regulator) |
| 14 | Supply and fixing AC Ceiling Fan complete 1200mm (48”) Sweep with 300mm Down Rod (without Regulator) (Higher End) including transport and other charges etc. complete.M-1337 |
| 15 | Supply and fixing4’ 18W Crystal Glass LED Tube Light Fitting with including transport and other charges etc. complete.M-1272 |
| 16 | Supplying and fixing in positon Indian Water Closet (Oriya type) of size 580 x 440mm white glazed earthern ware of approved quality and brand with “P” or “S” trap conforming to BIS with crushed stone sand cushion and forming flooring alround the closet using 40mm broken brick jelly in lime concrete 1:2:5 (One lime, Two crushed stone sandand Five brick jelly) 100mm thick and finishing the top to the required slope and including giving necessary connection to CI soil pipes (including the cost of 100mm dia CI pipe for a length of 600mm) by dismantling brick masonry wall / reinforced cement concrete roof / floor slab and making good the dismantled portion to the original condition with leakages etc., complete complying with standard specifications and as directed by the departmental officers. (The water closet should be got approved by the Executive Engineer before use on works). |
| 17 | Supply and providing 1000 litres capacity Priming Tank made up of PVC. |
| 18 | Manufacturing supplying and fixing of Fully Panelled steel door with the following specification MS angels of size 40x40x6mm are used for the outer frames and M.S. angles of size 35x35x5mm for the shutter frames, stiffeners with 32 x 6mm M.S flat is provided at required intervals in the shutter frame. 18-gauge C.R. sheet laid as panel in the shutter and welded intact. M.S. flat 18x5mm is welded over the 32 x 6mm M.S. flat sandwitching the C.R. sheet in between additional stiffeners with 18x5mm M.S. flat is provided diagonally at the rear side of the shutter. 3nos. of Steel Parliament Hinges of Size 125mm x 150mm in case of single leaf and 6nos. of Steel Parliament Hinges of Size 125mm x 150mm in double leaves shutter to be provided. 6nos. of holdfasts 200 mm in length made of angle section spliced at the ends are welded to the outer frames of the door. Tower bolts 3 nos, one at the top, one at lock rail(Inner) and the other at the bottom are provided 1no. Aldrop is provided at lock rail section in the door 2 Nos of 200mm handle are to be provided. One rotaing locking arrangements for the inner side of the door and additional provision for locking arrangements for lock is provided on the rear side of the door at an appropriate place. Incase of double leaf door M.S.Flat 32 x 3mm at 1.1Kg/m is provided on the one shutter t conceal the gap between the two shutters. at an appropriate place in the door. A tie bar is provided at the bottom of the frame to prevent twisting of frame during transportation and fixing. All members are given a coat of red oxide primer as directed by the departmental officers. The rate includes cost of all materials, labour charges, transportation to site of work, loading, un loading and all other incidental charges etc., complete complying with standard specification and as directed by the departmental officers. -Single leaf of size 1.00m x 2.10m. |
| 19 | Supply and fixing of the following specials including cost and conveyance of all material and labour charges etc. complete. |
| 20 | 110mm PVC Pipe |
| 21 | 110mm PVC Elbow |
| 22 | 110mm PVC Tee |
| 23 | 110mm PVC Coupling |
| 24 | 110mm PVC Bend |
| 25 | 90mm PVC Pipe |
| 26 | 90mm PVC Elbow |
| 27 | 90mm PVC Tee |
| 28 | 90mm PVC Bend |
| 29 | Supply and fixing of single box type 4'36 W flu fitting complete with electronic ballast with TW round blocks on wall or ceiling with flu tube with PVC unsheathed Copper leads from terminals to the fitting. SD 87 |
| 30 | Supply and fixing of 9W LED Bulb fitting complete with all internal fittings etc., complete complying with standard spoecifications |
| 31 | Supply and fixing of WT bulk head fitting with guard suitable for incandescent lamp with 60W bulb ( SD 84) |
| 32 | Supply and delivery of Mixer Grinder of approved quality including motor unit, jars, blades, lids, power cord and all standard accessories, including transportation, loading, unloading, testing, installation and all other incidental charges, labour charges etc. complete.Including GST |
| 33 | Supply of required materials and carrying out repair and maintenance works including transportation, loading, unloading, testing, installation and all other incidental charges, labour charges etc. complete.Including GST |
| 34 | Steam pipe line work |
| 35 | Steam Water line Work |
| 36 | Rice Grinding Machine (Tilting) |
| 37 | Urad Dal Wet Grinder |
| 38 | Steam Generator 280 lit capacity with Stand |
| 39 | Cooking essenstial Vessels |
| 40 | Gas Pipe line Work Please Enable Macros to View BoQ information |
