|
| 1 | Dismantling all types of masonry excepting cement concrete plain or reinforced, stacking serviceable materials at site and removing rubbish as directed within a lead of 75 m. |
| 2 | Dismantling all types of cement concrete works, stacking serviceable materials at site and removing rubbish as directed within a lead of 75 m. In ground floor including roof.a) Up to 150 mm thick |
| 3 | Earth work in excavation of field trenches as per design section and alignment for laying of pipe lines (PVC, RCC, ACP etc.) upto a depth of 1500 mm all sorts of soils including removing, spreading or stacking extra earth as directed. The item includes necessary trimming of sides trenches, levelling, dressing and ramming the bottom as required complete |
| 4 | Earthwork in excavation of foundation trenches or drains in all sorts of soil including mixed soil but excluding laterite and sand stone), including removing, spreading or stacking the spoils with in a lead of 75 m. as directed trimming the sides of trenches, leveling, dressing and ramming the bottoms, bailing or pumping out of water etc. as required complete. Depth of excavation not exceeding 1.5 metre (not required shoring) |
| 5 | Sand filling in foundation or plinth by silver sand in layers not exceeding 15 cm. as directed and consolidating the same by thorough saturation with water and ramming complete, including the cost of supply of sand. (payment to be made on measurement of finished quantity) |
| 6 | Single brick flat soling of picked Jhama bricks including ramming and dressingbed to proper level and filling joints with local sand. |
| 7 | Ordinary Cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement ,if any, in ground floor as per relevant IS codes (d) With local hard blackstone variety chips (crusher broken) |
| 8 | Ordinary Cement concrete (Mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement , if any, in ground floor as per relevant IS codes.(a) Pakur vareity. |
| 9 | Hire and labour charges for shuttering with centreing and necessary staging upto 4 metre using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs, beams,columns, lintels curved or straight including fittinhg, fixing and striking out after completion of works (Upto roof of ground floor). 25 mm. to 30 mm. thick wooden shuttering. |
| 10 | Brick work with 1st class bricks in cement mortar (1:6) (a) In foundation and plinth |
| 11 | 125 mm thick Brickwork with 1st class in cement mortar (1 : 4) in ground floor. |
| 12 | Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners, as directed and racking out joints or roughening of concrete surface including throating, nosing and drip course ,scaffolding and stagging where neccesary (ground floor)(excluding cost of chipping over the concrete surface) |
| 13 | Neat cement punning about 1.5 mm. thick in wall dado, floor, drain, door and window sill etc. Complete. (NB 0.152 cum per 100sqm) |
| 14 | Labour charges for fitting, fixing150 mm. Dia. Alfa-AIfa valve with 160mm. dia. P.V.C. riser pipe with the help of flanged P.V.C. tail-piece by joining the P.V.C. End of Tail-piece and riser pipe with coupler and flanged end of Tail-piece and Alfa-Alfa valve with rubber insertion, nuts and bolts etc. complete. |
| 15 | Labour charge for replacement of different PVC. Accessories in different portion of PVC. Pipeline of HDTW 1 MDTW 1 RLI including taking out of the existing damage accessories, and excluding the supplying the new accessories of 4 Kg.lcm2 capacity and as per I.S. specification at site andfitting,fixing the same by joining with solvent cement (cost inclusive) after roughening up the surface with wire brush, emery papers etc., to make the joint leak proof all complete as per direction of Engineer-in-Charge. (iv)140 mm X 140 mm X 160 mm. PVC.Tee |
| 16 | (xi) 160 mm dia. 90 degree long bend |
| 17 | (xi) 160 mm dia. Flanged tail piece fitted with Alfa-Alfa valve |
| 18 | Earth work in filling in trenches after laying pipe lines (PVC, RCC, ACP etc.) with good earth obtained from excavation of field trenches in layers not exceeding 225 mm, including watering and ramming etc. layer by layer complete. (Payment will be made on the basis of measurement of finished quantity of work.) |
| 19 | Repair of puncture/holes of any size in existing P.V.C. Pipeline of HDTW/MDTW/RLI by placing half round P.V.C. Pipe section of required size to cover the holes/ puncture having adequate bearing on all sides and joining the half round section with solvent cement after roughening the surface with wire brush, emery paper to make the joint leak proof as per direction of Engineer-in-Charge (cost inclusive of supplying solvent cement at site and transportation of required length of P.V.C.Pipe to be issued departmentlly, for cutting half round section, from Sub-Divisional Stores to site)(i) 200 mm dia. P.V.C. Pipe line |
| 20 | (ii) 140 mm dia. P.V.C. Pipe line |
| 21 | Laying of P.V.C. pipes of different diameters within field trenches in curve / straight line using P.V.C. fittings, viz. Bend, Tee, Reducer etc. and making leak-proof joints with couplers after roughening the surface with wire brush and emery paper and applying solvent cement (The rate is inclusive of transport of pipes, fittings and solvent cement to be supplied by Deptt. and cost of earth cutting & back filling with same earth including breaking clods after laying of pipe line) all complete as per direction of Engineer-in-Charge.(i) 200 mm dia. P.V.C. Pipe line |
| 22 | (ii) 140 mm dia. P.V.C. Pipe line |
| 23 | Erection, fitting, fixing of set of M S Quadruped inlet and outlet pipe fittings for 1st chamber and 2nd chamber of Major RLI Scheme. (Rate inclusive of transportation from departmental store to work site). |
| 24 | Fitting and fixing of M.S. / G.I. / C.I.accessories and special in pipe line (accessories & special to be supplied departmentally) including supply of jointing materials viz.rubber insertion, nuts & bolts, havoc Zink (Zink Oxide) complete as per direction of Engineer-in-Charge. a) 150 mm dia sluice valve. |
| 25 | Priming one coat on steel or other metal surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc. |
| 26 | Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary.b) On steel or other metal surface :With super gloss (high-gloss)iv) Two coats (with any shade except white). |
| 27 | Testing of pipe line system against leakages by filling the distribution chamber with water and supplying water through the entirepipe line net work for at least 4 (four) hour by running the departmental Diesel Engine pumping set, including supplying necessary fuels & lubricants and hiring and transporting tools and plants all complete as per direction of Engineer-inCharge. |
| 28 | Carriage charge 4% on Sl no 1-27 ,Excluding 3,4,18 i.e on Rs. 232973.11 |
| 29 | Add GST @18% for the item No (1 to 28) on Rs. 330003.91 |
| 30 | cess 1% on for the item No (1 to 29) on389404.61 Please Enable Macros to View BoQ information |
