|
| 1 | Rewiring for light point/ fan point/ exhaust fan point/ call bell point with 1.5 sq.mm FRLS/HFFR PVC insulated copper conductor single core cable and 1.5 sq.mm FRLS/HFFR PVC insulated copper conductor single core cable as earth wire in existing surface/ recessed steel/PVC conduit including dismantling as required.a) Group C |
| 2 | Supplying and fixing of following sizes of steel conduit along with accessories in surface/recess including painting in case of surface conduit, or cutting the wall and making good the same in case of recessed conduit as required.a) 20 mm |
| 3 | b) 25 mm |
| 4 | Supplying and drawing following sizes of FRLS/HFFR PVC insulated copper conductor, single core cable in the existing surface / recessed steel / PVC conduit as required.a) 3 x 1.5 sq.mm |
| 5 | b) 3 x 4 sq.mm |
| 6 | c) 6 x 4 sq.mm |
| 7 | d) 3 x 6 sq.mm |
| 8 | Supplying and fixing suitable size GI box with modular plate and cover in front on surface or in recess, including providing and fixing 6 pin 5/6 & 15/16 A modular socket outlet and 15/16 A modular switch, connections etc. as required. |
| 9 | Supplying and fixing suitable size GI box with modular plate and cover in front on surface or in recess, including providing and fixing 2 nos. 3 pin 5/6 A modular socket outlet and 2 nos. 5/6 A modular switch, connections etc. as required. (For light plugs to be used in non residential buildings). |
| 10 | Supplying & fixing 400mm sweep wall mounted cabin fan with speed regulator oscilatting type i/c testing & commsisioning suitable for 230volt 50Hz AC supply etc as reqd. |
| 11 | Supplying & Intallation of fresh air fan 250 mm sweep with shutter and louver in the existing opeining , including making the hole to suit the size of the above fan, making good the damage, connection, testing, commissioning etc. as required. |
| 12 | Supply and fixing of 15/16Amp 3pin top plug including connection complete as reqd. |
| 13 | Supplying , Installation, Testing and Commissioning of Air Cooled Hi Wall split type Air conditioners complete with Indoor unit(IDU), Out door unit (ODU), surface / concealed copper Refrigerant piping with insulation (closed cell elastomeric nitrile rubber tubular pipe section) upto 3 Mtr (IDU to ODU), copper power cable upto 3.5 Mtr (IDU to ODU) i/c drain pipe R-32/R-410/ R-407 Green Refrigerant, wireless Remote control, suitable for working between 180- 260V with low & high voltage cutoff and 50 hz ,1 phase AC supply capable of performing cooling, dehumidification, air circulation of following capacity with Scroll / rotary compressor. The system shall be able to deliver 100% of the rated capacity upto 42 0C. Min 5 year OriginalEquipment Manufacturer (OEM) warranty both compressor and Printed Circuit Board (PCB). Must comply : Electrical cable IS 694 or IS 9968 temperature sensing control IS /International Electrotechnical Commission (IEC) 60730, hermetic compressor IS 10617, heat exchanger IS 11329, capacitor IS 2993 and motor IS 12615. Complete as per CPWD specification and IS : 1391 Part II 2023. The system shall be able to operate up to 50 0C (out door ambient temperature). (Inverter Type - Cooling only)a) 1.5 TR with 5 Star BEE Rating |
| 14 | Supplying , Installation, Testing and Commissioning of Window type Air conditioners complete with copper power cable upto 3 Mtr, wireless Remote, suitable for working between 180- 260V with low & high voltage cutoff and 50 hz ,1 phase AC supply capable of performing, cooling, dehumidification, air circulation, R-32/R-410A /R-407B Green Refrigerant with Scroll / rotary compressor with min 5 year Original Equipment Manufacturer (OEM) warranty both compressor and Printed Circuit Board (PCB), antifreeze thermostat on the coil as a safety feature, complete with fixing including T&P & labour etc as required complete in all respect as specified of following capacity. Sound level of up to 50dB inside the room is acceptable. The unit shall be in confirmation with IS 1391 Part-I 2023 and CPWD Specification. The system shall be able to deliver 100% of the rated capacity upto 42 0C. The system shall be able to operate up to 50 0C (out door ambient temperature).Non Inverter Type a) 1.5 TR with fixed speed 5 Star BEE rating |
| 15 | Supplying ,installation , testing and commissioning of 4 KVA voltage stablizer wall mounted type for domestic use copper wound complete upto 1.5TR Capacity Air Conditioners unit, , Operating Voltage range (Input): 150-280 volts,Output 230+ 10 Volts, 50Hz AC supply etc. as required. |
| 16 | Supplying & Fixing 25 mm diameter PVC heavy duty pipe for drainage in the existing split type AC unit with supporting clamps etc . complete as reqd. |
| 17 | Supplying and fixing of Extra copper refrigerant piping of 5/8”, 3/8”, 1/4” i/c nitrile rubber insulation wrapping etc. complete as reqd. |
| 18 | Providing and fixing of 3 core 2.5 sqmm PVC insulated and PVC sheathed bright annealed copper conductor cable for communication between indoor unit/outdoor unit/controllers inside building in existing steel/PVC Conduit/ surface/ existing channel, i/c making connection etc as reqd. |
| 19 | Supplying and fixing stand for the outdoor unit of the STAC made of MS duly powder coated complete etc as required. |
| 20 | Supplying, installation, Testing & Commissioning of Panel light 2x2 ft., of following body material and construction as per IS: 10322 with DALI control driver as per the requirement with Driver efficiency >85%, Operating voltage AC 140-270 Volt, freq 50/60 hz, Operating temp range -15 deg to 40 deg centigrade, internal surge protection of 2.5 KV with Short & Open circuit protection, THD < 10% , P. F.≥0.95, IP20, CRI ≥80, UGR (Unified Glare Rating) < 16, Flicker free, (flicker should be below 5 %), life time (LED, Driver & electrical circuitry), of minimum 50000 Burning Hours with, 70% of initial Lumen maintained till life ends as per LM80 extrapolation IES TM-21-11 report, CCT Range 4000°to 6500°K (As per ANSI Bin), SDCM (Standard Deviation Colour Matching) <3, Maximum power consumption should not more than the specified rating and Fixture shall be of relevant BIS standard and trade mark certificate ( T.C.). Manufactures Word Mark/ Name Engraved/ Embossing/ Screen printing on housing. complete in all respect i/c external connections with 1.5 sq. mm FRLS/HFFR, PVC insulated copper conductor single core cable and earthing etc. as required with Minimum 5 year OEM warranty. System lumen efficacy ≥105 <120 lm/Watt output. LM79 & LM80 Test report and all testing required for LED fixtures as per BIS shall be submitted. Shape size and CCT shall be as approved by Engineer-in-Charge as per requirement. (Thermal management: heat sink of aluminium housing such that LED junction temperature shall not rise above 90°C). 36W with Dali Control control, PDC Aluminium / Extruded Aluminium body (Thickness ≥1.20mm) etc complete as reqd. |
| 21 | Supplying, installation, Testing & Commissioning of maximum 8watt and lumen flux luminaries 800 lumen COB LED Recessed/surface Down lighter (Round/ square/ Rectangular) SMD type with dali control gear of following body material with PMMA and prismatic diffuser and construction as per IS : 10322 with driver as per the requirement with Driver efficiency >85%, Operating voltage AC 140-270 Volt, frequency 50/60 hz, Operating temp range -5 0C to 40 0C centigrade, internal surge protection of 2.5 KV with Short & Open circuit protection ,THD < 10%, P. F.≥0.95, IP20, CRI >90, UGR (Unified Glare Rating) <16, Flicker free (flicker should be below 5 %), life time (LED, Driver & electrical circuitry), life time of minimum 50000 Burning Hours with 70% of initial Lumen maintained till life ends, CCT 3000°K / 4000°K / 5700°K /6500°K (As per ANSI Bin), SDCM(Standard Deviation Color Matching) <3, Maximum power consumption should not more than the specified rating and Fixture shall be of relevant BIS standard. Manufactures Word Mark/ Name Engraved/ Embossing/ Screen printing on housing Complete in all respect i/c external connections with 1.5 sq mm FRLS/HFFR, PVC insulated copper conductor single core cable and earthing etc. as required with Minimum 5 year OEM warranty. System lumen efficacy ≥120 <135 lm/Watt output . LM79 & LM80 Test report and all testing required for LED fixtures as per BIS shall be submitted.. Shape size and CCT shall be as approved by Engineer-in- Charge as per requirement. (Thermal management: heat sink of aluminium housing such that LED junction temperature shall not rise above 90°C). Powder coated die cast /Extruded aluminium Body including trim . |
| 22 | Supplying, installation, Testing & Commissioning of BIS approved IP20 Indoor strip COB light, with Aluminium Profile LED Strip, 15Watts/per Mtr, 24V DC DALI DRIVER, CRI >90, 3SDCM, L70B10@50,000B Hrs with 5Yrs Warranty. SLED trip should be Resin coated for additional protection, LED Efficacy 90LPW, Strip should come along with Thurmo conductive adhesive 3M in base for safe installation. LED Strip should be compatible for mounting on Surface mounted Triangle/Corner Mount Aluminum Profile and PC diffuser with Endcap and Mounting clip (2 sets/M).W: 16mm X H: 16mm LED Strip & Profile should be supplied with compatible 24V DC DALI 2 suitable for Tunable & Dimmable Driver of Reputed Make suitable for suitable for Indoor Application. LED Strip should be supplied in 5 Mtr. reels and can be cut and used based on site requirements in different length . BIS Approved Drivers LED Strips with 5 Years warranty, Signage Indoor strip light, 3000K CCT, 15Watts/Mtr, 24V DC, 3SDCM - PRIME, IP20 PRIME +ASAFTR01-SURFACE MOUNT TRIANGLE ALUMINIUM EXTUSION SET WITH OPAL DIFFUSER AND END CAPS 1M- SUITABLE FOR MAZE STRIP (16mmx16mm)+ DALI DRIVER etc complete as reqd. |
| 23 | Supplying, installation, Testing & Commissioning of 40watt 8ft. Minlight plus Pendent mounted Direct type LED luminaire in 44mm width and 2FT/4FT/6FT Length , UPDOWN Distribution with system power [40W ± 5%] , Cool White color temperature (5700K ± 355K) , made of extruded Aluminium housing and Snap fit type PDC Aluminium endcaps, Powder coated Corrosion Resistant Nano coating technology. The fixture is provided with Micro linear reflector used for low Glare <12 & optimal light Transmission. High efficiency electronic driver with rated voltage of 140-270V, Power factor > 0.95 and THD < 8% , Flickerfree with Ripple factor <5%,< 3 SDCM, Inbuilt surge protection of 3 KV & additional SPD with 6KV protection, should have mis wiring, Over voltage/under voltage & Short circuit protection. Driver should be maintenance-friendly with easy access to driver from top of the Luminaire. The Luminaire lumen output > 120 LPW , CRI of 90, R9>50, IP20 Protection . The LEDs used have a life of 80000 burning hrs & Lumen maintenance as per L70. Comes with standard warranty of 5 Years. Luminaire performance & Safety :IEC 60598, IS 10322- 5, IS 161-03/05/06/07, Surge : IEC 61000-4-5, EMC : EN 55015 IES, LM 79, LM 80, & TTC certificates will be provided from a NABL accredited lab. Necessary Certification: CE Certified, ROHS compliant, BIS certified - Dimension : L-2400mm W-44mm H-22mm) etc complete as reqd. |
| 24 | Supplying, installation, Testing & Commissioning of Modular Pendant luminaire Slash S with HPE (High Performance Efficiency) LED (Light Emitting Diode) system power: 28 W, Luminous flux of luminaire 3080 lm,Colour temperature of 5700 K, Cool white, CRI > 90, 230 V constant current driver, 70% of luminous flux after 50,000 operating hours; Energy efficient LEDs, Direct light emission, Luminaire profile in anodised aluminium, pre-wired batten luminaire, snap fit Prismatic APD (Added Performance Diffuser) diffuser for a homogenous light distribution, UGR<19 ZHLS (ZERO HALOGEN LOW SMOKE) internal wiring, Electronic control gear, Sliding fixing wire suspension,Protection class I, IP 20, MacAdam 3, T.H.D ≤ 10%,CRI>80, driver efficiency ≥ 88%, surge protection of 2.5kV,L1= 2400mm, B = 75 mm, H = 70 mm and fitting should be compairtable to connect from each fittings without gape and shape shall be obtain as per Engineer-in-charge and etc complete as reqd. |
| 25 | Credit Material Assorted : Fresh Air Fan/wall fan |
| 26 | Assorted : Switch/socket/regulator (Piano/Modular) |
| 27 | Assorted : copper Wire with insulation |
| 28 | Assorted : GI Box with modular plate/phenolic sheet |
| 29 | Assorted : LED batten/Downlighter/fl. Fitting |
| 30 | Assorted : 2x2 fitting |
| 31 | Assorted : Window/Split AC Please Enable Macros to View BoQ information |
