|
| 1 | Dismantling brick work or stone work in lime or cement mortar and including of matrerial as driected by the engineer in charge within a distance of 50 m. (SI. No. 692) |
| 2 | Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. All kinds of soil (DSR 2023 INo-2.8.1) |
| 3 | Providing and injecting chemical emulsion for preconstructional antitermite treatment and creating and chemical barrier under and around the columns pits, wall trenche basement excavation top surface if plinth filling junction of wall and floor along the external per meter of binding expension joints surrounding of pipes and conduit ete. Complete (Plinth area of the building at ground floor only shall be measured as per I.S.6313(part ii 1981). Aldrine emulsificable concentrate of any other approved material such as Hepthachlor or chlordance will be used. The rate of application of chemical emulsion shall be as follows., Treatment for masonry and foundatrion 5 litres per sqm, Back fill in immediate contact with foundation 7.5 liters/sqm.,Treatment junction of soil along extemal per meter building 7.50 litre/sqm. & Treatment of soil under apron along extemal perimeter 5 Iiter/ sqm.(S.I.No- 1 New Item) Ch- 8 |
| 4 | 1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources) (DSR 2023 I No 4.1.8) |
| 5 | Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:6 (1 cement : 6 coarse sand) (DSR 2021 Item No-6.1.2) |
| 6 | Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 12.5 in super structure above plinth level up to floor V level in all shapes and sizes in :Cement mortar 1:6 (1 cement : 6 coarse sand).(DSR 2023 I.N. 6.3.1) |
| 7 | Supplying and filling in plinth with sand under floors, including watering, ramming, consolidating and dressing complete. (DSR 2023 No-2.27) |
| 8 | Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works (DSR 2023, 10.25.2) |
| 9 | Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level : 1:1.5:3 (1 cement : 1.5 coarse sand (zone-III) derived from natural sources : 3 graded stone aggregate 20 mm nominal size derived from natural sources) (DSR 2023 INo-5.1.2) |
| 10 | Reinforced cement concrete work in beams, suspended floors, roofs having slope up to 15° landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases above plinth level up to floor five level, excluding the cost of centering, shuttering, finishing and reinforcement with 1:1.5:3 (1 cement : 1.5 coarse sand(zone-III) derived from natural sources : 3 graded stone aggregate 20 mm nominal size derived from natural sources). (DSR 2023 Item No 5.3) |
| 11 | Centering and shuttering including strutting, propping etc. and removal of form for Foundations, footings, bases of columns, etc. for mass concrete (DSR 2023 Item No- 5.9.1) |
| 12 | Centering and shuttering including strutting, propping etc. and removal of form for Lintels, beams, plinth beams, girders, bressumers and cantilevers (DSR 2023 Item No- 5.9.5) |
| 13 | Centering and shuttering including strutting, propping etc. and removal of form for Suspended floors, roofs, landings, balconies and access platform (DSR 2023 Item No- 5.9.3) |
| 14 | S/F Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level. Mild steel and Medium Tensile steel bars (DSR 2023 Item No- 5.22.1) |
| 15 | S/F Steel reinforcement for R.C.C. work ready to use “cut and bend” rebars of approved make from factory/workshop to construction site including placing in position and binding all complete above plinth level. Thermo-Mechanically Treated bars of grade Fe-500D or more. (DSR 2023 Item No- 5.22C.1) |
| 16 | 12 mm thick cement plaster of mix : 1:4 (1 cement: 4 coarse sand) (DSR 2023 Item No-13.4.1) |
| 17 | 15 mm cement plaster on rough side of single or half brick wall of mix: 1:4 (1 cement: 4 coarse sand) (DSR 2023 Item No-13.5.1) |
| 18 | Providing and laying Ceramic glazed floor tiles of size 300x300 mm (thickness to be specified by the manufacturer) of 1st quality conforming to IS : 15622 of approved make in colours such as White, Ivory, Grey, Fume Red Brown, laid on 20 mm thick cement mortar 1:4 (1 Cement : 4 Coarse sand), Jointing with grey cement slurry @ 3.3 kg/sqm including pointing the joints with white cement and matching pigment etc., complete.(DSR 2023 I.No-11.38) |
| 19 | Cement concrete flooring 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate) 40 mm thick with 20 mm nominal size stone aggregate, finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps etc. complete. without base (DSR 2023 Item No-11.3.1) |
| 20 | Providing and glass strips ,joints of floor skirting dado at time of laying floors flush with floor lavel including supply of all matareial labour and T&P etc. required for proper completion of work, 5.5mm. Thick and 2.2 cm. Depth (S.I.No 631 c) |
| 21 | 4cm (1 thick 1:2:4 plain cement concrete floor with cement, approved coarse sand and 2 cm.(3/4\\")graded approved stone shingle laid in panels finished with 3 mm.(1/8\\") floating coat of neat cement or cement and marble dust in 5:1 as specified over including Murga Jali, water proofing in the removing any over lapping mortar at the joints of Panels if any and giving them a uniform finish including Two coat painting on roof or over brick work or wherever required with bitumen @ 0.85 kg per sqm in each including supply of all material, labour and T&P etc as required for proper completion of the work supply of all materials, labour' and T&P etc. requierd for proper completion of the work including Murga Jali (A.R) |
| 22 | Providing and fixing 35 mm thick factory made laminated veneer lumber door shutter conforming to IS : 14616 and TADS 15:2001 (Part B), fixing with butt hinges of required size with necessary screws, all complete as per directions of Engineer- in-charge and panelling with panels of : 12 mm thick plain grade -1, medium density flat pressed three layer particle board FPT - I or graded wood particle board FPT- I, IS : 3087 marked, bonded with BWP type synthetic resin adhesive as per IS : 848 :(DSR I.N. 9.6.1) |
| 23 | Providing and applying plaster of paris putty of 2mm thick over plastered surface to prepare the surface even and smooth complete (DSR 2023, I No.13.26) |
| 24 | Finising walls with acrylics smooth exterior paint of required shade New work two more coat applied @1.67 lir./10Sqm over and including base coat of water proofing cement paint applied @2.2kg/10Sqm (DSR 2023.-13.46.1) |
| 25 | Distempering with 1st quality acrylic distemper (ready mixed) having VOC content less than 50 gram/litre, of approved manufacturer and of required shade and colour all complete to achieve even shade and colour : New work (two coats) over and including water thinnable priming coat with cement primer having VOC content less than 50 gram/litre(DSR 2023.I.No. 13.41.1). |
| 26 | Applying priming coat: With ready mixed red oxide zinc chromate primer of approved brand and manufacture on steel galvanised iron/ steel works (DSR 2023, 13.50.3) |
| 27 | Applying priming coat: With ready mixed aluminium primer of approved brand and manufacture on resinous wood and plywood (DSR 2023, 13.50.2) |
| 28 | Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade : Two or more coats on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture (DSR 2023 Item No-13.62.1) |
| 29 | Cement plaster 1:3 (1 cement: 3 coarse sand) finished with a floating coat of neat cement.20 mm cement plaster ( DSR 2023 I N.13.9.2) |
| 30 | Providing and fixing G.I pipes complete with G.I. Fittings and clamps including cutting and making good the walls etc. internal work Exposed on wall : 15mm dia. Nominal bore (D.S.R. 2023 I. No.18.10.1) |
| 31 | Providing and fixing G.I pipes complete with G.I. Fittings and clamps including cutting and making good the walls etc. internal work Exposed on wall : '20mm dia Nominal bore (D.S.R. 2023 No.18.10.2) . |
| 32 | Providing and fixing brass bib cock of approved Qty nominal bore, 15mm dia. Nominal bore (D.S.R. 2023 No.18.15.1) |
| 33 | providing and fixing brass stop cock of approved Qty 15mm dia. Nominal bore ( D.S.R.2023 No.18.16.1) |
| 34 | Concealed pipe including painting with anti corrosive bitumastic paint, cutting chases and making good the wall, 15mm dia. Nominal bore ( DSR 2023.I.No-18.11.1) |
| 35 | Providing and fixing ball valve (brass) of approved quality complete:High or low pressure with plastic floats: 15 mm nominal bore (DSR 2023.I.No-18.18.1.1) |
| 36 | Providing and placing on terrace (at all floorlevels ) polyethylene water storage tank ISI: 12701 marked with cover and suitable lockinjg arrangement and makinjg necessaryholes for inlet, outlet and overflow pipes but without fittings and the base support for tank. (DSR.I.No.- 18.48) |
| 37 | Providing and fixing white vitreous china wash basin including making all connections but excluding the cost of fittings :Flat back wash basin of size 630x450mm (DSR 2023.I.No-17.25.1) |
| 38 | Providing, laying and jointing glazed stoneware pipes grade 'A' with stiff mixture of cement mortar in the of 1 :1 (1 cement: 1 fine sand) including testing of joints etc. complete:100 mm dia. Nominal bore (D.S.R. No.19.1.1) |
| 39 | Providing and fixing water closet squatting pan (Indian type W.C. pan) with 100mm sand cast Iron P or Strap, 10 litre low level white P. V.C. flushing cistern with manually controlled device (handle lever) conforming to IS : 7231, with all fittings and fixtures complete including cutting and making good the walls and floors wherever required:White Vitreous china Orissa pattern W.C. pan of size 580x440mm with integral type foot rests. (DSR 2023.I. No 17.1.1) |
| 40 | Providing and fixing lSI marked oxidised M.S.sliding door bolts with nuts & screws etc. complete ( DSR No- 9.62) 250x16 mm ( DSR 2023 No-9.62.2) |
| 41 | Providing and fixing lSI marked oxidised M.S. tower bolt black finish, (Barrel type) with necessary screws etc. complete: 250x10 mm ( DSR2023 No- 9.63.1) |
| 42 | Providing and fixing lSI marked oxidised M.S. tower bolt black finish, (Barrel type) with necessary screws etc. complete: 200x10 mm( DSR 2023 No-9.63.2) |
| 43 | Providing and fixing lSI marked oxidised M.S. handles conforming to IS:4992 with necessary screws etc. complete: 125mm ( DSR 2023 No- 9.66.1) |
| 44 | Providing and fixing lSI marked oxidised M.S. handles conforming to IS:4992 with necessary screws etc. complete: 100mm ( DSR 2023 No- 9.66.2) Please Enable Macros to View BoQ information |
