|
| 1 | EW-AS-NC-IR) Earth work excavation for foundation in all soils and sub-soils to the required depth as may be directed except in hard rock requiring blasting but inclusive of shoring, strutting, and bailing out water wherever necessary and refilling the sides of foundation with excavated earth in 150mm thick layers well watered rammed and consolidated and depositing the surplus earth in places shown clearing and levelling the site with an initial lead of 10 metres and lift as specified here under etc. complete in all respects complying with relevant standard specifications. (Including Refilling)a) 0 to 2m depth. |
| 2 | EW-AS-OC-ER) Earth work excavation for Open Foundation in all soils and sub-soils to the required depth as may be directed except in hard rock requiring blasting, inclusive of shoring, strutting and bailing out water wherever necessary. (Excluding refilling the sides of foundation) and depositing the earth in places shown clearing and levelling the site with an initial lead of 10 metres and lift as specified hereunder etc., complete in all respects complying with relevant Standard specifications (Excluding Refilling).a) 0 to 2m depth. |
| 3 | FL-FB-SCS)supplying and filling in foundation and basement with filling crushed stone sand in layers of 150 mm thickness well watered, rammed and consolidated complying with relevant standard specification including cost of supplying filling crushed stone sand. |
| 4 | FL-FB-SD) supplying and filling in foundation and basement with Stone dust in layers of 150 mm thickness well watered, rammed and consolidated complying with relevant standard specifications including cost of supplying gravel and as directed by the departmental officers. |
| 5 | CN-FB-PCC-1:3:6) Plain cement concrete 1:3:6 (one of cement, three of crushed stone sand and six of hard broken stone jelly including Mortar Plasticizer (Liquid) at 200ml per bag) for foundation and other similar works using 40mm gauge hard broken stone jelly excluding the cost and fabrication of reinforcement grills, shuttering, centering and vibrating but including laying, curing, finishing etc., complete in all respects complying with relevant standard specifications and as directed by the departmental officers. |
| 6 | CN-FB-PCC-1:5:10) Plain cement concrete 1:5:10 (One of cement, five of crushed stone sand and ten of hard broken stone Jelly including Mortar Plasticizer (Liquid) at 200ml per bag) for foundation and basement using 40 mm gauge hard broken stone jelly inclusive of shoring, strutting and bailing out water wherever necessary ramming, curing etc., complete in all respects complying with relevant standard specifications and as directed by the departmental officers. |
| 7 | BW-FB-KB-CM 1:5) Brick work in Cement Mortar 1:5 (One of cement and five of crushed stone sand including Mortar Plasticizer (Liquid) at 200ml per bag) using Kiln burnt country bricks of size 8¾”x4¼”x2¾” (22x11x7cm) in foundation and basement including dewatering wherever necessary proper setting, curing etc., complete with relevant standard specifications. |
| 8 | BW-MW-KB-CM 1:6) Brick work in Cement Mortar 1:6 (One of cement and six of crushed stone sand including Mortar Plasticizer (Liquid) at 200ml per bag) using Kiln burnt country bricks of size 8¾”x4¼”x2¾” (22x11x7cm) for super structure in the following floors including labour for fixing the doors, windows and ventilator frames in position, fixing of hold fasts, scaffoldings, curing etc., complete in all respect complying with relevant standard specifications and drawings.BW-SS-KB-CM 1:6 -(GF)b. In Stilt / Ground Floor |
| 9 | CN-FL-PCC-1:5:10) Plain cement concrete 1:5:10 (One of cement, five of crushed stone sand and ten of hard broken stone Jelly including Mortar Plasticizer (Liquid) at 200ml per bag) for foundation and basement using 40 mm gauge hard broken stone jelly inclusive of shoring, strutting and bailing out water wherever necessary ramming, curing etc., complete in all respects complying with relevant standard specifications and as directed by the departmental officers. |
| 10 | PL-OU-CM 1:5-12mm) Plastering with CM 1:5 (One of cement and five of crushed stone sand including Mortar Plasticizer (Liquid) at 200ml per bag) 12mm thick finished with neat cement, including providing band cornice, ceiling cornice, curing, scaffolding, etc., complete in all respects and complying with relevant standard specifications. |
| 11 | PA-IN-PEP-2C BPC) Painting the false ceilling / New walls with two coats of 1st class ready mixed PLASTIC EMULSION PAINT of best approved quality colour and shade including a priming coat over cement plastered surface including clean removal of dirt and dust etc., complete including cost of necessary brushes, labour charges, putty etc., complying with relevant standard specification. (The paint should be supplied by the contractors at his own cost.The quality and shade of the paint should be got approved from the Executive Engineer before use.) |
| 12 | RW-PB-D-RMH) Supplying and fixing of Rubber Moulded Hydraulic Pressed Paver Bloc of approved quality and make of building front and back side including cost of materials and conveyance of paver blocks and labour charges for laying to proper level, slope etc., all complete and as directed by the departmental officers. ( Design and colour should be got approved from the Executive Engineer before use.RW-PB-D-RMH - 83)a) 83mm thick |
| 13 | CN-F&S-RCC-M30) Providing and laying in position, Standardised Concrete Mix M-30 Grade in a accordance with IS:456-2000 using 20mm and down graded hard broken granite stone jelly for the all RCC items of works CN-SS-RCC-M30-(GF)b. In Stilt /Ground Floor |
| 14 | FW-FW-WOS-RCC) Providing Form work and centering for reinforced cement concrete works including supports and strutting up to 3.30m height for plane surfaces as detailed below with all cross bracings using mild steel sheets of size 90cm x 60cm and MS 10 gauge stiffened with welded mild steel angles of size 25mmx25mmx3mm for boarding laid over silver oak or country wood joists of size 10cmx6.5cm spaced at about 90cm centre to centre and supported by casurina props 10cm to 13cm dia spaced at 75cm intervals and removing the same after a specified period without damaging the R.C.C works etc., complete complying with standard specifaction and as directed by the departmental officers.FW-SS-WS-CS)f.Curved surface |
| 15 | RE-RTS-Fe-CO) Supplying, fabricating and placing in position of Mild steel Grills / Ribbed Tor Steels (without cement slurry) of all diameters for reinforcement for all floors including cost of binding wire insulated with PVC, bending tying etc., all complete and as directed by the departmental officers. |
| 16 | MW-MS-GR) Supplying and fixing Mild Steel grills as per the design approved to verandah enclosure or gate including one coat of primer and labour for fixing in position etc. all complete |
| 17 | PA-EX-IW-2C EP) Painting the new Iron work and other similar works such as PVC /ASTM Pipes, Kerb Stone and grills with two coats of approved first class synthetic enamel ready mixed paint of approved quality and brand, the paint should be supplied by the contractor at his own cost. (The quality and the brand of paint should be got approved by the Executive Engineer before use) complying with relevant Standard specifications. |
| 18 | WS-EX-BWSM-SP) Supply and delivery of clear water vertical wet type submersible pump Single phase without panel board conforming to IS 8034/2002 and as amended thereafter and BEE 3 Star Rated capable of discharging noted LPM against head of water column due to all causes. The pump shall be with stainless steel shaft and dynamically balanced bronze or Cast SS impeller, brass screws and CI FG 200 grade pump bowl/diffuser with ISI mark. The pump shall be directly coupled to a continuos rated two pole suitable wet type vertical squirrel cage induction motor suitable for operation in AC single phase 230 a) 50x60 lpm |
| 19 | WS-Ex-UPVC CP-CP40) supplying of following dia UPVC column pipe for borewell including cost of all materials of best approved superior quality with isi mark etc all complete and as directed by the departmental officers. (the quality of upvc column pipe should be got approved from the executive engineer before use)c. 40mm UPVC Column Pipe |
| 20 | WS-Ex-LC-S BW/OW) Labour charges for the erection of submersible pumpset in borewell/openwell including fixing and jointing submersible cable with proper clamps upto the starter to required depth and also fixing of riser pipes to the required depth valves erection clamps, pressure gauges upto the exterior wall of pump room and erection of panel board consisting of TPICN switches starter, Voltmeter, Ammeter, three pilot (indicating) lamps capacitor single phasing preventor, water level guard and laying and jointing the cables and twin earthing as per IE rules etc., complete and testing the pumpset and trail run for 10 days. Upto 5HP |
| 21 | WS-EX-DOL-SPPB) SINGLE PHASE PANEL BOARD WITH TWO LEVEL GUARD AND AUTOSTART Supply and delivery of direct online starter confirming to IS13947, IEC60947-1 and as amended thereafter with suitable KW rating for operation in AC/single Phase/50HZ(± 5%) and 230 V(±10%) including Ammeter, Voltmeter, Thermal Overload relay, 16 Amps 2 pole Magnetic Contactor with under Voltage protection, Indication lamp, starting capacitor, running capacitor and On/Off Push button switches, 5 way connector, wiring with 1 sq. mm/1.5 sq. mm copper PVC insulated cable, powder coated vermin proof box including the capacitor (the cost of capacitor is to be taken separately). |
| 22 | WS-Ex-FCC-3c) Supply and laying of PVC insulated and sheathed following core and sq.mm flat type copper cable confirming to IS 694/1990,cable for submersible motor etc., all complete and as directed by the departmental officers. (The materials should be got approved from the Executive Engineer before use)WS-Ex-FCC-3x2.5)b) 3 core 2.5 sq.mm flat type copper cable |
| 23 | WS-EX-Ny R-BW) supply and delivery of 12mm dia nylon rope of superior quality for submersible pumpset in borewell and as directed by the departmental officers (the quality of nylon rope should be got approved by the executive engineer before supply) |
| 24 | Supply and fixing of 40mm dia SS adaptor with ISI mark of best quality including cost of materail and labour charges etc.,completed and as by the departmental officers. |
| 25 | Supplying and fixing of 4” aluminium Door handle, Hooks with eyes of approved brand ISI quatity for existing door shutter incluidng cost of materials, necessary screws and labour charge etc., all complete and as directed by the Departmental officers. |
| 26 | Supply and delivery of Raw Sewage transfer Submersible cutter pump with Motor -2 HP / 3 phase , Head-8 Meter, Type of pump: Non clog Submersible pump - Cutter, Material of construction: CI, Solid sludge Handling - 30mm, Make ;Toshio / Texmo/ Eqvt. with 2\\" dia Nylon heavy duty Hose-15 Meter and 2 HP / 3 Phase starter - 1No. Please Enable Macros to View BoQ information |
