|
| 1 | SPECIAL REPAIRS TO HARD STANDING/ FOOTPATH/ INTERLOCKING TILES NEAR CERTAIN PERMANENT OFFICERS MARRIED ACCOMMODATION AT DSSC WELLINGTON |
| 2 | Demolition of cement concrete (unreinforced ) in paving n exc15cm thickness (below or above ground level) and removing debris off the site complete all as specified and as directed. |
| 3 | Demolition of unreinforced Concrete of any description and in any position as in drain,copping, etc all as specified and as directed. |
| 4 | Demolition of Stone slabs and tiles of any description or thickness in floors, aprons etc laid,bedded,laid in any type of mortar complete |
| 5 | Demolition for brickwork or stone masonry laid with cement mortar or cement lime mortar |
| 6 | Excavating in trenches, n.exc 1.5m wide and n exc 1.5 in depth; for foundation getting out hard/dense soil all as specified and as directed. |
| 7 | Material and labour for providing plain cement concrete 1:4:8 type D2, using( 40mm graded stone aggregate )as in foundation filling and mass concrete all as specified and as directed. |
| 8 | M& L for 100mm thick PCC type C-2(1:3:6) using 40mm graded stone aggregate as in sub base for top finish of any description etc including finishthe surface even and rough to receive the top finish complete all as specified and as directed. |
| 9 | M& L for 100mm thick PCC type B-1(1:2:4) using 20mm graded stone aggregate as in pavings,floor etc etc including finish the surface even and smooth without using extra cement complete all as specified and as directed. |
| 10 | Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with pproved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand;e complete all as specifed and directetd. |
| 11 | M&L for chequered cement concrete tiles of size 30cmx30cmx 25mm thick ,set ,jointed and pointed in neat cement slurry in floors with grey cement and pigments of required colour over 20mm thick thick screed bed in CM (1:6) complete as specified and as directed. |
| 12 | Dismantling of old/existing kerb stone of any size of any description complete all as specifed and directed. |
| 13 | Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required complete. |
| 14 | M&L for 2 coats of synthetic enamel painting over a coat of priming paint plaster coat on new Brick, Stone, concrete, Asbestos cement plaster surface of any description over 10 cm width or girth not otherwise described incl preperation of surfaces complete all as specified and as directed |
| 15 | M&L for 2 coats of synthetic enamel painting over a coat of priming paint on Old Brick, Stone, concrete, Asbestos cement plaster surface of any description over 10 cm width or girth not otherwise described incl preperation of surfaces complete all as specified and as directed |
| 16 | M&L for Precast cement concrete block Type C1(1:3:6)(using 20 mm graded aggregate) masonry with solid solid blocks exc 10cm width and setting in mortar(1:6) complete. |
| 17 | M&L for Walling of random rubble,uncoursed, well bonded, bedded and solidly hearted, built in cement mortar in CM(1:6) as in retaining wall,toe wall etc complete. |
| 18 | Taking down cement or cement lime plaster of any description on brick or stone walls etc including racking out joints, hacking for key, scrubbing down with water etc, complete all as specified and as directed. |
| 19 | M&L 10mm thick rendering plaster on fair face of brick-work or concrete surface incl finish the surface even and smooth without using extra cement in CM 1:6 complete all as specified and as directed . |
| 20 | M&L raised pointing in cement mortar 1:4 to random or polygonal rubble, uncoursed or brought upto courses including raking out joints to the joints to existing or new surfaces complete all as specified and as directed. |
| 21 | Material and labour for providing plain cement concrete 1:3:6 type C2, using( 40mm graded stone aggregate )as in drain / surface channel including necessary form work complete all as specified and as directed. |
| 22 | Material and labour for appying two coat cement base paint over one coat chalk white primer on newly plastered surface including preperation of the surface all as specified and directed., |
| 23 | S&F 75 mm bore PVC (SWR) pipes single socketed in any length with rubber ring joints fixed to walls complete all as specified and as directed. |
| 24 | Dismantling wrought iron or mild steel work of any description not otherwise provided for steel members of Fence,gate etc complete all as spcified and as directed. |
| 25 | Material and labour for mild steel Framed work such as grills, gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks and similar work conforming to Fe.290.Gde-E-165all as specified and as directed. |
| 26 | Returning filling including spreading leveling watering and well ramming in layers not exc 25 cm hard and dense soil |
| 27 | Removing excavated material not exc 50M and depositing where directed (Soils) at a level not exc.1.5 mtr above the starting point |
| 28 | M&L for 2 coats of synthetic enamel painting over a coat of red oxide zinc crome on new steel surface of any description over 10 cm width or girth not otherwise described incl preperation of surfaces complete all as specified and as directed |
| 29 | M & L for PCC 1:3:6 type C-1 using 20mm graded stone aggragate as in steps,steps; seismic and other similar bands,plinth courses, string courses,lacing courses, parapets and railings upto 60 cm in height,copings, kneelers, apex stones,bed plates, kerbs not provided for in Item 04028, water troughs and the like including weathering, slightly rounded or chamfered angles and throating, complete all as directed |
| 30 | Material and labour for preparation of old RRM surfaces including removing bushes, shrubs and vegitation if any from block/ stone masonry retaining wall at any height upto 8 metre and making surface clean by removing waste and filling the damage joints with cememt mortar 1:6 and applying two coats of cement base paint over one coat of chalk white primer etc complete all as specified and as directed. |
| 31 | SPECIAL REPAIRS TO 01 X VEHICLE GARAGE AT MT SECTION AT DSSC WELLINGTON |
| 32 | Dismantling plain or corrugated steel sheeting, any gauge, thickness, including Nainital or similar pattern roof coverings all as directed |
| 33 | Demolition for brickwork or stone/PCC block masonry laid with cement mortar mortar complete. |
| 34 | Dismantling MS steel work of any descrption and not otherwise provided for complete all as specified and as directed |
| 35 | Demolition of Concrete in ground floors and pavings n. exc 15 cm thickness (below or above ground level) complete all as specified and as directed |
| 36 | Excavation in post holes (or similar holes) each n exc 0.5cum getting out returning filling in and ramming earth or broken rubble mixed with earth around in layers n exc 25cm ,in watering and removing surplus soil to a distance n exe 50m and making good surface in soft /loose soil all as specified and directed. |
| 37 | M&L for Cement concrete type C-2 (1:3:6) using 40mm graded stone aggregate as in foundations,filling and mass concrete |
| 38 | M & L for mild steel work as in tubular roof trusses (framed), trussed, purlins, crane gantries, rails and fastenings and heavy bracket framing (Beam, tee, angle, channel or flat, square tube etc sections) including distance pieces, cleats etc. Fe 410-W (Gde-E- 250) quality- A complete all as specified and as directed. |
| 39 | S&F mild steel for Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, prong etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and pintel hinges or steel hanging door fittings, inclusive of steel sheeting or other covering, running rails and guides, CI ornaments fitting; also fastening and fixing complete and similar work confirming to Fe-290 Gde E- 165 complete all as specified and as directed |
| 40 | S&F Welded steel wire fabric supplied and fixed complete to wood or steel members 3-4 kg/sqm complete all as specified and as directed. |
| 41 | M&L for Precast cement concrete block Type C1(1:3:6)(using 20 mm graded aggregate) masonry with solid solid blocks exc 10cm width and setting in mortar(1:4) complete. |
| 42 | Plastering 15mm thick on fair faces of brick work or concrete surfaces to be finished fair & even without using extra cement in CM 1:4 on walls complete all as specified and as directed. |
| 43 | M&L preparation of newly plastered wall surfaces and applying three coats of white wash complete all as specified and as directed |
| 44 | S&F prepainted Galvalume Aluminium zinc coating GI based plain steel sheet 0.5mm thick of any colour having tensile strenth of 550MPA as in rainwater gutter/ fascia/ wall cladding etc of any shape (semicircular/ rectangular) including necessary cutting,shaping/fabrication complete all as spd and directed. |
| 45 | S&F prepainted Galvalume Aluminium zinc coating GI based corrugated steel sheet 0.5mm thick of any colour having tensile strenth of 550MPA as in roof covering /cladding to wall,crimp curved where necessary fixed with self tapping screws complete all as spd and directed |
| 46 | Material and labour for two coat SE paint on steel surface over one coat of red oxide primer incl prepareation of new or old steel surface complte all as spd and directed. |
| 47 | M& L for 75mm thick PCC type D-2(1:4:8) using 40mm graded stone aggregate as in pavings,hard standing etc including finishthe surface even and rough to receive the top finish complete all as specified and as directed. |
| 48 | M&L for 50 mm thick PCC type B1 (1:2:4) using 20 mm graded aggregate in floors finished even and fair complete all as specified and as directed |
| 49 | Note: Please note that if rate quotwd for similar items are different, the lowest rate quoted for item shall be only considered for payments of works Please Enable Macros to View BoQ information |
