|
| 1 | M&L for site clearence in soft / loose soil including cleaning away all grass, vegetation, sapling, shrubs, brushwood, undergrowth, roots and trees not exceeding 30cm girth (measured one meter above ground level) and removing rubbish up to a distance of 50 m outside the periphery complete all as specified and directed. |
| 2 | M&L for moorum/red bajri filling in floors or pavings, laid in layers n exc. 15 cm thick, spread, levelled and rammed including watering complete all as specified and directed. |
| 3 | Rolling and consolidation of formation surfaces in cutting with 8 to 12 tonne power roller complete all as specified and directed. |
| 4 | M&L for boulder pitching and grouted with cement sand mortar 1:6 complete all as specified and directed. |
| 5 | M&L for excavating in post holes (or similar holes) each n exc 0.5 Cum getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm complete all as specified and directed. |
| 6 | M & L for plain cement concrete 1:4:8 type D2 (using 40 mm graded stone aggregate) as in foundation filling and mass concrete complete all as specified and directed. |
| 7 | M&L for hard core of broken stone or boulder, gauge n exc 63mm deposited spread and leveled in layers n exc 15cm thick watered and rammed to a true surfaces complete all as specified and directed. |
| 8 | M&L for precast cement concrete block masonary build with solid block of PCC 1:3:6 type C1 (Using 20mm graded stone aggregate) exceeding 10 cm in width , set in cement mortar 1:6 complete all as specified and directed. |
| 9 | PCC 1:2:4 type B1 (using 20mm graded stone aggregate) as in foundation for post and similar work complete all as specified and directed. |
| 10 | M&L for RCC 1:1.5:3 type A1 (20mm graded aggregates) as in foundation, footing, mass concrete, foundation beam, plinth beam and base for column complete all as specified and directed. |
| 11 | M&L for RCC 1:1.5:3 type A1 (20mm graded aggregates) as in Columns, pillars, piers, posts and struts complete all as specified and directed. |
| 12 | Use & waste for flat formwork to sides of concrete foundations, footings, bases of columns raft and raft beams, sides and soffits if any of foundations and plinth beams and similar work, etc, rough finished surfaces of concrete etc all as specified and directed |
| 13 | Use & waste for flat form work to sides of pillars, posts struts, piers columns and stanchions, square, rectangular or polygonal rough finished surfaces of concrete etc all as specified and directed |
| 14 | S&F TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed. |
| 15 | S&F TMT bars 5 mm to 10mm dia as in stirrups / spacers / binders, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed. |
| 16 | M & L for rendering 15 mm thick cement plastering on wall surfaces in two layers (10mm+5mm each) on fair faces of brick work or concrete surfaces in cement mortar 1:4, mixed with liquid water proofing compound in top layer as per manufacturer's instructions and finished the surface even and fair without using extra cement complete all as specified and directed. (Note : WPC shall be measured and paid separately against respective item). |
| 17 | Supply only liquid water proofing compound complete all as specified and directed. |
| 18 | S & F rolled mild steel hand rails, half round or other steel section or core for wooden hand-rail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concreteand screwing etc. wind ties for roof including securing bolts; posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming toFe-290 Gde E-165 complete all as specified and as directed. |
| 19 | S&F for Framed work such as grills,gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors, ladders; framed balusters; walk ways; railings, framework of water tanks and similar work conforming to Fe.290. Gde-E-165 complete all as specified and directed. |
| 20 | Material & Labour for providing and fixing stainless steel (Grade 304) railing made of hollow tubes, channels, plates etc., including welding, grinding, buffing, polishing and making curvature (where ever required) and fitting the same with necessary stainless steel nuts and bolts complete, including fixing the railing with necessary accessories & stainless steel dash fasteners, stainless steel bolts etc., of required size, on the top of floor or the side of waist slab with suitable arrangement complete all as specified and directed. |
| 21 | M&L for preparation of new steel surfaces of any description, over 10cm in width or girth, not otherwise described and applying two coats of synthetic enamel paint over one coat of red oxide zinc chrom primer, complete all as specified and directed. |
| 22 | S&F mild steel galvanised PVC coated chain link fencing, 3.15 mm nominal dia of GI wire, 1.4 mm thick PVC coating and average area of aperatus 25 sqcm with weight of chain link not less than 3.00 Kg / Sqm complete all as specified and directed. |
| 23 | S&F mild steel round bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed. |
| 24 | S&F of 20 mm outer diameter CPVC pipes SDR 11 & Plain CPVC SDR 11 fittings on walls/ceiling or laying in floors complete all as specified complete all as specified and as directed. |
| 25 | S & F 20 mm dia Gun Metal, globe or Gate Valve with Iron wheel head Screwed both ends for Iron Pipe and fixed complete all complete all as specified and directed. . |
| 26 | Supply, installation, testing and commissioning of pop up spray head, 4\\" (102mm) pop up height, , full circle 360 degree, dual spray pattern nozzle, with 1/2 \\" FNPT inlet, adjustable spray radious 8-15 ft, operating pressure 15-70 psi, UV resistant, plastic body with stainless steel spring, pressure activated wiper seal, ratcheting mechanism for alignment and removable top serviceable internal parts including all accessories, necessary excavation, connection to lateral line, flushing commissioning and making good complete all as specified and directed.(Make: Model No.1804 FDS of Rain Bird / Model No. PROS-04-CV of Hunter / Model No. PRO-S of K-Rain or as approved by GE.) |
| 27 | Supply, installation, testing and commissioning of submersible pump set 3.00 HP, single phase, water cooled, suitable for continious duty operation on 180-240 volts supply having cast iron body, dynamically balanced impeller, stainless steel shaft with bearings, capable of delivering discharge upto 100LPM against head 20-40 m, with and including suitable control panel for off on (DOL starter), submercible power cable ( 2.50 Sqmm flat Three Core PVC Insulated & PVC Sheathed Industrial Cable for Submersible pump Motors 1100 Volt, conforming to IS 694, Minimum length shall be 10 M.) fixing arrangements, electrical connections including making good disturbed surfaces complete all as specified and directed. |
| 28 | Supply, installation, testing and commissioning of central foam jet fountain nozzle, heavy duty, stainless steel / brass, corrosion resistant, 1\\" BSP connection, design to deliver a stable, frothy water column of 2.5-3 m height, operating pressure 1.50 - 3.00 bar, suitable for outdoor decorative fountain in the centre of locations including necessary flow straightner, clamps, piping alignment, connection to pump by all electrical connection including making good disturbed surfaces complete all as specified and directed. |
| 29 | M & L for 75 mm thick PCC 1:4:8, type D2, (using 40mm graded stone aggregate) as in sub- base floor finished the surface fair and rough to receive subsequent layer with and including necessary formwork complete all as specified and as directed. |
| 30 | M & L Machine pressed precast concrete interlocking paver block any shape prepared with grey cement and pigment of size confirming to IS 15658-2006 of 60 mm thick M-35 Grade laid over sand cushioning layer complete all specified and directed. (Note: Sand cushioning shall be measured and paid in relevant item.) |
| 31 | M&L for sand filling under floors or in foundations including watering and consolidation for cushioning complete all as specified and as directed. |
| 32 | M & L for 75 mm thick PCC 1:3:6, type C2, (using 40mm graded stone aggregate) as in base of kerbstone and including necessary formwork complete all as specified and as directed. |
| 33 | M&L Stone kerb of machine pressed rubber moulded precast cement concrete of M-25 grade , using 20mm graded stone aggregate, block of size 45cmX30cmX15cm finished at top bullnosed shape and finished surface even and smooth using coloured pigment and jointed in CM 1:3 struck finished as directed. |
| 34 | S&F 75 mm bore PVC (SWR) pipes single socketed in any length with rubber ring joints laid in trenches complete all as specified and as directed. |
| 35 | M&L for preparing the concrete surfaces of kerb stone applying two coats of synthetic enemel paints in zebra pattern over a coat of primer complete all as specified and as directed. |
| 36 | M&L for 18 to 20 mm thick granite (of any type and colour) tiles machine cut as in floors jointed with grey cement slurry and pointed with white cement with admixture of pigment to match the shade of granite stone including cutting and polishing with and including screed bed or bedding layer of mortar 15 mm thick in Cement Mortar 1:4 complete all as specified and as directed.(Note: The colour / shade / design of granite shall be as approved by GE(I).) |
| 37 | M&L for preparing new plastered surfaces of walls and applying Two or more coats of 100% Premium acrylic exterior emulsion paint having VOC less than 50 m/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/ 10 sqm over and including one priming coat of exterior primer applied @ 0.90 litre/ 10 sqm over new surfaces as ecommended by the manufacturer all as specified and as directed (Note : Rate shall be included for necessary scaffolding and safety measures where required at site ). |
| 38 | Supply and laying of pea gravel of 10mm size as in children play area complete all as specified and directed. (Loose volume shall be measured for payment purpose) |
| 39 | Supply, plantation and developing of carpet Grass including necessary earthwork and excavation to achieve a depth of 30 cm in any type of soil, removing the roots and vegetation and filling of the excavated area with good earth (red soil) mixing with cow dung and vermi compost and watering etc and applying soil pesticide complete all as specified.Notes: (i)Layout plan for lawn/plants/hedges/grass shall be submitted and get its approval from GE (I) before the execution of respective items.(ii) Cost of manure, good soil, pesticides etc. shall be measured and paid separately under relevant items. |
| 40 | Supply and plantation of Royal palm (height of plant not less than 10 feet above ground level) incl preparation of ground up to 30cm deep and filling of good earth, cow dung vermi compost and watering etc. complete all as directed by the Engineer-in-charge.Note: (i)Layout plan for lawn/plants/hedges/grass shall be submitted and get its approval from GE (I) before the execution of respective items.(ii) Cost of manure, good soil, pesticides etc. shall be measured and paid separately under relevant items. |
| 41 | Supply and plantation of Temple Tree (height of plant not less than 10 feet above ground level) incl preparation of ground up to 30cm deep and filling of good earth, cow dung vermi compost and watering etc. complete all as directed by the Engineer-in-charge.Note: (i)Layout plan for lawn/plants/hedges/grass shall be submitted and get its approval from GE (I) before the execution of respective items.(ii) Cost of manure, good soil, pesticides etc. shall be measured and paid separately under relevant items. |
| 42 | Supply and laying approved best quality red soil (without moorum content) and having suitable pH and EC as recommended for saline water condition and manure such as vermi-compost, polydol dust, neem cake and organic manure etc in the ratio 3:1 (3 part of soil and 1 part of manure) complete all as specified and directed.(Note: (i) Red soil should be well seived 90% to pass through IS seive of 10mm size, free from stone rubbish like lumps, stones and other foreign materials suitable for gardening. The soil shall be free from quarry. The colour of soil shall generally be reddish as directed.(ii) Manure shall be well decayed, well dried, well powdered , without cladds and free from stones, dried grass and rubbish materials.The colour of manure shall be black and shall be screened at site using IS designation 4.75 seive.(iii) The soil shall be stacked neatly on level ground.(iv) Before execution of soil filling , level sheet of existing ground shall be submitted to GE(I). The quantity of soil shall be calculated based on initial ground level and final ground level taken at site and applying symsons rule. void 10% shall be deducted for compaction.) |
| 43 | (Note for Serial item No. 39, 40 & 41: During defect liability period contractor shall look after the plants / tree by deputing one malli , who will watering the plants / tree, provide manure if requirred , loosing the earth near root of tree as requirred without any extra cost to the Govt.) Please Enable Macros to View BoQ information |
