|
| 1 | Earthwork in excavation by mechanical means (Hydraulic excavator)/manual means in foundation trenches or drains ( not exceeding 1.5 m in width or 10 Sq. m on plan), including dressing of sides & remaining of bottoms , lift upto 1.5 m , including getting out the excavated soil and disposal of surplus excavated soil as directed , within a lead of 50 m |
| 2 | All kinds of soil. |
| 3 | Providing and laying in position cement concrete of specified grade excluding the cost of centring and shuttering. All work upto plinth level. |
| 4 | 1:5:10 (1 cement : 5 fine sand : 10 graded stone aggregate 40 mm nominal size) |
| 5 | 1:3:6 (1 Cement : 3 coarse sand(zone-III) : 6 graded stone aggregate 20 mm nominal size). |
| 6 | Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement. All works upto plinth level |
| 7 | 1:1½:3 (1 cement : 1½ coarse sand (Zone-III) : 3 graded stone aggregate 20 mm nominal size) |
| 8 | Centring and shuttering including strutting, propping etc. and removal of form for |
| 9 | Foundations, footings, bases of columns etc. for mass concrete. |
| 10 | Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete up to plinth level. |
| 11 | Cold twisted/TMT bars |
| 12 | Brick work with common burnt clay (non-modular) bricks of class designation 7.5(at all levels) including curing in: |
| 13 | Cement mortar 1:6 ( 1 cement : 6 coarse sand) |
| 14 | Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting , hoisting , fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete. |
| 15 | Hot finished welded type tubes |
| 16 | Structural steel work welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete. |
| 17 | Providing and fixing precoated galvanized iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. |
| 18 | 12 mm cement plaster of mix : |
| 19 | 1:6 (1 cement: 6 fine sand) |
| 20 | Finishing walls with Acrylic exterior paint of required shade: |
| 21 | New work (Two or more coats applied over and includign priming coat of exterior primer applied @2.20 kg/10 sqm) |
| 22 | Painting with synthetic enamel paint of approved brand and manufacture to give an even shade. |
| 23 | Two or more coats on new work Please Enable Macros to View BoQ information |
