|
| 1 | Clearing grass and removal of rubbish up to a distance of 50 metres outside the periphery of the area . |
| 2 | Supplying and erecting minimum Three & above star rated 3 phase, 415 V, 50 Hz, submersible pump set of 7.5 KW/10HP suitable for erection on openwell, pump having delivery head from 72 to 28 m and discharge from 120 to 840 litres. per minute & pipe of Suction 65 mm/Delivery 50 mm diametererected with necessary H type clamps as per specification No. WP-OSP |
| 3 | Excavationfor foundation/pipe trenches in earth,soils of all types,sand,grave land soft murum, including removing the excavated material up to a distance of 50 metres and lifts as below, stacking and spreading asdirected, normal dewatering, preparing the bed for foundation and excludingbackfilling, etc. complete. (Bd-A1/259) |
| 4 | Excavationfor foundation/pipe trenches in hard murum including removing the excavated materialup to a distanceof50M and lifts as below, stacking and spreading asdirected by Engineer-in-charge, normal dewatering, preparing the bed for foundation and excluding backfilling, etc. complete.(Bd-A-2/259) |
| 5 | Providing and supplying in standard lengths High Density Polyethelene Pipes,confirming to IS4984/14151 / 12786 / 13488 with nesessary jointing material like mechanical connector i.e.thread/ insert joint/ quick release coupler joint / compression fitting joint or flanged joint excluding coupler/specials, including transportation and freight charges, inspection charges, loading / unloadingcharges, conveyance to the departmental stores&stacking thesame in closed shade duly protecting from sunrays & rains, excluding GST levied by GI & GO Minall respect etc.complete. |
| 6 | Lowering,Laying and JointingH.D.P.E./ M.D.P.E.pipes inproperpositionincludingall specialsbycompression fitting/electrofusionand butt fusion jointingprocedureasper relevent IS Code complete with all materials for jointing procedure like Electrofusion machine, Electric heater/butt fusionweldingmachinewithhydraulic jack, top loadingclampetc. andall labours as directedbyengineer inchargeasperIS-7634Part II |
| 7 | Hydraulic testing of H.D.P.E./M.D.P.E.pipe line to specified pressure including cost of all materials and labour andwater for testing for specified length including cutting,placing end cap making arrangement for filling safe water using reciprocating type pumps which should be able to provide specified test pressure gauges and other necessary equipments, labour,operation charges, etc. requiredfor testing.The rate under this item shall also include cost of retesting, if necessary andreinstatingtooriginalposition.. |
| 8 | Hiring of JCB for Excavation & for clearing site of lekages & making approach to leakage site & For making water way towards intakewell, in summer & dismentalling chairs and excavation for underground pipeline and for other misc work as directed by engineer-in-charge. |
| 9 | Excavation for pipe trenches in WBM Road..etc comp |
| 10 | Excavation for pipe trenches in asphalt Road..etc comp |
| 11 | Providing murum bedding below pipeline and filling on the top of the pipeline with selected material in 15 to 20 cm layers including watering, ramming etc. complete. |
| 12 | Supply of various unskilled labours for works directed as Engineer-In-charge. |
| 13 | Supply of CI Mechanical joint All Socket Tees as dimensionally described inTable-18of IS-13382/1992completewithsealing rubber gasket of S.B.R.(dimensionallydescribedinIS-12820/1989) with cast iron follower glandandmild steel nut bolts coated or otherwise protected from rusting and suitable for C.I.pipes. |
| 14 | Cutting and champhering of pipes of following diameters including cost of all materialsandlabourinvolved,etc.completeas directedbyEngineer-in-charge(forallclassof pipes) |
| 15 | Providing and supplying Air Valves as per IS14845 and MJP’s standard specifications double orifice type combined with screwdown isolating valve,small orifice elasticball resting on a gunmetal orifice nipple, large orifice vulcaniteball seating on moulded seat ring, inlet face and drilled, including insurance, third party inspection charges, loading, unloading, transportation upto departmental stores, excludingGST leviedbyGOI&GOMinall respectetc.complete. |
| 16 | Providing and fixing collapsible steel gate in one / two leaves with hot rolled vertical channels of 18 x 9 x 3 mm minimum size, crossings of M.S. flats of size 18 x 5 mm T orLowering, laying and fixing in proper alignment andpositionall types of C.I. air valves as directed by Engineer-in-charge includingcost of conveyance fromstores to siteofwork, cost of allmaterial andgiving satisfactoryhydraulic testing, etc. complete. (for all class of valves). |
| 17 | 300 mm @ ESR (outlet & Inlet sluice valve) |
| 18 | 150 mm @ RWRM |
| 19 | Providing and erecting Y type barbed wire fencing with seven rows of wire with 2.45 mmdia G.I. pipe ( Rezan/ concentiDeleted ire 0.75 mm dia ) with hot dip and G.I. coatedhooks as per drawing supported on M.S. angle 50 x 50 x 6 mm at 2.5 mtr. c/cincluding fixing and fastening with wire, painting M.S. angles with one coat of red leadprimer and two coat of oil paint etc. complete.As directed by Engineer in charge.One Running Metre917 1761296 Iron Work 40.06 BDW Providing and fixing 40mm diameter and 1.5 |
| 20 | Providing and erecting chain link fencing 1.6 M. height with G.I. chain link of size 50 x50 mm, 8 gauge thick and fixed 75 mm above ground level on vertical M.S. Angles of 40x 40 x 6 mm size, includind excavating pits for foundation and embedded in C.C. block of1:4:8 mix of size 450 x 450 x 670 mm. at 1.75 M. c/c with iron bar 16mm dia as hold fastincluding welding link with angle frame at 30 cm c/c with nuts and bolts and horizontalM.S. Angles at top and bottom of 25 x 25 x 5 mm size and vertical M.S. flat 35 x 5 mmand 25 x 5 mm horizontal including cross support of 40 x 40 x 6 mm angles both side atevery corner or bend embedded in concrete blocks of 1:4:8 of size 450 x 450 x 670 mmincluding 3 coats of oil painting etc. complete. |
| 21 | 300 mm @ ESR (outlet & Inlet sluice valve) |
| 22 | 150 mm @ ESR (outlet & Inlet sluice valve) |
| 23 | Supplying & erecting automatic control panel for 3 Ph, 415 volt, A.C. Submersible/centrifugal pump set up to 7.5 HP- 10 H.P. consisting of DOL starter having relay range 13-21 AMP,S.P.P., Combined ammeter/voltmeter, phase indicating lamp enclosed in CRCA powder coated Vibration proof enclosure with IP 54 protection. Control Panel should offer single phasing, phase reversal, phase imbalance etc. |
| 24 | Supplying & erecting D.O.L Starter suitable for 415 V, 3 phase 50 cycles with no volt coil and overload element with necessary materials and connected to supply for 10 H.P. |
| 25 | Supplying and erecting flat flexible 3 core 4 sq mm PVC sheathed submersible type copper cable suitably clamped at fixed intervals with column pipe assembly complete |
| 26 | Supplying and erecting SI mark GI pipe 50 mm dia.‘B’ class at position with accessories complete.Specification no. CW-PLB/GP |
| 27 | Supplying and erecting 50 mm dia. gun metal sluice valve at position with necessary materials complete. |
| 28 | upplying and erecting non return valve 50 mm dia in position made of gun metal complete. |
| 29 | Supplying and erecting CI flange 50 mm.dia with necessary nuts bolts andwashers with rubber seal in position complete |
| 30 | Supplying and erecting CI flange 75/80 mm. dia with necessary nuts bolts and washers with rubber seal in position complete |
| 31 | Supplying and erecting 0-100 lb/sq. inch pressure gauge having 4\\" dia complete with socket for 1/2\\" GI pipe complete |
| 32 | Providing earthing with galvanized iron earth plate size 60 x 60 x 0.6 cm with funnel with a wire mesh for watering and brick masonry block C.l. cover complete with all materials, testing & recording the results as per specification no. EA-EP |
| 33 | Supplying and erecting copper strip of high purity required size used for earthing on wall and/or any other purpose with necessary copper clamps fixed on wall painted with bituminous paint with joints required. As per specification no. EAEP. |
| 34 | Supplying & erecting conventional spike type air termination suitable to carry lightning stroke made up of heavy gauge 40 mm diacopper pipe of standard length with 5 Nos. copper spikes fixed on copper ball asair terminals duly threaded in copper pipe erected on provided foundation in anapproved manner. |
| 35 | Supplying, erecting & terminating FR XLPE insulated, galvanised steel formed wire armoured (strip) cable 1100 V, 4 core 16 sq. mm. aluminium conductor complete erected with glands & lugs, on wall/ trusses/pole or laid in provided trench/ pipe as per specification no. CB-LT/AL |
| 36 | Making cement concrete foundation in 1:3:6 cement concrete, (20 to 25) mm. stone metal duly plastered with necessary curing for complete. (pole muffing or any other purpose). |
| 37 | Supplying and laying (including excavation of suitable width & depth up to 90 cm) 50 mm outside dia. double wall corrugated pipes(DWC) of HDPE for enclosing cable below ground/road surface, to required depthcomplete |
| 38 | Supplying, erecting & marking FPMCB 40A to 63A, with rated short - circuit breaking capacity (Icn) 10kA in provided distribution board as per specification no. SW-SWR/MCB |
| 39 | Supplying & erecting triple pole and neutral distribution board (TPNDB), SP/TP MCBs total 4 ways /12 Poles, with door, 1.2mm thickness surface/flush mounted, IP 43 Protection on iron/GI frame (vertical busbar type) as per specification no. SW-SWR/MCBDB |
| 40 | Supplying and erecting 525 V 3 phase, 50 Hz., MPP type capacitor kVAr having minimum overcurrent capacity of 1.8 In, peak inrush current capacity 300 In and minimum life 150000 hours kVAr bank of all polypropylene condensers (APP) with the standard capacities of 2, 3, 5, 7, 10, 12.5 and 15 kVAr units of P.F. correction for operationon 3 phase 50 Hz. with externally discharging resistances, earthing terminals and built on angle iron or channel iron frame work and provided with terminal cover boxcomplete erected on provided iron bracket or on floor duly tested by licensee. |
| 41 | Supplying and erecting PVC insulated PVC round sheathed 4 sq.mm (56 no. x 0.30 mm dia.) 3 core flexible multi stranded copper Industrial cable for voltage grade up to 1.1 kV |
| 42 | Submersible openwell pump floater for floating purpose for 10Hp-12Hp wuth GI pipe etc complete |
| 43 | Supply, install and commission Electromagnetic Flow Meter (EMF) As Per ISO 4064, forRaw/Pure water with accuracy +/- 0.5% of measured value & protection as per givenspecifications for size 100 mm1000mm including sensor, transmitter surge arrestor, cableGI duct if suitable size for 25 mtrs built in GSM/GPRS ( with Simcard and its charges,valid for 36 months) including the pipecutting, leveling and installation of flow meter in the pipelines with necessary tool tackles,cranes including 36 monthsguarantee etc complete, as may be required at site & based on technical specifications. Please Enable Macros to View BoQ information |
