|
| 1 | Demolition of brick work or stone masonry built in cement mortar including all quoins, arches, pillars, etc. and disposing off the rubbish materials outside MD land as specified and directed |
| 2 | Demolition and removal of PCC in ground floors and paving not exc 15cm thickness below or above ground level unreinforced and removing the debris outside MD land. |
| 3 | Demolition of cement Concrete (Reinforced) in ground floors and pavings n. exc 15 cm thickness (below or above ground level) as specified and directed. |
| 4 | Dismantling wrought iron or mild steel work of any description not otherwise provided for complete as specified and directed. |
| 5 | S&F Mild steel , FE- 290 (Gde E-165) Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc. complete, drilled for fixing of steel sheeting or other covering, Doors etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive or steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete as specified and directed. |
| 6 | M&L for MS round steel bars 12 mm dia and over as in mooring rings, cut to length, bent to shape required and fixed on floor complete all as specified |
| 7 | M&L for preparation of new untreated steel surfaces of any description not otherwise described, over 10cm in width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed. |
| 8 | S&F Wire netting(mesh size 12mm) of stainless steel wire 1.4mm dia fixed with tinned tacks of stainless steel wire staples as specified and directed. |
| 9 | Rough excavation n. exc 1.5 mtr depth in and getting out complete all as specified and directed |
| 10 | Removing excavated material exc 250m but n exc 500m and deposited where directed at a level n exc 1.5m above the starting point |
| 11 | Forming embankments and traverses including raising (or lowering) earth, spreading in layers n exc. 30 cm thick;watering, ramming/rolling and finishing to required size, shape, etc. n,exc. 1.5 m high from base complete all as specified and directed. |
| 12 | M&L for Moorum/red bajri filling in floors or paving, laid in layers n exc. 15 cm thick spread, levelled & rammed including watering complete all as specified and as directed by Engr in Charge |
| 13 | M&L for PCC 1:2:4 type B2 using 20mm graded aggregate as in surfaces channels and drains complete all as specified and as directed. |
| 14 | M&L for Brick work with pre-cast cement concrete block masonary(Type C1 1:3:6) with solid blocks, exc. 10cm in width and built in CM 1:6 complete all as specified and directed. |
| 15 | M&L for providing pre-cast cement concrete type B1, 1:2:4 with using 20 mm grade stone aggregate set in CM 1:6 as in cover slab (manhole)/ open drain etc., with plain faces all as specified and directed including demolition of old U/s precast manhole cover/slab complete all as specified and directed by Engr-in-Charge complete as specified and directed by Engr-in-Charge. |
| 16 | M&L for rendering in two layers (i.e.) CM 1:6 10mm thick as first layers and CM 1:4, 5mm thick as 2nd layer on fair face of brick or concrete surfaces finished even & smooth without using extra cement complete all as specified and directed by Engr-in-Charge by Engr-in-Charge. |
| 17 | M&L for three coats of white wash including preparation of new concrete surfaces of drain and wall etc all as specified. |
| 18 | S&F mild steel TMT bar 10 mm dia bars cut to length bent to shape require, including cranking bending and binding with and including mild wire (annealed) not less than 0.9 mm dia or securing with clips quality conforming to deformed or twisted bars. Please Enable Macros to View BoQ information |
| 19 | S&F mild steel TMT bar 10 mm dia bars cut to length bent to shape require, including cranking bending and binding with and including mild wire (annealed) not less than 0.9 mm dia or securing with clips quality conforming to deformed or twisted bars. Please Enable Macros to View BoQ information |
