Name of Work:- Resurfacing of Internal Roads in Sector – Sigma III, Greater Noida.
Sl. No.
Item Description
1
Providing and applying tack coat with bitumen grade VG-10 using bitumen pressure distributor at the rate of 0.5 kg per sqm on the prepared bituminous surface cleaned with mechanical broom.
2
Dense Graded Bituminous Macadam Grading-ll: Providing and laying dense graded bituminous macadam with higher capacity batch type HMP using crushed aggregates of specified grading, premixed with bituminous binder VG-30 @ 4.5 percent by weight of total mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment. rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MORTH specification clause No. 505 complete in all respects (MORTH-505)
3
50mm compacted thickness with bitumen penetration of 60/70 @ 4.5% by weight of total mix
4
Providing and laying bituminous concrete with higher capacity batch type hot mix plant using crushed aggregates of specified grading, premixed with bituminous binder VG-30 @ 5.4 percent of mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MORTH specification clause No 507 complete in all respects (MORTH-507)
5
40mm compacted thickness with bitumen penetration of VG-30 @ 5.4% weight of total mix
6
Providing and laying 40mm thick mastic asphalt wearing course with paving grade bitumen meeting the requirements given in table 500-29 prepared by using mastic cooker and laid to required level and slope after cleaning the surface including providing antisked surface with bitumen precoated fine grained hard stone chipping of 13.2mm nominal size at rate of 0.005 cum per 10 sqm and at am approximate spacing of 10cm center to center on both direction pressed into surface when the temperture of surface not less them 1000c producing 1mm to 4mm over mastic surface all complete as per Morth clause 516/AR/GNIDA
7
Labour Cess and GST will be paid extra as per govt.orders Please Enable Macros to View BoQ information
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
