|
| 1 | Demolition of Un-reinforced cement concrete of any description and in any position not otherwise specifically provided, complete all as specified and as directed. |
| 2 | M&L for Providing cement concrete type B1 1:2:4 using 20mm graded stone aggregate as in Bed Block ,Coping and like works, complete all as specified and as directed. |
| 3 | M&L for Use & waste of form work to sides of pillars, posts and columns for fair finished surface, complete all as specified and as directed. |
| 4 | S & F for Mild steel work as in posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165, complete all as specified and as directed. |
| 5 | S & F Galvinised, 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails including securing or tying with and provision of galvinised MS wire staples or steel pins etc, complete all as specified and as directed. |
| 6 | M&L for two coats of synthetic enamel paint over one coat of red oxide exc 10cm width or girth on newly prepared steel surfaces, complete all as specified and as directed. |
| 7 | S&F Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws, complete all as specified and as directed. |
| 8 | S&F galvanised concertina coil of 750mm dia made of 0.5mm thick 19mm wide strip and 2.59mm dia high tensile wire 1.25 Nos of clips, having 56 Nos of circle and covering 8 to 10 running meter and 'S' clips per spiral using a central core of high tensile wire around which a tape of razor sharp bars is machine crimned etc, complete all as specified and as directed. |
| 9 | M&L for providing precast cement concrete type B-1, 1:2:4 (20mm graded aggregate) and set in cement mortar 1:6 in landings, cover slabs (for manholes/ drain cover) etc, complete all as specified and as directed. |
| 10 | M&L TMT bars 10mm dia and over cut to length, bend to shape required including cranking, bending spirally for hookings for cols, hooking ends and binding with and including mild steel wire (aneeled) not less than 0.9mm dia, complete all as specified and as directed. Please Enable Macros to View BoQ information |
