|
| 1 | Supply and fixing of wooden Table with best quality of country plywood top finishing with best quality MICA including all cost and convenyance at materials to site and all labours charges etc., complete. |
| 2 | Supply and Delivery of Executive chair best Quality with Cusion, back rest & Hand holder including all cost and conveyance of materials and all labour charges etc., complete. |
| 3 | Model 1 |
| 4 | Model 2 |
| 5 | Removing and Refixing in position of Alu. Anodised Partition with 62x38x2mm extruded box section at bottom vertical and horizontal members. The vertical member are spaced at 90 cm c/c and to horizontal members are spaced at 1.2M, 2.1M and 2.4M height the bottom panels should be covered with 12 mm thick PLB exterior grade and the top and middle panels should be fixed at 4mm thick glass thick glass with necessary glassing clips.rubber beading, etc., including necessary dismantling holes in RCC columns, beams masonry wherever necessary with power power drill ti the extent required and made good to the original conditions after fixing as directed by the departmental officers. All the Aluminium sections should be anodised to 1.5microns as per ISI specification 1868/1962. |
| 6 | Removing & Refixing in position of Alumi.Anod.natural colour matt finish door half glazed and half PLB board using 12 mm thick PLB board and 5.5 mm thick glazed door using rectangular Alu.Box section of following sizes for frame and shutter with necessary accessories such as rubber beading, Al. Clips, Best double action floor springs, Aluminium Handles on both sides,floor stopper,Tower bolt, Locks and glass including all materials, Labour, power consemption charges required for fabrication if necessary chipping, dismantling making necessary holes in RCC Coloums, Beams or Masonry wherever necessary with power drill to the extent required and made good to the original conditions after fixing etc.,complete. The Alumi. surface must be anodised with matt finish under electrically controlled condition in accordance with IS specification 1868 / 1962 of Anodic filthickness of not less than 15 Microns (Fifteen) for all sections. |
| 7 | Provision for Repair and refixing of Existing AC, Gas filling, Wash water output & Replacement of Motor including all cost of labour charges materials etc complete. |
| 8 | Supply and fixing of wall mounding fan 400mm sweep including all cost and conveyance of materials and all labour charges etc., complete. |
| 9 | Supply and fixing of 20W LED Tube Light for T8 Fitting (Single Side) |
| 10 | Wiring with 2x1.5sqmm PVC unsheated SC.alu.cable of 1100V grade with sutable PVC riged pipe Concealed on wall and ceiling with accessories and in flush with wall with 150mm X 100mm x113mm TW switch box and 5A F.T Switch in flush withwall 3mm thick hylum sheet cover for making good of the Concealed portion with painting of sutable colour and continues earthwire connection of 14 SWG TC wire for Concealed PVC Plug Point (SD 38) |
| 11 | Supply and fixing of 1200mm (48\\") sweep AC ceiling fan complete with stepped electronic 300W regulator with 1 metre down rod with fan clamp with side plates and cross arm of size 450mm (18\\") (SD 106) |
| 12 | Provision for Loading, Unloading, transportation charges for Furnishing materials (Table, desk, chair, Berow, Rack etc) including all cost of conveyanance of materials and all labour charges etc., complete. 25mm 3way Ball Valve Please Enable Macros to View BoQ information |
