|
| 1 | Providing laying, spreading by mechanically means and compacting to 75mm (seventy five millimeter) compacted thickness, stone aggregates of Grading-III, 53mm to 22.4mm (fifty three to twenty two point four millimeter) size to water bound macadam specification including spreading in uniform thickness, using template, hand packing motor grader, rolling with three wheeled roller 80-100 (eighty to hundred) kN static weight in stages to proper grade and camber including applying and brooming stone screening type-B of size 11.2mm (eleven point two millimeter) nominal size at the rate of 0.18cum (zero point one eight cubic meter) per ten square meter to fill up the interstices of coarse aggregate, watering and compacting to the required density as per MORD Technical specification section 400 and as per entire satisfaction and direction of Engineer-in-Charge including carriage of materials with in all leads, lifts and other incidentals. The rate is including Royality, Malkana, Octroi, GST, toll tax or any other taxes imposed by the Government. |
| 2 | Repair to pot holes by removal of loose material, trimming of sides, cleaning of surface, then providing tack coat at the rate of 0.300Kg (Zero point three zero zero kilogramme) per square meter road surface with bitumen VG-10 followed 20mm (Twenty millimetre) thick compacted pre-mix carpet using 1.46Kg (One point four six kilogramme) of bitumen VG-10 and 0.027 Cum (Zero point zero two seven) cubic meter of crushed stone aggregate of proper grading per square meter of road surface mixed and heated to proper temperature in mix-all 6-10 tonne capacity rolled to desired density with 8-10 tonne weight static road roller followed by seal coat IRC type B using 0.68Kg (Zero point six eight kilogramme) of bitumen VG-10 and 0.006 (Zero point zero zero six) cubic meter sand per square meter of road surface duly mixed and heated in mixall to the required temperature and property rolled after laying with 8-10 tonne weight static road roller to the desired density as per technical specification Clause 1904.2, direction of the Engineer-in-Charge. including carriage of materials with in all leads, lifts and other incidentals. The rates including Royality, Malkhana, Octroi, Toll tax, Sale tax, GST or any other taxes imposed by the Government. |
| 3 | Providing and applying tack coat with bitumen emulsion RS-I, including cleaning the road surface with hydraulic brooms and spraying with emulsion pressure distributor at the rate 0.25 to 0.30 kg (zero point two five to zero point three zero kilogramme) per square meter on the prepared granular surface treated with primer complete as per MORD Technical specification section 500, and as per the entire satisfaction and direction of Engineer-in-Charge including carriage of materials with in all leads, lifts and other incidentals. The rate is including Royality, Malkana, Octroi, GST, Toll tax or any other taxes imposed by the Government. |
| 4 | Providing and laying 30mm (Thirty millimetre) compacted thick bituminous concrete with min 40-60 TPH (Forty- sixty tonne per hour) hot mix batch type/drum type plant with electronic control Grading-II using crushed aggregate 13mm (Thirteen millimetre) nominal size of specified grading premixed with bituminous binder VG-30 (Viscosity Grade-Thirty) @ 5% (five percent) of mix weight transported to site, laid with censor paver finisher hydraulic with censor control to the required grade, level and alignment over a previously prepered surface and rolling complete with smooth wheeled roller 8-10 (Eight-Ten) tonne capacity for initial break down rolling and vibratory roller 8-10 (Eight-Ten) tonne capacity or pneumatic type roller of 12-15 (Twelve-fifteen Tonne) with tyre pressure of atleast 0.56 mpa (Zero point five six ) for intermediate rolling and finish rolling with 6-8 (six-eight) tonne smooth wheeled tandom roller to achieve the desired compaction as per MORTH Technical specification clause No. 509 including hauling of material in all leads, lifts as per entire satisfaction and direction of Engineer-in-Charge including carriage of material within all leads,lifts and other incidental. The rates including Royality, Malkhana, Octroi, Toll tax, Sale tax, GST or any other taxes imposed by the Government. |
| 5 | Providing and laying of hot applied thermoplastic compound 2.5mm thick (two decimal five millimeter) thick and 0.10 (zero decimal one zero) meter wide strip in centre line and 0.30 (zero decimal three zero) meter wide strip in zebra crossing including reflectorising glass beads @ 250 gms (two hundred fifty grammes) per square meter area, thickness of 2.5mm (two decimal five millimeter) is exclusive of surface applied glass beads as per IRC: 35 (thirty five) in accordance with ministry of road transport specifications (Latest revision) and IRC code the finished surface to be level, uniform and free from strasks and holes including carriage of all labours, equipments and materials to various location through all modes of tranpottation in all leads , lifts and all incidental charges, including carriage of material within all leads,lifts and other incidental. The rates including Royality, Malkhana, Octroi, Toll tax, Sale tax, GST or any other taxes imposed by the Government. Please Enable Macros to View BoQ information |
