|
| 1 | Dismantling of wrought iron or mild steel work of any description and in any position complete all as specified and directed. |
| 2 | Dismantling of posts or struts including GI barbed wire (wood,steel or RCC) from natural ground/at any level and any section including taking out embedded portion and making good distrubed ground complete all as specified and directed. |
| 3 | Taking down cement plaster on Brick/Concrete/stone masonry surfaces incl raking out joints, hacking for key scrubbing down with water and Removing Rubbish of the MD Land complete all as specified and directed |
| 4 | Excavation in post holes (or similar holes) in soft/loose soil each not exc 0.50 Cum and getting out returning, filling in and ramming earth around, in layers n exc 25 cm, watering and removing surplus soil to a distance not exc 50 Mtr and making good surfaces complete all as specified and directed. |
| 5 | M&L for cemnt concrete 1:3:6 type C-2 using 40mm graded crushed stone aggregate as in foundation filling and mass concret or as in post hole filling complete all as specified and directed |
| 6 | Demolition of plain cement concrete of any description and in any position not otherwise specifically provided for and removing all the rubbish all as specified and directed |
| 7 | M&L for PCC (1:4:8) type-D2 using 40 mm graded stone aggregate as in foundations, filling and mass concrete complete all as specified and directed. |
| 8 | Demolition of precast concrete block walling, brickwork of stone/ boulder masonry, built in cement mortar including all quoins, arches, pillars etc, but excluding ashlars facings, dressed stonework and precast concrete articles etc complete all as specified and directed. |
| 9 | Demolition of reinforced Concrete of any description and in any position not otherwise specifically provided reinforcement to be cut to facilitate the demolition complete all as speciified and directed |
| 10 | M & L for Reinforced cement concrete (nominal mix) in lintels or any other description type B0 1:2:4 wirh 12.5 mm graded aggregate including necessary formwork complete all as specified and diected by Engineer in charge |
| 11 | M&L for PCC 1:3:6 type C1 using 40mm graded aggregate of 75mm thick as in Plinth Protection, hard standing, path etc finishing surfaces even and smooth without using extra cement complete all as specified and directed. |
| 12 | M&L for providing cement concrete type B0,1:2:4 (using 12.5 mm size graded stone aggregate)as in roof kerbs or mud stops, rounded or chamfered on edges complete all as specified and directed. |
| 13 | M & L for providing precast cement concrete block masonary PCC 1:3:6 with solid blocks exc 10cm width, type C-1, using 20mm graded stone aggregate and set in cement mortar (1:6) complete all as specified and directed. |
| 14 | All as per item No.13 here-in-before but except precast blocks i.e using serviceable precast blocks obtained from item No 8 (demolition) here-in-before complete all as specified and directed. |
| 15 | M & L for walling of random rubble, masonary uncoursed, well bonded, bedded and solidly hearted built in cement mortar 1: 4 complete all as specified and directed. |
| 16 | All as per item No. 15 here-in-before but except stone i.e using serviceable stone obtained from item No 8 (demolition) here-in-before complete all as specified and directed. |
| 17 | M & L for Flush pointing to stones in course or ashlar masonry or cement concrete block walling in CM 1:4 complete all specified and directed |
| 18 | M & L for rendering 15mm thick in cement mortar 1:4 on fair faces of block masonary or concrete surfaces or stone surfaces finished fair & even complete all specified and directed. |
| 19 | M&L for preparation of newly plastered surfaces of walls and applying two coats of cement base paint over a coat of primer complete all as specified and directed |
| 20 | M&L for PCC 1:2:4 type C1 (Using 20mm graded stone aggregate) as in coping, block for hold fast block or lintels , cills, steps; seismic and other similar bands, plinth courses, , parapets and railings apex stones, bed plates, kerbs similar work and finished the surface with existing and including form work if necessary as in etc complete all as specified and directed. |
| 21 | S&F mild steel Framed work as in doors or gates of angle or other section with gusset plates, rails,braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; including fastening and fixing Fe 410-W (Gde E- 250) quality complete all as specified and directed. |
| 22 | M & L for mild steel Hand rails, half round or other stock section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embedding in concrete and screwing etc. wind ties for roof including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe 165 (Fe-290) complete all as specified and directed. |
| 23 | S&F Mild steel screw bolt (machine made 11 to 15mm dia of shank with hexagonal or square heads at one end and screwed the other or screwed both ends each screwed and to fitted with washers and one hexagonal or square nut length of bolt n.exc 5cm long complete all as specified and directed. |
| 24 | M&L for two coats of synthetic enamel paint over a coat of red oxide primer including preparation of new/old steel surfaces of any description exceeding 10cm width or girth complete all as specified & directed. |
| 25 | Dismantling of Plain or corrugated steel sheeting, any gauge, thickness, including ridges, hips, valleys and flashings all as specified and directed. |
| 26 | S&F pre-painted Galvalume Aluminium Zinc coating GI based corrugated steel sheets 0.5 mm thick of any colour having tensile strength 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all as specified and directed. |
| 27 | S &F for fibre glass reinforced translucent corrugated sheeting with two corrugations side lap fixed with coach screw and washer in roof ,wall etc. complete all as specified and as directed. |
| 28 | S & F in repair galvanized 2 strand steel barbed wire 2.24 mm dia barbed with 2mm dia barbs at 75 mm spacing and straining and fixed to any type of standard rail straining bolts, including securing or tying at crossing with and provision of galvanized mild steel wire, staple or steel pins etc complete all as specified and directed. Note : Each line wire to be measured |
| 29 | Restraining, resecuring including making good staples to galvanised 2 strand steel barbed wire any dia barbed with 2mm dia barbs at 75mm spacing and in any position etc complete all as specified and directed. |
| 30 | Supply only chain link MS galvanized fencing of any mesh size or any descrption and type any dia of wire complete all as specified and as directedNote :- (i) Fixing shall be measured and paid separately. (ii) Size of mesh and dia of wire will be decided by Engr-in-Charge as per the requirements.(iii) Weight of the fencing will be ascertain by BOO. |
| 31 | Fixing only in repair chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified and directed. Note : Chain link mesh will be measured and paid seperately. |
| 32 | M&L for Mild steel round barbs 10mm dia and over for runner in fencing for securing chain link fencing cut to length bent to shape required incl binding bolting or any other description etc complete confirming to to FE 290-S complete all as specifed and directed |
| 33 | Surface excavation in soft/loose soil n.exc (not exceeding) 30 cm deep and averaging 15cm deep and getting out complete all as specified and directed. |
| 34 | Excavation in trenches not exceeding 1.5m wide and not exceeding 1.5m depth for foundation & getting out in hard/dense soil complete all as specified and directed. |
| 35 | Removing excavated material n exc. 50m and depositing where directed at a level n exc. 1.5 m above the starting point complete all as specified and directed. |
| 36 | Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm in soft or loose soil complete all as specified and directed. |
| 37 | M&L for preparation of old plastered / decorated surfaces of wall by brooming down or steel wire brushing, scrapping down smoke soot, moulds, moss and efflorescent salts and trading oil and greasy spots etc and appyling one coats of cement base paint including necessary scafolding and safety measures as required as specified and as directed by Engr-in-Charge. |
| 38 | All as per item No 37 above but two coats of cement base paint complete all as specified and directed. |
| 39 | Dismantling of 300mm cast iron or reinforced concrete drain pipes, jointed in cement mortar and taking out of trenches, if required complete all as specified and directed. |
| 40 | M & L for Reinforced cement concrete pipe 300mm internal dia, class NP3, laid and jointed complete with collars all as specified and directed. |
| 41 | M&L for providing precast cement concrete louvres and jallies in cement concrete type B0, 1:2:4 (12.5mm graded stone aggregate) set in CM 1:4 , 25mm thick (measured solid), including all mouldings incl taking down existing jallies complete all as specified and directed. |
| 42 | M/L for 18-20mm thick rough finishes sadarahalli stone as in flooring , steps, jambs, pillars window cills , cooking platform skirting in cement mortor 1:4 incuding pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite including 15mm thick screed bed in CM 1:4 and rounding to edges complete all as specified and directed. |
| 43 | M & L for Machine cut kota stone slab flooring 20-25mm thick over cement screed base laid and jointed with grey cement slurry mixed with pigment to match the shade of the slab including rubbing and polishing complete over 20 mm screed in CM 1:4 complete all as specified and as directed. |
| 44 | M&L for 20mm thick Granite of any type/colour at any description tiles machine cut, laid over cement screed and jointed with grey cement slurry, and pointed with white cement with admixture of pigment to match the shade of granite stone including grinding and polishing including 15mm thick rendering in CM 1:4 complete all as specified and directed |
| 45 | M&L for complete removal of existing treatment by brooming down or steel wire brushing, scrapping down smoke soot, moulds, moss and efflorescent salts and trading oil and greasy spots etc and preparation of old plastered surfaces /decorated wall surfaces including appyling two or more coats of 100 % premium acrylic emulsion paint having VOC less than 50 gms/lit and UV resistance and including priming coat of exterior primer appled @0.90 litre/10 Sqm including necessary scafolding and safety measures as required complete all as specified and directed by Engr-in-Charge. Please Enable Macros to View BoQ information |
