|
| 1 | Construction of Embankment with Material Obtained from Borrow Pits. |
| 2 | providing and laying of 350 mm NP3 pipe as per direction of engineer-in-charge. |
| 3 | Providing, laying, spreading and compacting stone aggregates of specific sizes 45-63 mm to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with three wheel 80-100 kN static roller in stages to proper grad |
| 4 | Providing, laying, spreading and compacting stone aggregates of specific sizes22.4-53mm to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with three wheel 80-100 kN static roller in stages to proper grad |
| 5 | Laying brick soling layer on prepared sub-grade with brick on edging according to lines, graded and cross-section shown on the drawing filling joints with sand and earth, spreading 25 mm thick layer of earth over brick soling, watering and rolliing as per Technical |
| 6 | Providing and applying primer coat with bitumen emulsion (SS-1) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.70 kg/sqm using manual means as per Technical Specification Clause 502. |
| 7 | Providing and applying tack coat with Bitumen VG-10 grade pressure distributor at the rate of 0.30 kg per sqm on the prepared granular surfaces treated with primer & cleaned with Hydraulic broom as per Technical Specification Clause 503. |
| 8 | Providing & laying of rolling of open graded premix carpet of 20mm thick.composed of 13.2-5.6mm Aggregates either using penetration grade bitumin or emulsion to required line,grade and levelto serve as wearing course on a previously prepared base ,i/c mixing in a suitable plant ,laying & rolling with a three wheel 80-100 KN Static roller capacity ,finished to required level and grades to be followed by seal coat of either Type A or Type B or Type C as per Technical Specification Clause 508. |
| 9 | Providing and laying seal coat by Manual means with VG-10 Grade Bitumen sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type C as per Technical Specification Clause 510 |
| 10 | Painting lines,Dashes,Arrows etc on Road in Two coat on New work with ready mixed road marking paint conferming to IS:164 on bitumenous/concrete surface ,i/c cleaning the surface of all dirt,dust and other foreign matter,demarcation at site and Traffic control as per drawing and Technical specification clause 1702. |
| 11 | providing and fixing of information sign board Please Enable Macros to View BoQ information |
