|
| 1 | Clearing grass and removal of rubbish up to a distance of 50 metres outside the periphery of the area as per Technical specificationS.O.R. Item No. 2.02 |
| 2 | Clearing and Grubbing Road Land (Clearing and grubbing road land including uprooting rank vegetation, grass, bushes, shrubs, saplings and trees girth up to 300 mm, removal of stumps of trees cut earlier and disposal of unserviceable materials and stacking of serviceable material to be used or auctioned up to a lead of 1000 metres including removal and disposal of top organic soil not exceeding 150 mm in thickness.)By Manual means with In area of light jungleS.O.R. Item No. 2.03 (i) A |
| 3 | Construction of sub-grade and earthen shoulders with approved material obtained from Borrow pits with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacting to meet requirement of Table 300-2.S.O.R. Item No. 3.18 |
| 4 | Granular Sub Base with Grading-ll Material(By Mix in Place Method) Construction of granular sub-base by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with smooth wheel roller to achieve the desired density, complete as per Technical Specification Clause 401.(By Mix In Place Method)With Grading-Il MaterialS.O.R. Item No. 4.01 B (ii) |
| 5 | Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days,using curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501S.O.R. Item No. 6.02 |
| 6 | E/W in excavation for foundation per drawing and technical specification including setting out, construction of shoring and brading, removal of stumps and other deleterious material dressing dressing of sides and bottom backfilling in wih approved material. S.O.R. Item No. 3.13 (I) A |
| 7 | Plain/Reinforced cement concrete in open foundation complete as per drawing and Technical Specifications(P.C.C. Grade M-15)S.O.R. Item No. 11.4 (II) (i) |
| 8 | Stone masonry work in cement mortar in foundation complete as per drawing and technical specifications Clauses 702, 704, 1202 & 1203.Random Rubble Masonary in C.M. (1:3) in foundationS.O.R. Item No. 11.6 (III) (ii) |
| 9 | Stone masonry work in cement mortar in sub-structure complete as per drawing and technical specifications Clauses 702, 704, 1202 & 1203.Random Rubble Masonry Work in Cement Mortar 1:3 in S/SS.O.R. Item No. 12.4 (III) (ii) |
| 10 | Plain/Reinforced Cement Concrete on Top of Wall complete as per Drawing and Technical Specifications.(P.C.C. Grade M-15)S.O.R. Item No. 12.5 (I) (i) |
| 11 | Providing weep holes with day grades stone filter of 53 mm to 22.4 mm size in abutment and wing wall all complete job as per specification and direction of E/I.S.O.R. Item No. 13.1 (II) |
| 12 | Pointing with cement mortar (1:3) on brick or stone masonary work as per drawing and technical specification Clauses 613.3 and 1204S.O.R. Item No. 12.2 |
| 13 | E/W in excavation for structure as per drawing and technical specification clause 305.1 including setting out, construction of shoring and brading, removal of stumps and other deleterious material and disposal utp a lead of 50m, dressing of sides and bottom backfilling in trenches with excavated suitable material.Ordinary Soil Mechenical Means SOR Item No. 3.13 (i)B |
| 14 | Providing and laying boulders pitching for protection against scour with stone boulders weighing not less than 40 kg each complete as per drawing and Technical specification.S.O.R. Item No. 16.09 |
| 15 | Plain/Reinforced cement concrete in open foundation complete as per drawing and Technical Specifications(P.C.C. Grade M-15)S.O.R. Item No. 12.08 A Case ll |
| 16 | Stone masonry work in cement mortar 1:3 for substructure complete as per drawing and Technical SpecificationsSqure Rubble Coarse Rubble Masonry (First Sort) Work in CM 1:3 in foundationS.O.R. Item No. 12.07 A |
| 17 | Stone masonry work in cement mortar 1:3 for substructure complete as per drawing and Technical SpecificationsCoursed Rubble Masonary in C.M. (1:3) in (First sort) sub-structureS.O.R. Item No. 13.04 B |
| 18 | Stone masonry work in cement mortar in sub-structure complete as per drawing and technical specifications Clauses 702, 704, 1202 & 1203.Coarse Rubble Masonry Work in Cement Mortar 1:5 in sub-structureS.O.R. Item No. 12.4 (II) (iii) |
| 19 | Stone masonry work in cement mortar in sub-structure complete as per drawing and technical specifications Clauses 702, 704, 1202 & 1203.Random Rubble Masonary in C.M. (1:4) in sub-structureS.O.R. Item No. 12.4 (III) (ii) |
| 20 | Stone masonry work in cement mortar in superstructure complete as per drawing and technical specifications Clauses 702, 704, 1202 & 1203.Random Rubble Masonary in C.M. (1:3) in superstructureS.O.R. Item No. 13.17 (I) |
| 21 | Plain/Reinforced cement concrete in sub-structure complete as per drawing and Technical Specifications(P.C.C. Grade M-15)S.O.R. Item No. 13.05 A (p) |
| 22 | Plain/Reinforced cement concrete in sub-structure complete as per drawing and Technical Specifications(P.C.C. Grade M-20)S.O.R. Item No. 13.05 B (p) |
| 23 | Furnishing and Placing Reinforced/ Prestressed cement concrete in super-structure as per drawing and Technical Specification(P.C.C. Grade M-25 in Deck Slab)S.O.R. Item No. 13.5 F (p) |
| 24 | Providing and laying Cement Concrete Wearing Coat M-30 grade including reinforcement complete as per drawing and Technical SpecificationsS.O.R. Item No. 14.04 |
| 25 | Supplying, fitting and placing HYSD bar reinforcement in super-structure complete as per drawing and technical specificationsS.O.R. Item No. 13.06 |
| 26 | Plastering with cement mortar (1:3) on brick or stone masonary work as per drawing and technical specification Clauses 613.3 and 1204S.O.R. Item No. 13.03 |
| 27 | Providing weep holes with day grades stone filter of 53 mm to 22.4 mm size in abutment and wing wall all complete job as per specification and direction of E/I.S.O.R. Item No. 13.08 |
| 28 | Backfilling behind abutment,wing wall and return wall with sandy material complete as per drawing and technical specification SOR Item no.13.09 B |
| 29 | Add G.S.T ( Goods & Service Tax ) |
| 30 | Add Labour Cess Please Enable Macros to View BoQ information |
