|
| 1 | Providing Hight Strength Thread Locker (Anaerobic Di methacrylate ester) having atleast the following properties: Breakaway torque (M10): ≥ 26 Nm, Temperature resistance: –55°C to +180°C, Fixture time: ≤ 10 min, works on active metal but also on passive substrates, Prevailing torque (M10): ≥ 32 Nm |
| 2 | Providing High Strength Bearing retainer (Urethane methacrylate anaerobic adhesive) having atleast the following propertiesGap filling capability: up to 0.25 mm, Shear strength (steel): ≥ 28 N/mm², Works on active & passive metals, Temperature resistance: –55°C to +180°C |
| 3 | Providing Low Viscosity Instant adhesive (Ethyl cyanoacrylate adhesive) having atleast following propertiesViscosity: 12–22 cP, Very fast fixture: ≤ 5 sec on plastics & rubber, Lap shear strength (steel): ≥ 15.5 N/mm², Temperature resistance: –40°C to +120°C |
| 4 | Providing High Temperature RTV Silicone (Acetoxy silicone sealant) having atleast following propertiesHigh temperature resistance: up to 315°C, Shore A hardness: ≥ 18, Elongation at break: ≥ 300%, Tensile strength: ≥ 1.5 N/mm², Peel strength on metal: ≥ 1.73 N/mm |
| 5 | Providing of Graphite-based non-metallic anti-seize having atleast following propertiesPenetration: 310–360 (1/10 mm), Torque coefficient K: 0.13 (lubricated bolt), Temperature range: –29°C to +482°C, Good conductivity across threaded joints |
| 6 | Providing of Fast Set Steel Putty having atleast following propertiesGel time: 3.5–4 min, Tensile strength: ≥ 27 N/mm², Compressive strength: ≥ 51 N/mm², Shore D hardness: ≥ 80, Operating temperature: –30°C to +95°C |
| 7 | Providing of Penetrating oil having atleast following properties Specific gravity: 0.83, Must loosen rust-locked nuts/bolts, Displaces water & moisture, Removes rust, dirt, oxidation, Provides temporary corrosion protection |
| 8 | Providing of Electrical contact cleaner having atleast the following propertiesZero residue formulation, Removes moisture, dust, oils & oxides, Safe on metals & most plastics, Must restore electrical continuity |
| 9 | Providing of Superior metal Epoxy (Ferro-silicon filled heavy-duty epoxy) having atleast the following propertiesTensile strength: ≥ 27 N/mm², Compressive strength: ≥ 134 N/mm², Shore Hardness : ≥ 86 N/mm², Abrasion resistance ASTM D4060 : not more than 127 mg, Temperature resistance: up to 120°C |
| 10 | Providing of Floor Repair Epoxy having atleast the following properties3-component, 100% solids epoxy mortar, Volume shrinkage: ≤ 0.66%, Compressive strength: ≥ 90 N/mm², Shore D hardness: ≥ 80, Temperature resistance: –30°C to +120°C, Self-levelling formulation Please Enable Macros to View BoQ information |
