|
| 1 | Providing, Fabrication and Installation of Covered Structure in the Mortuary Section at KEM Hospital |
| 2 | Providing, detailing, composite fabricating members like Trusses, N-girders, girders, bracings, supports, purlins, runners, and similar structural steel members fabricated using M.S. hollow tubular steel sections (circular & rectangular pipes), of TATA Structura Make or equivalent conforming to IS 1239 part 1 and 2 and of grade Fe 250 as per specifications and approved fabrication drawings (which are to be prepared by Contractor and got approved from Engineer), including transportion of the same to site, erection of structural steel members for all heights & at all levels, provision of necessary erection bolts, fixing bolts, nuts, washers, cleats, stiffeners, gussets, base plate, and all necessary operations like preheating as per specifications, straightening, bending, cutting, drilling, grinding, machining if specified, welding, grinding, removing the welding burr and preparing surface for painting with wire brush cleaning and applying two coats of epoxy red oxide zinc phosphate primer of 30 microns each and two coats of Epoxy Corrosion Resistant Enamel paint of 30 microns after fabrication including touching up with spray painting after erection etc complete as directed by Engineer In Charge. |
| 3 | Providing and fixing structural Profile decking sheet as per particular specification,with GI sheet, zinc coating not less than 275 GSM as per IS 277 and of yield strength 500 Mpa of approved make with specified Base Metal Thickness. The profile shall be structural decking profile having ribs & pitch as per the drawing referred with the embossments (shear groove) on top and side of the ribs for better composite action. The decking sheet shall be fabricated to required form as per the slab design and fixed with Galvanised Iron fasteners, self drilling screws, shear studs as per IS 1367, connectors etc. complete as per design, drawing and direction of Engineer-in Charge. (Refer typical drwg).The sheet shall be filled with 75mm thick M25 grade concrete reinforced with 8mm dia. HYSD bars placed 150mm C/C both ways. Plan area of the sheeting shall be measured and paid. Structural steel frame work shall be paid seperately. With Base Metal Thickness (BMT) (excluding Zinc coat thickness) 1.00 mm thick Profile decking sheet . |
| 4 | Excavation for foundation, substructures, basements, tanks, sumps, walls, chambers, manholes, trenches, poles, pits & general building works in soft/ disintegrated rock, sand stone, stiff clay, gravel, cobblestone, hard laterite, water bound macadam, wet mix macadam, asphalt mix carpet of any type, pitching, soling, paths and hardcore, lime concrete, plain cement concrete, stone masonry and all types of brick/ block masonry below ground level, rock boulders, etc. for depths/ lifts upto 1.5M measured from the ground level, including dressing/ trimming the sides, leveling of bottoms, manual dewatering, removing rank vegetation, backfilling in layers not more than 200mm thickness, watering, consolidating, compacting to achieve not less then 97% Modified Proctor density conforming to relevant IS, stacking in measurable heaps for future use within owners space or disposing within an initial lead of 150m as directed, loading, unloading, leveling excluding shoring, strutting etc. complete as directed by Engineer-in Charge. Note: 1) The rate includes the handling/supporting the existing utilities such as cables, drains, pipes, water mains etc. 2) It also includes the royalty and other taxes if any. Please Enable Macros to View BoQ information |
