|
| 1 | Excavation for roadwork in soil with hydraulic excavator including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross sections, and transporting to the embankment location with all lifts and lead up to 1000 m as per Section-300 of the specifications. |
| 2 | Construction of Embankment/Sub-grade/Earthen Shoulders with material obtained from other sources, as per provisions of Section 305 of the specifications, with approved materials/soil confirming to requirements given in Table 301-1 of specifications including all lead and lifts, including cost of watering, compaction by vibratory roller/heavy pneumatic type roller etc. confirming to requirements given in Table 301-e specifications complete. |
| 3 | Construction of granular sub-base, spreading in uniform layers with motor grader on prepared surface, mixing by Mix in Place Method at OMC and compacting with vibratory roller of 80-100 KN Static weight to achieve the desired density, including all lifts and lead complete in all respect as per Section-400 of the specifications.By Mix in Place Method-Grading I |
| 4 | Construction of Dry Lean Cement Concrete Sub-Base Over a prepared sub-grade with coarse and fine aggregate conforming to IS: 383, the size of coarse aggregate not exceeding 26.5mm, aggregate cement ratio not to exceed 15:1, aggregate gradation after blending to be as per Table 600-1 of the specifications, cement content not to be less than 150 Kg/Cum, optimum moisture content to be determined during trial length construction, concrete strength not to be less than 10 MPa at 7 days, mixed in a batching plant, transported to site, laid with paver with electronic sensor/mechanical paver, compacting with 8-10 tonnes vibratory roller, finishing and curing and as per Section 601 of specifications. |
| 5 | Deduct from Item No 6.1 above if paver with electronic sensor/ mechanical paver, is not used and laying is done by any other method. |
| 6 | Construction of Dowel jointed, Plain Cement Concrete Pavement in M-30 Grade Concrete over a prepared sub base with 43 or higher grade cement, coarse and fine aggregate conforming to IS:383 maximum size of coarse aggregate not exceeding 25 mm, mixed in a batching and mixing plant as per approved mix design, transported to site, laid with a fixed form or slip form paver with electronic sensor spreading the concrete by shovels, rakes compacted using needle, screed and plate vibrator |
| 7 | Deduct from Item No 6.2.1 & 6.2.2 above if paver with electronic sensor/ mechanical paver, is not used andlaying is done by any other method. |
| 8 | Mild Steel dowel bars confirming to IS 432, grade I |
| 9 | HYSD tie bars of Fe 500 grade confirming to IS 1786, |
| 10 | Providing and applying 2.5 mm including reflectorising glass beds @ 250 gm per Sqm area thick road marking strips (retro- reflective) of specified shade/colour using hot thermoplastic material by fully/ semi-automatic thermoplastic paint applicator machine fitted with profile shoe, glass beads dispenser, propane tank heater and profile shoe heater, driven by experienced operator on road surface including cost of material, labour, T&P, cleaning the road surface of all dirt, seals, oil, grease and foreign material etc. complete as per direction of Engineer-in-charge and as per Section 803 of specifications. Please Enable Macros to View BoQ information |
