|
| 1 | Demolition of Cement Concrete of any description and in any position not otherwise specifically provided for and removing rubbish to a distance not exceeding 1.50 KM complete all as specified and as directed. |
| 2 | Demolition of Reinforced Cement Concrete [reinforcement cut as required to facilitate demolition] of any description and in any position not otherwise specifically provided for and removing rubbish to a distance not exceeding 1.50 KM complete all as specified and as directed. |
| 3 | Demolition of Brickwork or Stone / Boulder Masonry, built in Cement Mortar including all quoins, arches, pillars, etc, but excluding ashlar facings, dressed stonework and precast concrete articles and removing rubbish to a distance not exceeding 1.50 KM complete all as specified and as directed. |
| 4 | Taking down Cement Plaster of any description on brick or stone walls or concrete surfaces etc including raking out joints, hacking for key scrubbing down with water etc and removing rubbish to a distance not exceeding 1.50 KM complete all as specified and as directed. |
| 5 | M & L for Cleaning / Desilting of Drains [Covered or Open] of any cross section and in any condition [including foul condition] by removing Silt, Grit, Mud, Debris, Sludge deposits, Pebbles, Large Stones of any shape with necessary dewatering by mechanical pump if required and temporary diversion of drain water as required including disposal of Spoil to a distance exceeding 250m but not exceeding 500m including removing and replacing cover slabs for smooth flow of water complete all as specified and directed.Note: The work shall be executed as and when required basis / urgent basis for smooth flow of traffic without damaging or disturbing the existing road. |
| 6 | M & L for PCC 1:3:6, Type C-2 [using 40 mm graded granite stone aggregate] in surface channels and drains including forming fair finished drain or channel of any inner girth using extra cement including forms, moulds, mitred / stooped ends complete all as specified and as directed. |
| 7 | M & L for Plain / Reinforced cement concrete Type B1 [Nominal Mix] 1:2:4 using 20mm graded stone aggregate Cast in Situ in Lintels up to 1.5m Span, Cills, Steps, Seismic and Other Similar Bands, Plinth Courses, String Courses, Lacing Courses, Parapets and Railings up to 60 cm in Height, Copings, Kneelers, Apex Stones, Bed Plates including Weathering, slightly rounded or chamfered angles and throating as directed including use and waste of form work, complete all as specified and as directed. |
| 8 | M & L for providing Precast RCC 1:2:4, Type B-1, using 20mm graded stone aggregate as in Landings, Cover Slabs [for Manholes etc], Chullah Hoods, Chajjas, Water Troughs, Mangers, Shelves and similar articles with plain faces set in cement mortar 1:6 complete all as specified and as directed. |
| 9 | M & L for walling of random rubble masonry, uncoursed, well bonded, bedded and solidly hearted, built in Cement Mortar 1:6 complete all as specified and directed. |
| 10 | All as per Serial Item No. 9 above but except Stone complete all as specified and directed. |
| 11 | M & L for Providing Precast Cement Concrete Solid Block Masonry with Solid Blocks exceeding 100mm width of PCC 1:3:6, Type – C1 using 20mm graded stone aggregate set in Cement Mortar 1:6 complete all as specified and as directed. |
| 12 | S & F Reinforcement using High Strength Deformed TMT Bars of Grade Fe–500D of 10mm dia and over, cut to length, bent to shape required including cranking, bending, spirally for hooping, hooking ends and binding with annealed mild steel wire not less than 0.9mm dia or securing with clips or welded complete all as specified and as directed. |
| 13 | M & L for rendering to brick / concrete surfaces, 15 mm thick in Cement Mortar 1:4, surfaces finished even and smooth without using extra cement including mixing of water proofing compound of approved make as per manufacturers instructions complete all as specified and as directed. Note: Water proofing compound will be measured and paid separately. |
| 14 | Supply only Integral Water Proofing Compound [ISI marked] of approved make complete all as specified and as directed. |
| 15 | S & F in repairs Mild Steel work confirming to Fe - 290, Grade E-165, as in framed work such as Grills, Gratings, Ladders etc with ends of bars shouldered and/or riveted, or forged into spikes, framed Guard Bars, Barred Iron Doors, Ladders, framed Balusters, Walk Ways, Railings, framework of Water Tanks and similar work including Dismantling of Mild Steel or Wrought Iron Work of any description not otherwise provided for complete all as specified and as directed. |
| 16 | M & L for two coats of Synthetic Enamel paint over one coat of Red Oxide / Zinc Chrome Primer on new steel surfaces of any description, not exceeding 10 cm width or girth including preparation of surfaces complete all as specified and as directed. |
| 17 | S & F 75mm bore PVC [SWR] pipes single socketed, in any length as in Spouts or Weep Holes in Masonry / Concrete Walls complete all as specified and as directed. |
| 18 | M & L for 600 mm dia RCC Pipes, Class NP3, laid and jointed with Collars in trenches and jointed complete all as specified and as directed. |
| 19 | M & L for PCC 1:4:8, Type D–2, using 40mm graded stone aggregate as in Foundation, Fillings, Mass concrete, Footings etc complete all as specified and as directed. |
| 20 | M & L for PCC 1:3:6, Type C–2, using 40mm graded stone aggregate as in Foundation, Fillings, Mass concrete, Footings etc complete all as specified and as directed. |
| 21 | M & L for Cutting Bituminous Road / Hardstanding etc. as required for Jointing / Laying Cables and Pipeline of width not exceeding 1000mm and depth not exceeding 1200mm and refilling after laying and making good with PCC 1:2:4, Type B1 using 20mm graded stone aggregate, 100mm thick over 300mm thick Hardcore of Guage 40mm-63mm size boulders over 100mm thick Sand filling complete all as specified and as directed. Please Enable Macros to View BoQ information |
