|
| 1 | I AIR POLLUTION |
| 2 | Part A Stack Monitoring of 02 no’s pass A & B in Unit # 5 for Boiler in service for following determinations: |
| 3 | SPM in mg/NM³ SO₂ in mg/NM³ NO₂ in mg/NM³ |
| 4 | Mercury mg/NM³ |
| 5 | B Part I :- Ambient Air Quality twice a week, on three location/ inside(1No) & out side( 2 Nos in surrounding areas of 1.9 km radius from the PH) for following determinations: |
| 6 | Sulphur Dioxide (SO2) μg/m3 |
| 7 | Nitrogen Dioxide (NO2) μg/m3 |
| 8 | Particulate matter (size less then 10 μm ) |
| 9 | Particulate matter (size 2.5 μm ) |
| 10 | Ozone (O3) μg/m3 |
| 11 | Carbon Monoxide (CO) μg/m3 |
| 12 | Part B II Ambient Air Quality twice a week, on four location/ inside & out side( in surrounding areas of 1.9 km radius from the PH) for the following determinations: |
| 13 | Lead (Pb) |
| 14 | Ammonia (NH3) μg/m3 |
| 15 | Benzene (C6H3) μg/m3 |
| 16 | Benzo (a) Pyrene (BaP) ng/m3 Particulate Phase Only: |
| 17 | Arsenic (As) ng/m3 |
| 18 | Nickel (Ni) ng/m3 |
| 19 | Part B III Air pollution Quality monitoring at sangma siding sohagpur area Dhanpuri on two location upward & downward wind direction arround 500 mtr. From emission of source. |
| 20 | PM10 μg/m3 |
| 21 | PM2.5 (SPM) μg/m3 |
| 22 | SO₂ μg/m3 |
| 23 | NO₂ μg/m3 |
| 24 | Part C Fugitive Emission Determination in air samples collected in services areas for following Parameters: |
| 25 | (i) Mill Area (1)(ii) Bunker House(1)(iii) ESP Area(1)(iv) Silo Area(1)(v) Track Hopper(1)(vi) Primary & Secondary crusher (2) |
| 26 | II WATER POLLUTION |
| 27 | Part A Water sample from ash pond (1)& around ash pond in all four direction (4) for following: |
| 28 | BODCODFluorideCadmiumLeadArsenicMercuryTitaniumZincDissolved O₂ChlorideNitrateSulphateChromium Hexa valentBoronCyanideAluminiumManganesePhenolic CompoundMineral OilPesticideAnionic CompoundTotal DetergentBacteriological |
| 29 | Part B Industrial Drain:- 01 no Boiler & 01 no Condenser for following: |
| 30 | pH TSS TDS CopperIron oil & Grease Free available Chlorine |
| 31 | Part C Cooling Tower Blow Down for following:- |
| 32 | Free available ChlorineZincChromium(Total)PhosphateOther corrosion inhibiting material |
| 33 | Part D Domestic Water from settling Tank (01) no’s & Domestic waste water (01) no of following: |
| 34 | pH TSS Oil & GreaseFluorideDissolved O₂BOD/CODMPN Colliform/100 ml |
| 35 | Part E ETP Effluent for following:- Two numbers sample of plant premisses & coal loading/unloading of Sangma Siding |
| 36 | Oil & Grease |
| 37 | Chlorides |
| 38 | Part F Ash Pond Effluent for following: |
| 39 | oil & Grease |
| 40 | Part G POTABILITY CERTIFICATE from Govt. Agency or Govt. approved Lab for drinking water sample from settling tank & reservoir; |
| 41 | Part H Piezometer Water Samples:Chemical Parameters (mg/1, except, pH and EC: pH, EC, TDS, total Alkalinity, Ca, Mg, Na, K, Cl, SO4,NO3, PO4 Trace Elements (mg/1):As, Ba, Cd, Co, Cr,Cu, F, Fe, Hg, Mn, Ni, pb, Zn |
| 42 | III NOISE POLLUTION |
| 43 | Monitoring at six location as below: |
| 44 | Turbine House PH-3Boiler House PH-3WT Plant PH-3PF Mill area PH-3Coal Handling Plant PH-3Basement Area PH-3 |
| 45 | Sangma Siding on two times ( Coal Loading/Unloading platform) 6:00 AM to 9:00 PM to 9:00 PM to 6:00 AM |
| 46 | IV HAZARDOUS WASTE ANALYSIS |
| 47 | Part A Analysis of Used/Waste Oil Determination of following parameters in Used Oil (Lub/Transformer etc.) before their disposal. |
| 48 | Poly Chlorinated Bi-Phenyl's (PCB's), Lead, Arsenic Cadmium/Chromium/Nickel, Poly Aromatic Hydrocarbons (PAH's), Sediments, Total Halogens |
| 49 | Part B ETP Sludge 2 Nos. (1 No. from ETP & 1 no. from N- Pit of DM Plant) |
| 50 | pH Total Solid content (TS) Fixed Solid (FS) Volatile Solid (VS) Total Alkalinity Copper Iron Calcium Sludge Volume Index (SVI) Chromium Silica Please Enable Macros to View BoQ information |
