|
| 1 | Clearing Jungle including up rooting of trunk vegetation grass bush wood trees and sapling of girth upto 30cm. Measured at a hight of 1 meter above ground level and removal of rubbing upto a distance of 50m. Outside the prepheri of area cleared as per PWD-231 |
| 2 | E/work in excavation by mechanical means (hydraulic excavator ) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan ), i/c dressing of sides and ramming of bottoms, for all lift including getting out the excavated soil and disposal of surplus excavated soil as directed , within a lead of 50 m as per DSR No 2.8.1 |
| 3 | Treatment of soil under existing floors using chemical emulsion @ one litre per hole, 300mm apart i/c drilling 12mm diameter holes and plugging with cement mortar 1:2 (1 cement: 2 coarse sand) to match the existing floor with Chlorpyriphos/Lindane E.C. 20% with 1% concentration. as per PWD-2.35.3 |
| 4 | Sand filling in plinth under floor including watering and ramming and also including lift up to 1.50m and lead 50 m as per PWD-2.27 |
| 5 | Providing and Laying of cement concrete in 1:4:8 with cement,coarse sand and 40 mm stone ballast including supply of all the materials, labour and T & P etc. all complete as per D.S.R. No.-4.1.8 |
| 6 | Earth work in embankment in the ordinary soil excavation to be done from the regular pits 20 cm. layers including ramming and dressing pulverzation surface to the required levels and slope directed by E/I including proper completion of the work as per D.S.R. No.-2.25 (a) supply of roller and required for the proper completion of the work as per D.S.R. No.-2.25 (a) |
| 7 | Brick work with common burnt clay F.P.S (non modular ) bricks designation 7.5 in foundation and plinth in 1:6 ( cement :6 c/sand) as per D.S.R No 6.1.2 |
| 8 | R.C.C. work in 1:1.5:3 with cement, coarse sand and 20 mm stone grit in slab including supply of all the materials, labour and T & P etc. all complete as per D.S.R. No.-5.3 |
| 9 | Class-150 brick work in 1:6 with cement and coarse sand mortar in super structure and including supply of all the materials, labour and T & P etc. all complete as per D.S.R. No.-6.4.2 |
| 10 | Fabrication of M.S. grills with frame for the Window and Ventilators and including supply of all the materials, labour and T & P etc. all complete as per D.S.R. No.-10.25.1 |
| 11 | RCC work in 1:2:4 ( 1cement :2 coarse sand :4 graded stone aggregate 20 mm nominal size excluding the cost of centering , shuttering as per D.S.R No 5.1.3 |
| 12 | Mild Steel or Iron Work for reinforcement in R.C.C. work including supply of all the materials, labour and T & P etc. all complete as per D.S.R. No.-5.22.1 |
| 13 | 12 mm thick plaster in 1:4 with cement and coarse sand mortarincluding supply of all the materials, labour and T & P etc. all complete as per D.S.R. No.-13.4.1 |
| 14 | Providing and Laying Vitrified Floor Tiles in different sizes (thickness to be specified by manufacture) with the water absorption less than 0.08% and also confirming to the IS:15622 of approved brand and manufacture in all colours and shades in the skirting, risers of steps, laid with cement based high polymer modified quick set tile adhesive (water based) and confirming to IS:15477 in average 6 mm thickness including grouting of the joints including supply of all the materials,labour and T & P etc. all complete as per D.S.R. No.-11.47.2 |
| 15 | Making of Base with Two Coat Birla Putty on the smooth surface and including supply of all materials, labour and T & P etc. all complete as per D.S.R. No.-13.80 |
| 16 | One Priming Coat and Two Coat of Oil Bound Distemper on the new work including supply of all the materials, labour and T & P etc. all complete as per D.S.R. No.-13.83.2 |
| 17 | Painting or Varnishing on New Iron Work or Wooden Work in smallareas with two coat of the ready mixed priming paint and one coat of approved superior quality including supply of all the materials, labour as per D.S.R No |
| 18 | Centering and Shuttering including strutting, proping etc. and removal of form for Suspended , floors, roof, landing , balconies and platform as per D.S.R No 5.9.3 |
| 19 | Centering and Shuttering including strutting, proping etc. and removal of form for Lintle , beams , plinth beams ,girders, bressumers and cantilevers as per D.S.R5.9.5 |
| 20 | P/L in position cement concrete of specified grade excluding the cost of centering and shuttering in 1:1.5:3 cement , c/sand and 20 mm gause stone aggregate as per D.S.R No 4.1.2 |
| 21 | Providing and fixing water closet squatting pan (Indian type W.C. pan ) with 100 mm sand cast Iron P or S trap, 10 litre low level white P.V.C. flushing cistern, including flush pipe, with manually controlled device (handle lever) conforming to IS : 7231, with all fittings and fixtures complete, including cutting and making good the walls and floors wherever required: White Vitreous china Orissa pattern W.C. pan of size 580x440 mm with integral type foot rests D.S.R. 17.1.1 |
| 22 | Providing and fixing white vitreous china flat back or wall corner type lipped front urinal basin of 430x260x350 mm or 340x410x265 mm sizes respectively.D.S.R. 17.23 |
| 23 | White Vitreous China Wash basin size 630x450 mm with a single 15 mm C.P. brass pillar tap:D.S.R. 17.7.2 |
| 24 | Providing and fixing P.V.C. waste pipe for sink or wash basin including P.V.C. waste fittings complete. D.S.R. 17.28.2.2 |
| 25 | Providing and fixing uplasticised PVC connection pipe with brass unions : D.S.R. 18.21.1.1 |
| 26 | Providing and fixing C.P. brass long nose bib cock of approved quality conforming to IS standards and weighing not less than 810 gms. D.S.R. 18.51.1 |
| 27 | Providing and fixing C.P. brass stop cock (concealed) of standard design and of approved make conforming to IS:8931. D.S.R. 18.52.1 |
| 28 | Providing and fixing C.P. brass angle valve for basin mixer and geyser points of approved quality conforming to IS:8931 15 mm nominal bore D.S.R. 18.53.1 |
| 29 | Providing and placing on terrace (at all floor levels) polyethylene water storage tank, IS : 12701 marked, with cover and suitable locking arrangement and making necessary holes for inlet, outlet and overflow pipes but without fittings and the base support for tank.D.S.R. 18.48 |
| 30 | Providing and fixing C.P. brass shower rose with 15 or 20 mm inlet :D.S.R. 18.22.2 |
| 31 | Providing and fixing mirror of superior glass (of approved quality) and of required shape and size with plastic moulded frame of approved make and shade with 6 mm thick hard board backing :D.S.R. 17.32.2 |
| 32 | Providing and fixing PTMT towel rail complete with brackets fixed to wooden cleats with CP brass screws with concealed fittings arrangement of approved quality and colour.:D.S.R. 17.73.1 |
| 33 | Providing and fixing Chlorinated Polyvinyl Chloride (CPVC) pipes, having thermal stability for hot & cold water supply and all CPVC plain & brass threaded fittings, including fixing the pipe with clamps at 1.00 m spacing. This includes jointing of pipes & fittings with one step CPVC solvent cement and testing of joints complete as per direction of Engineer in Charge.20 mm nominal dia Pipes .D.S.R. 18.7.2 |
| 34 | Providing and fixing on wall face unplasticised Rigid PVC rain water pipes conforming to IS : 13592 Type A, including jointing with seal ring conforming to IS : 5382, leaving 10 mm gap for thermal expansion, (i) Single socketed pipes.110MM Dia Metar.D.S.R. 12.41.2 |
| 35 | S/F 110mm Dia Waste Jali with all comp. |
| 36 | Wiring for light point/ fan point/ exhaust fan point/ call bell point with.1.5 sq.mm FRLS PVC insulated copper conductor single core cable in surface / recessed steel conduit, with piano type switch, phenolic laminated sheet, suitable size MS box and earthing the point with 1.5 sq.mm FRLS PVC insulated copper conductor single core cable etc. as required. D.S.R. 1.1.1 Group A |
| 37 | Wiring for light/ power plug with 2X4 sq. mm FRLS PVC insulated copper conductor single core cable in surface/ recessed steel conduit alongwith 1 No. 4 sq. mm FRLS PVC insulated copper conductor single core cable for loop earthing as required. D.S.R. 1.5 |
| 38 | Wiring point for plug with 1.5 sq. mm.PVC conduit with 1.5 sq. mm.FRLSH PVC insulated multistrand copper conductor cable as earthwire drawn inside the conduit concealed in the wall, complete with 14 SWG copper earth continuity wire,GP Box , piano type switch and socket etc. complete in all respect including matching colour wash. 134 C |
| 39 | Providing and fixing switch box with all comp.as per S.I.No.164 |
| 40 | S/F of LED bulb of approved make 9 to12 watt complete in all respect. |
| 41 | Supply& Laying of aluminuim conductor cable PVC insulated armoured served sheathed cable 1100 volts all wall surface as dircted by Engineer in charge all complete of work for 10 sqmm 2 core as per S.I. No.20c.1.2 22.0x0.8475=186.45 |
| 42 | S/F Sign Board Lettring&Painting ,Branding etc. |
| 43 | Cartage of handpump machine 110/63 mm pvc pipe strainer &all fitting &materials of plae form at site |
| 44 | REQUIRED MATERIALS FOR HAND PUMP 110mm pvc pipe 6 kg/cm2 |
| 45 | REQUIRED MATERIALS FOR HAND PUMP 63mm pvc pipe 6 kg/cm2 |
| 46 | REQUIRED MATERIALS FOR HAND PUMP 63mm pvc str. Blind pipe (3.00+1.00=4 M) |
| 47 | REQUIRED MATERIALS FOR HAND PUMP 110mm x 63 mm reducer |
| 48 | Drilling by pom &pressure method & T&P |
| 49 | Digging of pit,tripod etc 150 mm dia 0.00-15.00M |
| 50 | Digging of pit,tripod etc 150 mm dia 15.00-30.00M |
| 51 | Digging of pit,tripod etc 150 mm dia 30.00-45.00M |
| 52 | Lowering of materials i.e 110/63 mm pipe & str. Pipe 0.00-30.00M |
| 53 | Supply of coarse sand & pouring around str pipe |
| 54 | Bentonite poder |
| 55 | Devlopment as per rule |
| 56 | P/F of Submersible Pump of approved make with 1 H.P. oil field I.S.I Marked i/c with starter and 30mtr.cable capacity |
| 57 | Water testing |
| 58 | Add 18% GST Please Enable Macros to View BoQ information |
