|
| 1 | Dismantling wrought iron or mild steel work of any description as in barbed wire or concertina coil, complete all as specfied and as directed. |
| 2 | Excavation in trenches, not exceeding 1.5m wide and not exceeding 1.5m in depth, for foundation etc., or for shafts, well, pier holes etc., not exceeding 10 Sqm on plan and not exceeding 1.5m in depth and getting out in any type of soil, complete all as specfied and as directed. |
| 3 | All as per description of Srl Item No.- 02 here-in-before but depth exceeding 1.5m and not exceeding 3.0m and getting out in any type of soil, complete all as specfied and as directed. |
| 4 | Returning, filling in including spreading levelling, watering and well ramming in layers not exceeding 25cm thick in any type of soil, complete all as specfied and as directed. |
| 5 | Removing excavated materials not exceeding 50m and depositing where directed at a level not exceeding 1.5m above the starting point, complete all as specfied and as directed. |
| 6 | Plain Cement concrete 1:2:4 type B-2 (using 40mm graded crushed stone aggregate) as in foundations, filling and mass concrete in footings of angle iron post, complete all as specfied and as directed. |
| 7 | Mild steel TMT bars (Fe-550D) 10mm dia & over in reinforcement cut to length bend to shape required, including cranking bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, complete all as specified and as directed. |
| 8 | Mild steel screw bolts (Machine made) of 16mm dia of neck with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, length of bolt exceeding 5cm but not exceeding 10cm, complete all as specfied and as directed. |
| 9 | Structural steel rolled sections conforming to Fe 410-W (Gde-E-250) quality A, as in framing for cladding, glazing and the like fixed with angle iron cleats and connecting plates, etc., complete all as specfied and as directed. |
| 10 | Rolled Mild steel Plates (Plain or Chequred) channels, square cut or notched, (ordinary and counter sunk) forming holes, with riveted, bolted or welded attachment conforming to Fe 410 -W (Gde E-250) Quality-A, complete all as specfied and as directed. |
| 11 | Pre-painted galvalume aluminum zinc coating GI based Plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in view cutter fixed to vertical ISMB member with minimum 03 Nos., 12mm dia bolts (tightened with nuts as required) on each vertical member and horizonatal ISMC member with minimum 02 Nos., 12mm dia bolts (tightened with nuts as required) on each horizontal members between two vertical members, complete all as specfied and as directed. |
| 12 | Preparation of new or previously untreated steel or iron Surfaces of any description, over 10cm in width or girth and applying two coats of synthetic enamel paint over a coat of red-oxide primer complete all as specified and as directed by Engr-in-Charge. Please Enable Macros to View BoQ information |
| 13 | Preparation of new or previously untreated steel or iron Surfaces of any description, over 10cm in width or girth and applying two coats of synthetic enamel paint over a coat of red-oxide primer complete all as specified and as directed by Engr-in-Charge. Please Enable Macros to View BoQ information |
