|
| 1 | Hiring & engaging Diesel Pump of 5 H.P. with POL For Dewatering at site. |
| 2 | E/W in cutting in foundation of box culvert/guide wall on channels including lead upto 30m and lift upto 1.5 m and disposal and backfilling as per direction of engineer in charge |
| 3 | Providing and laying filter media with granular crushed aggregates as per specification with smaller size towards the soil and bigger size towards the floor apron including cost of all material , labour T& P etc for proper completion of work |
| 4 | Providing and laying filter media with granular crushed aggregates between CC blocks as per specification with smaller size towards the soil and bigger size towards the floor apron including cost of all material , labour T& P etc for proper completion of work |
| 5 | Laying Plain Cement Concrete (M -15) in foundation 1:2:4 with stone grie including cost of material, labour, T&p etc, complete. |
| 6 | Laying Reinforced Cement Concrete (M25 A20) in foundation , wall, slab etc. in 1:1:2 with stone grit including cost of material, labour, T&p etc, complete. |
| 7 | Laying Reinforced Cement Concrete in Crash barrier aproch slab 1:01:02 (M-30) with stone grit including cost of material, labour, T&p etc, complete. |
| 8 | Supply and fixing steel r/f bar (tested) for RCC including cleaning, streghtening, cutting, bending, all handling, placing in position and binding with 0.90mm annealed binding wire conforming to IS:280- 1978. (including cost of binding wire) cold work steel high strength bars conforming to grade Fe 415 of IS:1786 |
| 9 | Providing fixing centering & shuttering for Bridge slab above 3.00m span including cost of all material labour T&P etc. |
| 10 | Providing fixing centering & shuttering for RCC WORK including cost of all material labour T&P etc. |
| 11 | Providing fixing centering & shuttering for CC Work including cost of all material labour T&P etc. |
| 12 | Providing fixing centering & shuttering for PCC Work in foundation including cost of all material labour T&P etc. |
| 13 | Providing & Fixing Bitumen Joint filer Board For Expansion Joints. |
| 14 | Finishing wall with water proofing cement paint of approved make such as super snowcem, Durocem,robiecem, guttu cem, supercem quality and of required shade on new wall white cement primer to give an even shade after thoroughly brushing the surface to remove powdered materials surface(two coats) over one coat of including curing and cost of all materials |
| 15 | Writing letter on Gauge &chainege above 50 mm size but below80 mm size CHAPTER XIII SR 34(l) |
| 16 | Sub GradeConstruction of subgrade and earthen shoulders with apprved material obtained from borrows pits with all fifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table 300.2 with lead upto 1000 m |
| 17 | Granular Sub Base Construction of granular sub-base by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with smooth wheel roller to achieve the desired density, complete |
| 18 | WBM Grade-2Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening/binding materials to fill-up the interstices of coarse aggregate, watering and compacting to the required density grading 2 |
| 19 | WBM Grade-3Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening to fill-up the interstices of coarse aggregate, watering and compacting to the required density Grading 3 |
| 20 | Prime CoatProviding and applying primer coat with bitumen emulsion (SS-1) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.70-1.00 kg/sqm using mechanical means |
| 21 | Tack CoatProviding and applying tack coat with Bitumen (VG-10) using bitumen pressure distributor at the rate of 0.35 kg per sqm on the prepared granular surfaces treated with primer & cleaned with Hydraulic broom as per Technical Specification Clause 503. (as per En.C. Circular No. 10598 MT / Samanya Varg / 60 MT / 2012 dated 23.11.2012) |
| 22 | Premix CarpetProviding, laying and rolling of open-graded Premix Carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen (VG-10) to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in suitable plant, laying and finishing with paver finisher and compaction with three wheel 80-100 kN static roller capacity, finished to required level and grades to be followed by Seal Coat 'Type-B' |
| 23 | Seal CoatProviding and laying Seal Coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using 'Type B & VG-10' Please Enable Macros to View BoQ information |
