Name of Work:- PROVN OF 02 x STANDALONE CENTRAL HEATING SYSTEM AT SATA REGT UNDER GE 865 EWS
Sl. No.
Item Description
1
Supply, installation, testing and commissioning of duct able type standalone oil fired kerosene/ HSD based heating system complete with stainless steel heat exchanger chamber consisting of furnace fabricated out of high temperature resistance stainless steel, automatic burner assembly control panel with sequence controller, photocell, for flame failure. HT Transformer electrode fan assembly with motor temperature controller stainless steel reflector, built in fuel oil piping exhaust chimney all housed in powder coated casing suitable for operation on 50 Hz single phase 230 volt AC Supply capacity 50,000 KCal/ hr with fallowing:-(a) Heat Output - 50000 KCal/Hr.(b) Hot Air Temp - 40 C(c) Temperature Rise - 90 C Max(d) Fuel Consumption - 1.75 Ltr/Hr(e) Thermal Efficiency - 80-90%(f) Electrical Supply - 220 Volts 50 Hz(g) Temperature Control - Automatic(h) Fuel - Kerosene/ Diesel(j) Burner - Riello/ Ben-toneMake:- ECCO Flame/Flameco/Thermax
2
Supply, fixing and testing of ducting for hot air blower of size 200mmx200mm made out of MS sheet of size 22 SGW and supported with Angle Iron of size 25x25x4mm with fixing arrangements and duly insulated with insulation material 633 thick and aluminium cladding as required at site complete all as specified and or/ as directed by Engr-in-Charge
3
Material & labour for Point wiring for power point 3 pin switch socket 15 Amp with PVC copper conductor FRLS cable multistranded unsheathed 2.5 Sqmm on independent board including one run of 2.5 Sqmm multistranded PVC copper conductor FRLS cable for earth continuity in and including PVC casing and capping fixed on wall complete all as specified and/ or as directed by Engr-in-Charge.
4
Supply and fixing switch socket combination multi purpose 2 in 1, 3 pin 5/15 Amp, flush type complete all as specified and/or as directed by Engr-In-Charge
5
Material and labour for earthing complete with galvanised steel earth plate electrode 600 X 600 X 6mm thick buried directly in ground vertically to a depth not less than 2.25 metre deep below ground level with top edge of the earth plate not less than 1.5 metre deep below normal ground level, connected with and including galvanised iron strip of size 32 x 6 mm connected to main test point as directed as earthing lead by means of nuts, bolts and washers of galvanised iron protected by 40mm dia (medium grade) GI tubing, funnel, wire mesh, 20mm bore GI tubing (light grade) watering pipe, including concrete pit in PCC (1:3:6) type C-1, precast RCC (1:2:4) type B-1 cover slab of size 350 x 350 x 50mm reinforced with 8mm dia TMT bars @ 15cm c/c in both ways and 10mm dia MS handle (01 No) of suitable size for lifting of cover slab, charcoal and salt in alternate layers including necessary excavation and earth work in any type of soil all as shown in electrical plate No 3 of SSR Part-I and testing on completion complete all as specified
6
Material & labour for PCC 1:3:6 type C-1 (using 20mm graded stone aggregate) for making padestal etc for installation of stand alone CHS etc. complete all as specified and/ or as directed by Engr-in-Charge. Please Enable Macros to View BoQ information
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
