|
| 1 | Provising and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level: 1:2:4 (1 cement:2 coarse sand (zone-III) derived from natural source: 4 grade stone aggregate 20 mm nominal size derived from natural sources) |
| 2 | Steel work welded in built up sections/framed 100 work including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. In gratings, frames,guard bar, ladder, railings, brackets, gates and similar works. |
| 3 | Providing and fixing following rating and breaking 1 capacity and pole MCCB with thermomagnetic release and terminal spreaders in existing cubicle panel board including drilling holes in cubicle panel, making connections, etc. as required.100 Amp, 16 KA, TPМССB |
| 4 | Providing and fixing following rating and breaking 1 capacity and pole MCCB with thermomagnetic release and terminal spreaders in existing cubicle panel board including drilling holes in cubicle panel, making connections, etc. as required. 125 Amp,16 КА,ТРМССВ SITC of metal clad, powder coated, compartmentalized cubical panel board as per CPWD electrical specifications including insulated aluminum bus bars, supports, interconnection, erection of switch gears with depth 30 cm to 60 cm and making provisions for termination of incoming/ outgoing cables/ bus ducting and making foundation etc as required. (Suitable for 400 AMP TP & amp,N) |
| 5 | SITC of metal clad, powder coated, compartmentalized cubical panel board as per CPWD electrical specifications including insulated aluminum bus bars, supports, interconnection, erection of switch gears with depth 30 cm to 60 cm and making provisions for termination of incoming/ outgoing cables/ bus ducting and making foundation etc as required. (Suitable for |
| 6 | Providing and fixing precoated galvanised iron 48 profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+0.05%), total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protectiveguard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-incharge. The sheet shall be fixed using self drilling/selftapping screws of size (5.5x55mm) with EPDM seal, complete upto any pitch in horizontal/ vertical orcurved surfaces, excluding the cost of purlins, raftersand trusses and including cutting to size and shapewherever required |
| 7 | Supply of XLPE insulated PVC sheathed Al. Conductor 220 Armoured Cable 1.1KV grade conforming to IS-7098 of following size:-4C*50 sqmm |
| 8 | Laying of one number PVC insulated and PVC sheathed / XLPE power cable of 1.1 KV grade of 220 meter 58 12760 following size in the existing masonry open duct as required. Above 35 sq. mm and upto 95 sq. mm Please Enable Macros to View BoQ information |
