|
| 1 | Dismantling wrought iron or mild steel work of any description not otherwise provided for |
| 2 | S&F mild steel work as in posts or struts of fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc, including all necessar drilling, bolting or riveting etc conforming to Fe- 290 Gde E-165. |
| 3 | S & F Rolled Mild Steel Framed work as in doors or Gates of angle or other section confirming to Fe 410 - S, with gusset plates, rails braces, etc., complete, drilled for fixing of steel sheeting or other covering and hanging and fixing complete. |
| 4 | S&F Rolled sections as in main and cross beams, hip and jack rafters; purlins where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates Fe 410 gde E |
| 5 | S&F steel work as in tubular (round/square/ rectangular shape of pipes as approved by Engr-in-Charge) trusses of semi circle shape upt height 6 mtr including post special shaped washers etc complete incl necessary nut bolts wind tiles and gusset plates etc using ERW or induction butt welded tubes conforming to IS 1161-1998 grade Yst-240 complete all as specified |
| 6 | S&F Framed work such as grills, gratings etc., with ends of bars shouldered and/or riveted, or forget into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks and similar work conforming to Fe 410-0 or Fe 310-0 |
| 7 | M & L two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer including preparation of previously untreated surfaces of steel and iron exc 10 cm width or girth. |
| 8 | Dismantling Asbestos cement (corrugated, semi corrugated, etc sheets in roof coverings complete all as specified and directed. |
| 9 | S & F pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50 mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all as specified and directed. |
| 10 | S&F of pre-painting galvalume sheets (Galvalume base-PPGL trapezoidal profile sheets) thickness not less than 0.50mm having tensile strength of 550 Mpa as in ridges, hips, valley gutters, drip and straight flashing cut to length and bend to shape fixed with aluminium self tapping screws of size 50/75mm and aluminium washer of suitable size in roof covering all as specified. |
| 11 | S&F Polycarbonate Hollow sheet 10mm thick of an colour having tensile strength of 60.30MPa as in roof covering/cladding to wall, fixed with self tapping screwsand including aluminium channel strip complete all as specified and as directed by Engineer in charge(.Note: Colour is approved by GE) Please Enable Macros to View BoQ information |
| 12 | S&F Polycarbonate Hollow sheet 10mm thick of an colour having tensile strength of 60.30MPa as in roof covering/cladding to wall, fixed with self tapping screwsand including aluminium channel strip complete all as specified and as directed by Engineer in charge(.Note: Colour is approved by GE) Please Enable Macros to View BoQ information |
