|
| 1 | 4.4.1 Surface dressing of the ground including removing vegetation and in-equalities not exceeding 15 cm deep and disposal of rubbish, lead up to 50 m and lift up to 1.5 m.1 All kinds of soil |
| 2 | 9.33 SHEET ROOFING Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch ofcorrugation as approved by Engineer-in-charge) 0.50 mm ( plus 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS:277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should haveprotective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length up to 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete up to any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. |
| 3 | 4.7.1 Earth work in surface excavation not exceeding 30 cm in depth but exceeding 1.5 m in width as well as 10 sqm on plan including getting out and disposal of excavated earth and lift up to 1.5 m, as directed by Engineer-in- Charge:1.1 All kinds of soil 50m lead |
| 4 | 4.12.1 Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead up to 50 m and lift up to 1.5 m,as directed by Engineer-in-charge.1 All kinds of soil |
| 5 | 10.8 CEMENT CONCRETE FLOORING Providing and laying of conglomerate floor 40mm thick cement concrete topping 1:2:4 |
| 6 | 11.6.1 CEMENT PLASTER (IN FINE SAND) 15 mm cement plaster on the rough side of single or half brick wall of mix :1 1:4 (1 cement: 4 fine sand) |
| 7 | 11.6.2 CEMENT PLASTER (IN FINE SAND) 15 mm cement plaster on the rough side of single or half brick wall of mix :2 1:6 (1 cement: 6 fine sand) |
| 8 | 11.30.2 TILE FLOORING Providing and laying of chequered precast cement concrete tiles 22 mm thick in footpath and courtyard, jointed with neat cement slurry mixed with pigment to match the shade of tiles, including rubbing and cleaning etc. complete, on 20mm thick bed of cement mortar 1:4 (1 cement: 4 coarse sand).2 Medium shade pigment using 50% white cement 50% Grey cement |
| 9 | 11.25.1 POINTING ON BRICK WORK Pointing on brick work or brick flooring with cement mortar 1:3 (1 cement : 3 fine sand):1 Flush / Ruled/ Struck or weathered pointing |
| 10 | 13.29.2 SIGLE/BUILT-UP STEEL/TUBULAR SECTIONS Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required.2 In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works. |
| 11 | 13.30.2 SIGLE/BUILT-UP STEEL/TUBULAR SECTIONS Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.2 Hot finished seamless type tubes |
| 12 | 11.68.3 INTERIOR FINISHING Applying priming coat:3 With ready mixed red oxide zinc chromate primer of approved brand and manufacture on steel galvanised iron/ steel works. |
| 13 | 10.100.1 OTHER MISCELLANEOUS ITEMS USED FOR FLOORING 0 Cement Concrete 1:8:16 Flooring1 Cement Concrete 1:8:16 with Over burnt (Jhama) Brick Aggregate: 90 mm to 40 mm size in foundation and plinth. |
| 14 | 11.78 INTERIOR FINISHING Painting two coats excluding priming coat with synthetic enamel paint in all shades on new wood work or metallic or plastered or concrete surfaces to give an even shade. |
| 15 | 7.20.2 BRICK WORK Brick work with common burnt clay modular bricks of class designation 10.5 in foundation and plinth in:2 Cement Mortar 1:6 (1 cement : 6 coarse sand) |
| 16 | 7.22.2 B BRICK WORK Brick work with common burnt clay non-modular bricks of class designation 10.5 insuperstructure above plinth level up to floor IV level in all shapes and sizes in :2 Cement mortar 1:6 (1 cement : 6 coarse sand). |
| 17 | 30.24 FINISHING WORKS Distempering with dry distemper of approved brand and manufacture(one or more coats) and of required shade on old work to give an even shade. |
| 18 | 6.1.1 CEMENT CONCRETE (CAST IN SITU) Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work below plinth level and up to Floor IV level:1 1:1½:3 (1 Cement: 1½ coarse sand (zone-III) : 3 graded stone aggregate 20 mm nominal size) |
| 19 | 6.2.2 CEMENT CONCRETE (CAST IN SITU) Providing and laying cement concrete in retaining walls, return walls, walls (any thickness) including attached pilasters, columns, piers, abutments, pillars, posts, struts, buttresses, string or lacing courses, parapets, coping, bed blocks, anchor blocks, plain window sills, fillets, sunken floor etc., up to floor four level, excluding the cost of centering, shuttering and finishing:2 1:2:4 (1 Cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size) |
| 20 | 6.8.2 DAMP-PROOF COURSE Providing and laying damp-proof course with cement concrete 1:2:4 (1 cement : 2 coarse sand (zone-III): 4 graded stone aggregate 12.5mm nominal size)2 40mm thick |
| 21 | 6.14.2 D REINFORCED CEMENT CONCRETE Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level :2 1:2:4 (1 cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size) |
| 22 | 6.29.3 CENTRING AND SHUTTERING (FORM WORK) Centering and shuttering including strutting, propping etc. And removal of form work for :3 Columns, piers, abutments, pillars, posts and struts. |
| 23 | 6.39.1 K CEMENT CONCRETE PRECAST Providing and fixing at or near ground level precast cement concrete in kerbs, edgings etc. as per approved pattern and setting in position with cement mortar 1:3 (1 Cement : 3 coarse sand), including the cost of requiredcentering, shuttering complete.1 1:1½:3 (1 Cement: 1½ coarse sand(zone-III) : 3 graded stone aggregate 20 mm nominal size). |
| 24 | 6.33.3 STEEL REINFORCEMENT Steel reinforcement for R.C.C. work, where not included in the complete rate of RCC, including straightening, cutting, bending, placing in position, binding, wastage, overlaps, welded joints, spacer bars, chairs, stays, hangers and annealed steel wire etc. complete in all respect below plinth level3 Cold twisted bars |
| 25 | Job Work ANALYSIS OF RATES EARTH FILLING UPTO 5.00 KM LEVEL AS PER HSR 2023 COMPLETE IN ALL RESPECT. |
| 26 | Job Work Supply of RCC Pole made in cement concrete ration 1:2:4 size 1.80 MTR high 4.50\\" x 4.50\\" at bottom and 3.50\\" x 3.50\\" at top which include 4 No. 6MM Dia Round Bar, providing 7 No. Ring, 6 No. Hooks including carriage upto site of work complete in all respect and @380/- Each (Market Rate) |
| 27 | Job Work Providing and fixing of 06 Nos. Horizontal and 2 cross GI Barbed wire fencing complete in all respect. Please Enable Macros to View BoQ information |
