|
| 1 | Demolition of cement concrete (unreinforced) in ground floors and pavings n.exc 15cm thickness (below or above ground level) etc., complete all as specified and as directed. |
| 2 | M&L for 75mm thick Cement concrete type D2, 1:4:8 (using 40 mm graded stone aggregate) in sub base of flooring/ hard standing.finishing the surface even & smoth without using extra cement all as directed. |
| 3 | Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-30 grade with approved colour, design & pattern as in footpath, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of coarse sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with fine sand and cutting of paver block as per required size and pattern, finishing and sweeping extra sand; complete. |
| 4 | M&L for 75mm thick PCC 1:3:6 Type C-2 (using 40mm crushed stone aggregate) as in plinth protection finished even and fair without using extra cement etc., complete all as specified and as directed. |
| 5 | Dismantling floor, hearth or wall tiles including cement mortar bedding (but not backing) and removing serviceable tiles to stores and rubbish off the premises etc., complete all as specified and as directed. |
| 6 | Providing and laying vitrified parking tiles of sizes (600X600) of 10-15 mm thickness conforming to IS 15622 in all colors and shades in outdoor floors and skirting meant for parking of cars and trucks,set and jointed in neat cement slurry and pointed in white or coloured cement to match and including 20mm thick screed bed in CM (1:4) etc., complete all as specified and as directed. |
| 7 | Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion and making good disturbed ground Concrete, brick work, masonry, etc. complete all as directed. |
| 8 | Dismantling fencing wire mesh any type complete all as directed. |
| 9 | Excavating in post holes (or similar holes) each n exc 0.5 cu. m, getting out, returning, filling in & raming earth/ broken rubble mixed with earth around, in layers n. exc. 25cm, watering, & removing surplus soil to a distance n exc 50m & making good surface in soft/loose soil complete all as specified and directed. |
| 10 | M&L PCC in foundations, filling and mass-concrete type D2 (1:4:8) using 40 mm graded stone aggregate complete all as specified. |
| 11 | S&F MS framed work such as fencing post including cutting tops to shape as directed, drilling holes,notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified. |
| 12 | M&L for plain cement concrete type B1 (1:2:4) using 20mm graded stone aggregate as in copings cavings, bed plats and embeding swan neck fencing post, etc incl weathering slightly rounded or chamfered angles and throating as directed complete all as specified and directed. |
| 13 | M&L PVC coated GI chain link fencing 3.5mm dia with 50mm x 50mm mesh including fixing of MS line wire / rod, flat iron & machine made hexagonal or square head bolts to fencing posts complete all as specified.Note :- supply only of MS rod and bolts will be measured and paid seperately. |
| 14 | Supply only mild steel screw bolts n exc 12 mm dia machine made with hexagonal or square head at one end and screwed the other or screwed both ends for fixing of chain link fencing complete all as specified and directed. |
| 15 | M&L for Preparing new steel or iron surfaces of any description over 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified. |
| 16 | Taking down scrubs/vegitation growth from crevices completely upto any height and applying suitable chemical (herbicide) making good with PCC 1:2:4 or necessary plaster with CM 1:4 wiith WPC complete with all safety equipments complete all as specified and directed. |
| 17 | Demolition of Precast Concrete work/ precast concrete block wall built in Cement Mortar including all quoins arches pillars etc complete all as specified and as directed. |
| 18 | M & L for Pre-cast cement concrete solid block masonry using PCC (1:3:6) , Type C-1 (using 20 mm stone agg), exc10 cm in width and setting in CM( 1:6) complete all as specified and as directed. |
| 19 | S & F PVC pipe 110mm dia any length as in weep holes fixed in PCC block masonary wall complete all as specified. |
| 20 | Taking down Cement Plaster of any description on PCC block walls or concrete surfaces including raking out joints, hacking for key, scrubbing down with water etc complete all as specified and as directed. Note :- Rate including necessary scaffolding up to a height of G+3 bldg all as directed. |
| 21 | M&L Rendering 15mm thick in fair faces of PCC block wall or concrete surfaces in CM(1:4) finished even & fair without using extra cement all as specified and directed.Note :- Water Proofing compound shall be paid separately |
| 22 | Supply only Liquid water proofing compound ISI marked etc., complete all as specified and as directed. Note : WPC may apply as per manufactures instructions or 3% by the wt of cement. |
| 23 | M & L for applying Two coats of 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal esistance, dirt resistance exterior paint of WHITE colour with silicon additives coat applied @ 1.67 ltr/10 sqm over and including priming coat of exterior primer applied @ 2.20 kg/10 sqm over new surfaces complete all as specified and as directed by Engineer-in-charge.Make: Asian Paints (Apex Ultima), Berger (Weathercoat Long Life Flexo) Nerolac (Excel Total), Shalimar Paints (Weatherpro+ Super Luxury Emulsion) |
| 24 | Dismantling Asbestos Cement Corrugated or Semicorrugate in Roof covering, complete all as specified and directed. |
| 25 | S&F for pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50 mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified.Note : Height of the bldg up to G+3 storey including necessary safety arrangements etc., |
| 26 | S&F for Pre-painted galvalume aluminum zinc coating GI based Plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as in ridges, hips, valley gutter, drip, and straight flashing all as specified and as directed. Note : Height of the bldg up to G+3 storey including necessary safety arrangements) etc., |
| 27 | S&F Aluminium flat iron work in wind ties 40x6mm size fixed with 50mm/ 75 mm aluminium self staging screws with integral EPDM washer screwed in roof covering all as directed.Note :- Height of the bldg up to 15 mtrs including necessary safety arrangements etc., |
| 28 | Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as directed. |
| 29 | M&L for stainless steel (Grade 304) railing made of hollow tubes, channels, plates etc., including welding, grinding, buffing, polishing and making curvature (where ever required) and fitting the same with necessary stainless steel nuts and bolts complete, including fixing the railing with necessary accessories &stainless steel dash fasteners, stainless steel bolts etc., of required size, on the top of floor or the side of waist slab with suitable arrangement. etc., complete all as specified and as directed. Note :- Considered for Railing on balcony /staircase portion at any postition |
| 30 | M&L for Roof trusses (framed), trussed, purlins, crane gantries, rails and fastenings and heavy bracket framing (Beam, tee, angle, channel or flat sections) including distance pieces, cleats etc.conforming to Fe.290.Gde-E-165 etc., complete all as specified and as directed. |
| 31 | M&L for MS Plates (plain or chequered) channels, square cut or notched (ordinary and counter sunk) forming holes, with riveted, bolted or welded attachment confirming to Fe 410 -W (Gde- E- 250) quality- A etc., complete all as specified and as directed. |
| 32 | S&F Mild steel screw bolts (machine made) 5 to 10 mm dia with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, exc 5cm but n.exc. 10 cm long etc., complete all as specified and as directed. |
| 33 | S&F in repairs for galvanised, 2 strand steel barbed wire 2mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of stranded rails straining bolts, including securing or tying at crossing with and provision of galvanised mild steel wire, staple or steel pins etc as directed each line wire to be measures complete all as specified. |
| 34 | Dismantling of stone slabs and tiles of any description or thickness in floors, approns and laid bedded and pointed in any mortar etc., complete all as specified and as directed. |
| 35 | M&L for 18-20mm thick Granite (of any type) work (table rubbed and polished) in steps, jambs, pillars, window-cills, cooking platforms and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite over and including 15 mm thick screed bed in CM(1:6) etc., complete all as specified and as directed. |
| 36 | Rounding to edges of stone slabs one edge, such as in steps, cooking platform, and other similar situations complete all as specified and directed. Please Enable Macros to View BoQ information |
