|
| 1 | Demolition of brick work built in cement mortar including all quoins arches pillars etc complete all as specified and directed. |
| 2 | Surface excavation not exceeding 30 cm deep and averaging 15cm deep including clearing away all grass vegetation, saplings, shrubs, brushwood, undergrowth, roots, and trees not exceeding 30 cm girth (measured one metre above ground level) and removing rubbish upto a distance of 50 metres and getting out soft/loose soil complete all as directed and specified. |
| 3 | Earthwork in excavation by mechanical means (Hydraulic excavator)/ in foundation trenches or drains (not exceeding 1.50 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.50 m including getting out the excavated all kind of soil and disposal of surplus excavated soil as directed, within a lead of 50 m complete all as specified and directed. |
| 4 | Rough excavation not exceeding 1.50 m deep and getting out in any type of soil complete all as specified and directed. |
| 5 | M&L for PCC 1:4:8 type D-2 (using 40mm graded stone aggregate ) in foundations, filling and mass conctrete complete all as specified and directed. |
| 6 | M&L for reinforced cement concrete (nominal mix) type B1 1:2:4 (using 20 mm graded stone aggregate) in for foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete complete all as specified and directed. |
| 7 | M&L for reinforced cement concrete (nominal mix) type B1 1:2:4 (using 20 mm graded stone aggregate) as in columns, pillars, piers, posts and struts complete all as specified and directed. |
| 8 | M&L for reinforced cement concrete (nominal mix) type B1 1:2:4 (using 20 mm graded stone aggregate) as in beams, cantilevers, bressummers, lintels over 1.5m span and similar work complete all a specified and directed. |
| 9 | Use and waste formwork to sides of concrete foundation footings, bases of columns raft and raft beams sides and soffits (if any) of foundation and plinth beams and similar work : vertical or to batter rough finished surfaces of concrete complete all a specified and directed. |
| 10 | Use and waste formwork to sides of pillars, post, struts, piers, columns and stanchions for fair finished surface complete all a specified and directed. |
| 11 | Use and waste formwork to sides of soffits of floor or roof beams etc for fair finished surface complete all a specified and directed. |
| 12 | S&F TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all a specified and directed. |
| 13 | S&F TMT bars 5mm dia and over upto 10mm dia bar as in stirrups cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all a specified and directed. |
| 14 | M&L for brickwork with fly ash bricks, straight or curved on plan exc 6m mean radius built in CM 1:6 complete all a specified and directed. |
| 15 | All as per item No 14.00 above but except bricks. Note: Old brick obtained from demolition shall be re-used. |
| 16 | Taking down cement or cement lime plaster, any description on stone walls etc incl raking out joints hacking for key, scrubbing down with water, etc. |
| 17 | M&L for 15mm thick rendering in CM 1:4 on fair face of brick walls finished even and smooth without using extra cement complete all as specified and directed. |
| 18 | M&L for preparation of newely plastered surface of wall and applying two coats of cement base paint over over a coat of alkali resistence primer complete all as specified and directed. |
| 19 | M&L for preparation of old plastered surfaces of wall and applying two coats of cement base paint complete all as specified and directed. |
| 20 | Dismantling wrought iron or mild steel work of any description not otherwise provided for as boundary wall grills complete all as specified and directed. |
| 21 | S&F mild steel framed work such as grill grating ornamental gate etc with end of bars shoulder or riveted forged into spikes, framed guared bars, barred iron doors, ladders framed balusters, walk ways railings, framed work of watertank and similar work conforming to Fe290. Gde-E165 complete all as specified and directed. |
| 22 | All as per item No 21.00 above but refixing only. Note: Old steel obtained from Dismantling shall be re-used. |
| 23 | M&L for preparation of new steel and iron surfaces of any description, over 10 cm in width or girth , not otherwise described and painting with two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed. |
| 24 | M&L for preparation of old painted steel and iron surfaces of any description, not otherwise described over 10 cm width or girth and applying a coat of sythetic enamel paint complete all as specified and directed. |
| 25 | Returning, filling in soft/loose soil including, spreading, levelling, watering and well ramming in layers not exc 25cm thick complete all as specified and directed. |
| 26 | Removing of surplus excavated material exc 250m but n exc 500m and deposited where directed at a level not exc 1.5m above the starting point complete all as specified and directed. |
| 27 | M&L for cement concrete type B0 1:2:4 (using 12.5mm graded stone aggregate) in copings, kneelers, apex stones, bed plates, water troughs and the like including weathering, slightly rounded or chamfered angles and throatingcomplete all as specified and directed. Please Enable Macros to View BoQ information |
