|
| 1 | Excavation work by mechanical means (Hydraulic excavator)/ manual means in foundation trenches or drains of soil in all kinds of soils, soft and hard rocks and saturated soil, de-watering, including wedging out rocks where blasting work is prohibited, chiseling or any other mixed variety of soil, including shoring, strutting or bailing out water upto any depth or any height quantum of water including de-watering removal of slush and stacking the serviceable and un-serviceable material clear from the edge of excavation as per direction of Engineer-in-Charge and returning the stacked soil in 15cm (Fifteen centimeter) layers, when required into plinths, sides of foundation etcetera consolidating each deposited layer by ramming, watering and then disposing of all excavated earth including carriage of material within all leads, lifts and other incidentals as per approved drawing, design and as directed by the Engineer-Incharge. The rate is inclusive of octroi, royality, Malkana, Toll tax, sale tax, GST and any other taxes imposed by the Government. |
| 2 | Providing and laying mechanically mixed and vibrated cement concrete 1:5:10 (one cement isto five sand isto ten graded crushed stone aggregate 40mm (forty millimeter) nominal size) for plain cement concrete, in or under water in open foundation for all types of structures,retaining/breast walls, edge walls including pumping or bailing out water/ dewatering (surface/sub-soil water) and including removal of slush which may arise at the time of laying under water for all heights/depth and any quantum of water including cost of form work and curing complete as per drawing and MORD Technical specification 802, 803, 1202 & 1203 and as per the direction and the entire satisfaction of Engineer-in-Charge, including carriage of material with in all leads lifts and other incidentals. The rates including Royality, Malkhana, Octroi, Toll tax, Sale tax, GST or any other taxes imposed by the Government. |
| 3 | Providing and laying in position Tor steel/ reinforcement in Sub-Structures of TATA TISCON/SAIL/JINDAL- PANTHER steel make of thermo mechanically coated bars of grade Fe 500D for Reinforced Cement Concrete work complete as per drawing and MORD 1000 and 2000 including cutting , bending, binding and placing in position complete including cost of binding wire and other incidentals for its completion upto any floor level and as per the directions of the Engineer-in-Charge including carriage of materials within all leads, lifts and other incidental. The rate is including of Octroi, Royality, Malkhana, Toll Tax, Sale Tax, GST or other Taxes imposed by the Government. |
| 4 | Providing and laying mechanically mixed and vibrated reinforced cement concrete Grade-M-20 (M-Twenty) design mix with cement contents not less than @ 350 kg (three hundered fifty cubic metre) with 20mm (twenty millimeter) nominal size graded crushed stone aggregate in Bed Block, dirt wall and the like etcetera for all heights, including cost of form work and curing complete but excluding the cost of reinforcement for reinforced work as per MORD technical specification section 800,900 and 1200 and as per the direction and the entire satisfaction of Engineer-in-Charge complete including carriage of materials with in all leads, lifts and other incidentals. The rates is including Royality, Malkana, Octroi, toll tax, sale tax, GST or any other taxes imposed by the Government. |
| 5 | Providing and Laying filling Behind Retaining Wall with approved Granualr mterial as per specification to a thickness of not less than 600 mm with smaller size towards the soil and bigger size towards the wall and providing over the entire surface behind abutment, wing wall, return wall to full height compacted to firm condition completeas per drawing and technical specification clause 1204.3.8 and as directed by the Engineer-in-Charge including carriage of materials with in all leads, lifts and other incidentals. The rates including Royality, Malkhana, Octroi, toll tax, sale tax, GST or any other taxes imposed by the Government. |
| 6 | Providing and laying 100mm (one Hundred millimeter) dia ISI marked VECTUS /FINOLAX P.V.C. pipe ( working pressure not less then 4 Kg per sequre cm) Weep Holes in brick masonry/stone masonry plain/ reinforcement concrete abutments, wing wall/ return wall, retaining walls and breast walls, extending through the full width of the structure with slope of 1(V): 20H (One vertical isto twenty Horizontal) towards drawing face complete as per drawing and MORD technical specification clause 614,709,1204.3.7 and as per the direction and entire satisfaction of Engineer-in-Charge complete, including carriage of materials with in all leads, lifts and other incidentals. The rates including Royality, Malkana, Octroi, toll tax, sale tax, GST or any other taxes imposed by the Government. |
| 7 | Providing and laying mechanically mixed and vibrated concrete for plain cement concrete Grade M-10 (M-Ten) nominal mix 1:3:6 (One cement isto three sand isto six graded crushed stone aggregate 20mm (Twenty millimeter) nominal size), in or under water in open foundation for all type of structure and the like etcetera complete including pumping or bailing out water, dewatering (surface/sub soil water)including removal of slush which may arise at time of laying under water for all heights/depths and any quantum of water, including cost of form work and curing complete for 14 (fourteen) days and as per drawing and MORD Technical specification section 800, 900 & 1200 and as per entire satisfaction and directions of Engineer-in-charge, including carriage of materials within all leads, lifts and other incidentals. The rates including Royality, Malkhana, Octroi, toll tax, sales tax or any other taxes imposed by the Government. |
| 8 | Construction of embankment with approved materials deposited at site from roadway cutting and excavation from drain and foundation of other structures graded and compacted to meet requirement including setting out, true to the lines, grades, width and side slopes in accordance with drawing including spreading the embankment material with motor grader in successive layer of in layer 200mm (two hundred millimetre) uniforms thickness and compacting with vibratory roller 8-10 ( eight to ten) tonne static weight to meet requirement of Tables 300.1 and 300.2 as per MORD Technical Specification section 300 & 1600 and as per direction of Engineer-in-charge including carriage of materials within all leads, lifts and other incidentals. The rate is including octroi, royality, Malkana, toll tax, and any other taxes imposed by the Government but excluding GST. Please Enable Macros to View BoQ information |
