|
| 1 | CIVIL WORKEarth work in excavated by mechenical means (hydraulic excavator)/ manual means in foudation trenches or drains (not exceeding 1.5 m in width of 10 sqm on plan), including dressing of sides and ramming of bottoms, for all lift, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. All kinds of soil Item no-2.8.1 DSR 2023.+2.26.1 Extra for additional lift of 1.50mDSR2023/2.8.1+2.26.1+3%0.00 TO 1.50M |
| 2 | 1.50 TO 3.00M |
| 3 | 3.00 TO 4.50M |
| 4 | 4.50 TO 6.00M |
| 5 | 6.00 TO 7.50M |
| 6 | Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering all work up to plinth level 1:4:8 (1 cement: 4 coarse sand (Zone-III) derived from natural sources :8 graded stone aggregate 40 mm nominal size derived from natural sources) item no-4.1.8 DSR 2023 +3% |
| 7 | Providing and laying in position machine batched and machine mixed design mix M-25 grade cement concrete for reinforced cement concrete work, using cement content as per approved design mix, including pumping of concrete to site of laying but excluding the cost of centering, shuttering, finishing and reinforcement, including admixtures in recommended proportions as per IS: 9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability as per direction of Engineer-in-charge. (Note :- Cement content considered in this item is @ 330 kg/cum. Excess/ less cement used as per design mix is payable/recoverable separately). DSR 23/5.33.1.1 UP TO PLINTH LEVEL All works upto plinth level DSR 5.33.1/2023+3%RAFT |
| 8 | M.S. steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level. mild steel and medium tensile steel bars. Item no-5.22.1 DSR 2023+3% |
| 9 | Providing and laying integral cement based treatment for water proofing on horizontal surface at all depth below ground level for under ground structures as directed by Engineer-in-Charge and consisting of:(i) Ist layer of 20 mm thick approved and specified cement plaster with neat finiesh thick base of cement mortar 1:3 (1 cement: 3 coarse sand) including applying of twice (at base and top of mortar) cement slurry @ 2.2kg/m2 (each time) mixed with water proofing compound conforming to IS:2645 in the recommended proportion over the leveling course (leveling course to be paid separately). Joints sealed and grouted with cement slurry mixed with water proofing compound.(ii) 2nd layer of 25 mm thick cement mortar 1:3 (1 cement: 3 coarse sand) mixed with water proofing compound in recommended proportions.(iii) Finishing top with stone aggregate of 10 mm to 12 mm nominal size spreading @ 8 cudm/sqm thoroughly embedded in the 2nd layer. item no-22 DSR 2023 |
| 10 | Cement concrete flooring 1:2:4 (1 cement: 2 coarse sand : 4 graded stone aggregate) finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps etc. complete.40MM Thick with 20mm norminal size stone aggregate DSR2023/11.3.1+3% |
| 11 | 20 mm cement plaster1:3 (1 cement: 3 coarse sand) finished with a floating coat of neat cement.DSR2023/13.9.2+3% |
| 12 | Finishing walls with water proofing cement paint of required shade:New work (Two or more coats applied @ 3.84 kg/10 sqm)DSR2023/13.44.1+3% |
| 13 | Supply and fixing Galvanized corrugated and powder coating iron roofing in position including supply of all materials labour. Tools &plants etc. required for proper completion of the work and including wastage.SI. NO. 536/ SOR-20220.80mm thick |
| 14 | Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.DSR2023/10.2+3% |
| 15 | Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade Two or more coatswith primar coat on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture DSR2023/13.61.1+3% |
| 16 | E/MSEWAGE TREATMENT PLANTDesign, Supplying, Installing, Testing & Commissioning of Sewage Treatment Plant capacity 400 m3/day.Nature of effluent - Domestic Sewage from Toilet use and kitchen waste. Daily average flow - 400 Cum / DaypH - 7.5 - 8.5BOD5 - upto 300-350 Mg/LS. Solids - 200- 250 Mg/LCOD - upto 400-500 Mg/LOil & Grease - 30 Mg / LEffluent discharge standard after treatmentpH - 6.0 - 8BOD5 - Less than 10 Mg/LS. Solids - Less than 20 Mg/LCOD - Less than 50 Mg/LOil & Grease - Less than 5mg/lSewage Treatment Plant shall comprise of following tanks in civil:Bar Screen Chamber - 1 NoOil & Grease Trap Chamber - 1 NoEqualization Tank - 1 NoIrrigation Water Tank - 1 NoFlushing Water Tank - 1 NoPlant Room-1 NoShop Drawings:Detailed GA drawing, flow diagram, equipment list, power load requirement with design calculations of all Tanks, elements of the plant, electrical and mechanical work to satisfy / supply adequacy of design followed by submission of detailed GOOD FOR CONSTRUCTION' architectural, electrical, mechanical and piping drawing for approval. Contractor shall ensure submission of detailed GA drawings (Plan & Section), P & I diagram, schematic diagram for the above mentioned components and additional components such as inserts, puddle flanges, vent pipes etc. if so required for the complete work. |
| 17 | Electromechanical:Supply, installation, testing & commissioning of 2 Nos Stainless Steel Perforated Screen with suitable lifting arrangement mechanically with bar space 10 mm for coarse screen and bar space 5 mm for fine screen. |
| 18 | Supply, installation, testing & commissioning of float level switch for automatic operation of the system for high/low level control with auxillary NO/NC contacts. |
| 19 | Supply, installation, testing & commissioning of non clogging type pumps, having CI casing & SS shaft, CI impeller complete with all accessories, motor of required capacity. Delivery header with isolation valve/NRV etc on delivery line with level switch with wiring to control the level of sump automatically. Pump shall have following duty. Solid handling cap. 30-40 mm.Sewage Transfer Pumps Submersible in Equalization TankFlow rate (each) : 17 m3 / hrHead : 10 meter1 Set : 2 Nos. ( 1 Working +1 Stand By) |
| 20 | Air diffusion system shall include the following:Supply, fixing, testing & commissioning of 2 Nos. (1 working & 1 standby) Twin Lobe Air Blowers (common for mixing & aeration) capable of delivering system required free air driven through “V” belt or directly coupled through flexible coupling to a TEFC motor of suitable HP for 415 ± 10% volts, 3 phase, 50 cycles A.hC. supply complete with valves, headers, NRVs, Pressure gauge Base Frame etc.Capacity (each) : 450 M3/Hr. at 0.35 to 0.5 kg/cm2 or as per design calculation1 Set : 2 Nos. ( 1 Working +1 Stand By) |
| 21 | Non clog type air dispersion system capable of handling 3-5 cfm of air with oxygen transfer efficiency of 3-4% per/meter water depth. Air dispersion grid shall be assembled in modular form so that they can be replaced / repaired.Coarse Bubble Tubular Diffusers for Equalization / Collection Tank.Coarse Bubble Tubular Diffusers for Sludge Holding Tank. Fine Bubble Tubular Diffusers for Aeration Tank. |
| 22 | Supply of PP hybrid fluidised MBBR media for aeration tank having surface area of 400 m2/m3 and media loading rate of 16 grams BOD / m2. |
| 23 | Supply, installation, testing and commissioning of PVC tube settling media having plain settling area of 11 m2/m3 to be installed in Settling Tank. Frame work for media in MS along and any other civil work will be in scope of civil contractor. |
| 24 | Supplying, installing, testing & commissioning of centrifugal filter feed water pumps SS 304 Casing, SS 304 Impeller, SS 304 Shaft with mechanical seal along with motor. Pressure gauge with isolation cock, NRV, Isolation valve on delivery line and Isolation valve, stainer at suction. The pump shall be suitable for 415 ± 10% volts, 3 phase, 50 cycles a/c supply.Filter Feed PumpsFlow rate : 5.0 M3/hr.Head : 30-35 mtr1 Set : 2 Nos. ( 1 Working +1 Stand By) |
| 25 | Supplying, installing, testing and commissioning of Composite MSEP Filter Vessel with 6 mm shell thickness and 8 mm dish end thickness , internal distribution system, MS C Class frontal piping, manual valves, first fill media, pressure gauge etc complete to give filtered treated water.Multigrade pressure sand filter mediaFlow rate : 17 M3/hr.Filteration velocity : 15 cum/hr/sqmFilter Size : 1200 mm diameter, 1800 mm Height |
| 26 | Activated Carbon FilterFlow rate : 17 M3/hr.Filteration velocity : 15 cum/hr/sqmFilter Size : 1200 mm diameter, 1800 mm Height |
| 27 | Supply, installation , testing & commissioning of Chemical Dosing System (disinfection / cleaning) comprising 0-6 LPH electronic diaphragm type metering pump along with 100 ltrs LDPE / HDPE tank with inlet and outlet connection. |
| 28 | Supply, installation , testing & commissioning of LLDPE / HDPE CIP Tank of 500 ltrs capacity complete with inlet, outlet connection, float switch and automation valve. |
| 29 | Flushing Water Transfer 'Water Flow Rate : 9.0 M3/Hr (EACH)'Head : 60 Meter'1 Set : 2 No (1 Working + 1 Stand By) |
| 30 | Irrigation Water Transfer Flow Rate : 6 m3/hr eachHead : 40 meter'1 Set : 2 No (1 Working + 1 Stand By) |
| 31 | Supplying, installing, testing & commissioning of self priming sludge recirculation pumps CI Casing,CI Impeller, CS Shaft with mechanical seal along with motor, isolation cock, NRV, Isolation valve on delivery line. The pump shall be suitable for 415 ± 10% volts, 3 phase, 50 cycles a/c supply Flow rate : 7.5 M3/hr.Head : 8 mtr1 Set : 2 Nos. ( 1 Working +1 Stand By) |
| 32 | Filter Pree Feed PumpFlow Rate : 6 m3/hr eachHead : 40 meter'1 Set : 2 No (1 Working + 1 Stand By) |
| 33 | Filter PressFlow Rate : 6 m3/hr each |
| 34 | MBBR Tank -2, Tube Settler-1, CCT-1, SHT-1MSFRP-5 mm Please Enable Macros to View BoQ information |
| 35 | MBBR Tank -2, Tube Settler-1, CCT-1, SHT-1MSFRP-5 mm Please Enable Macros to View BoQ information |
