|
| 1 | Dismantling RCC by manual / by using deploying machineries including clearing away from site etc complete |
| 2 | Installation of Vertical Bored cast in situ RCC piles of following diameter in all types of soils, using Standardised Vibrated Concrete Mix of following grade, with sulphate resistant Cement or OPC/PPC, etc and Crushed Stone Sand and 20mm and down graded HBGS jelly coarse aggregate. The rate includes cost for placing of reinforcement cage in bore hole in correct position, cost of boring to the required depth with Bentonite solution with temprory casing of required length, conveyance of RMC to site and pouring concrete using Tremine pipes, conveyance of all materials to the site including all tools and plants, shifting the plants and equipments from one point to another, excavtion of mud pits for circulation of Bentonite soultion, closing the mud pits to original level and mud removal with initial lead and lift but including dismantling the concrete above the cut off level etc complete as directed by the departmental officers including socketing. The reinforcement cage should be welded properly for lifting. The concrete cubes to be tested as per IS 456-2000. Acceptance criteria by clause 16.1. Frequency of testing as per 15.2.2. Testing to be conducted at both the ends at site as well as RMC plant. Pile driving depth should be decided by the departmental officers at site. The length of pile for payment shall be measured from top of shoe to the bottom of the pile cap.( Cost of Reinforcement provided for Pile and Welding charges shall be measured and Paid separately ) |
| 3 | Earth work Excavation in all classes of soils except hard rock not requiring blasting and depositing on bank with all leads and lifts as per SS20B including cost of all labour, materials, tools, equipments and all incidental charges and sheeting, shoring, bracing and their subsequent removal, removal of all logs, stumps and other deleterious matter and obstructions, trimming of bottom of excavtion backfilling, and clearing the site and disposal of all surplus materials etc. complete as per standard specification forFoundation under Abutments & Return Walls and Piers / Pile cap under Abutments & Return Walls and Piers. |
| 4 | Filling with Stone Dust including cost and conveyance of material to work site including labour charges for filling, laying, compacting by manual labour under optimum moisture content to get the maximum density flooding with water as layers or built-up to the bottom level inclusive all other incidental charges etc., complete below levelling course. |
| 5 | Cement Concrete 1:5:10 (One Cement, Five crushed stone sand and Ten hard broken stone jelly) using 40 mm gauge hard broken granite stone jelly for foundation including dewatering wherever necessary and laid in layers of not more than 15 cm thick well rammed, consolidated and including curing etc. complete complying with standard specification and as directed by the departmental officers -Mixing by mechanical means |
| 6 | Supplying,fabricating and placing inposition Ribbed Tor Steel reinforcement grills of all variety like HYSD/CTD/TMTand all grade like Fe 500,Fe550D,Fe 500D etc for all RCC works as per design given including cost of steel reinforcement and GI binding wire,wastage etc complete complying with standard specification and as directed by the departmental officers.(Contractor has to make his own arrangements for the supply of steel reinforcement and binding wire) |
| 7 | Vibrated Reinforced Cement Concrete of grade M35 (Design mix) using 20mm and below HBG graded metal including cost and conveyance of all materials to site excluding cost of steel including cost of formwork, soft water, labour charges for mixing, transporting, laying and curing concrete, working at depths Hire charges for Tools and plants and incidental charges such as bailing out water, maintaining of protective bunds, cofferdams, shoring, strutting etc., complete as per relevent standard specification for PILE CAPS Under Abutments & Piers |
| 8 | Vibrated Reinforced Cement Concrete of grade M35 (Design mix) using 20mm and below HBG graded metal including cost and conveyance of all materials to site excluding cost of steel including cost of formwork, soft water, labour charges for mixing, transporting, laying and curing concrete, working at depths Hire charges for Tools and plants and incidental charges such as bailing out water, maintaining of protective bunds, cofferdams, shoring, strutting etc., complete as per relevent standard specification for Reatining Wall |
| 9 | Vibrated Reinforced cement concrete of grade M35 (Design mix) using 20mm and below HBG metal including cost and conveyance of all materials to site and cost of cement excluding cost and fabrication of steel but including labour charges for mixing, transporting, laying and curing concrete, working at heights, hire charges for Hire charges for Tools and plants including all other incidental charges etc., complete for Solid Deck Slab / T Beam and Cross girders / Deck Slab, Kerb & Footpath. |
| 10 | Vibrated Reinforced cement concrete of grade M30 (Design mix) using 20mm and below ISS hard broken granite metal including cost and conveyance of all materials to site cost of premoulded expansion joints and fixing the same in position including cost and labour charges for formwork, labour charges for laying, compacting, curing including all other incidental charges etc., complete for Hand Rails and Posts |
| 11 | Painting New Plastered wall Surface with Two finishing coats of ready mixed (Emulsion) of approved quality and colour over one coat priming coat in all floors including the cost of primer etc complete complying with standard specification and as directed by the departmental officers.(The make,quality and colour of paint should be got approved by the Executive Engineer before use on works) |
| 12 | Conveyance of Debris and excavated earth with initial lead and lift with an extra lead of 2km conveyance depositing places shown by the department officers including sectioning levelling etc.complete. |
| 13 | Supply and delivery of MS pipes and specials with inside lining/epoxy coating as per IS 13260-1993 and outside coating with cement mortar 20mm thick as per IS 1916-1989 and IS 7322-1985. etc.complete. |
| 14 | Lowering of upto 150mm dia MS pipe and specials the the tranches and laying to proper gradient and alignment and as directed by department officers |
| 15 | Supply of MS spiral welded saw pipes-mm ODxmm WR confriming to IS 3589/ 2001 made with HR coll conforming to la 2026 Ro 410 grade in double random length with bevelled/ plain ends . |
| 16 | Engaging the Tractor with Dozer vehicle on Daily Hire basis for earth work excavation,Refilling and Removal the existing earth including cost of Transporting charges,Fuel charges and Driver Bata etc., complete. |
| 17 | Hire Charges for Diesel Pumpset above 7.5HP with Fuel and Crew charges including transportation at site etc.complete. |
| 18 | Engaging the Crane with grab bucket of 0.75 / 1.0 cum capacity and accessoriesCrane vehicle on Daily Hire basis for lifting of pipes and specials,steel fabrication etc including cost of Transporting charges,Fuel charges and Driver Bata etc complete. |
| 19 | Supply and fixing of 120W LED street light fitting with LED (Higher end) with 32mm dia GI pipe (class B) with 1No of 32mm dia GI bend complete on the existing post/ on wall with PVC unsheathed FRLS copper leads with MS clamps and with painting SD-459 |
| 20 | Supply and clamping of 2 x 6 sq.mm PVC armoured Copper LTUG cable on post or on wall with MS clamps SD-216 |
| 21 | Supply and fixing of brass cable gland for 2 x 6 sq.mm. PVC LTUG armoured cable with earth connection SD-159 |
| 22 | Supply and providing cable end termination of 3-1/2x25 sq.mm PVC LTUG aluminium armoured cable with necessary aluminium cable sockets by crimping etc with electrical connection complete SD-223 |
| 23 | Supplying and Fixing GI pipe 32 mm dia (B class) including cutting and fixing in to kerb wall for30 cm depth including fixing weld mesh 7.5 cm x 5cm 10 gauge and fixing welding with MS angle 35 x 35 x 6mm allround and with MS Flat 45 x 6mm at middle including Conveyance etc ., Complete |
| 24 | Chipping of concrete and roughening the surface including all charges etc complete as directed by departmental engineer(W-0036) |
| 25 | Vibrated Cement Concrete M20 (Design mix) using 20 mm ISS HBG graded metal including cost and conveyance of all materials to site and cement at site and cost form work and centering soft water labour charges for mixing, transporting, vibrating and compacting finishing and curing concrete, working at heights, hire charges for Hire charges for Tools and plants, including all other incidental charges, etc., complete as per standard specifications for CC Pavement |
| 26 | Supplying and installation of Strip Seal Expansion Joint system conforming to specifications for Roads and Bridge works published by the MORT&H and Highways in the 40mm wide expansion gap provided in between decks over piers and in between decks and dirt wall over abutment with fatigue tested structural steel section at the nosing and anchorage seembly including cost and conveyance ofall materials cost of testing as per the MOST specifications including labour equipment and incidental charges for fixing the joints complete in all respects as per section 2600 of MORT&H specification. |
| 27 | Vibrated cement concrete M30 Grade (Design mix) using 20mm, 12mm and 6mm ISS size hard broken granite metal including cost and conveyance of all materials to site cost of premoulded expansion joints and fixing the same in position including cost and labour charges for formwork, labour charges for laying, compacting, curing including all other incidental charges etc.,complete for WEARING COAT 75mm UNIFORM THICKNESS OVER DECK SLAB AND OVER APPROACH SLAB. Please Enable Macros to View BoQ information |
