|
| 1 | Cutting in earth work in all kinds of soil such as pick work, jumper work, blasting work and chiselling work etc. and disposal of excavated earth as directed within all leads and lifts. |
| 2 | Excavation in foundation, trenches,etc. in earth work in all kinds of soil such as pick work, jumper work,blasting work, hard blasting and chiselling etc. stacking the excavated soil not more than 3 mtrs.clear from the edge of excavation and then returning the stacked soil in 15cm.layers when required into plinths sides of foundations etc.then disposited layer by ramming and watering and then disposing of all surplus excavated earth as directed within all leads and lifts.complete in all respect and to the entire satisfaction of the Engineer-in-charge. |
| 3 | Excavation in drains and channels etc. in earth work for pipes upto all depth in all classification of earth work such as pick work, jumper work, saturated soil i/c balling or pumping out water , blasting soft /hard rock or chiseling soft/ hard rock where blasting is prohibited in all lifts including jungle clearance wherever required, trimming and dressing of sides, levelling of beds to correct grade including shoring /struting, planking, timbering and dewatering wherever required stacking the useable /unusable material/soil seperately and after laying,jointing and testing of pipes ,returning the useable soil in treches in 15 cm layers including consolidating of such deposited layer by ramming and watering and then disposing of all surplus excavated soil/ unusable material as directed within all leads and lifts including restoration of un-metalled surfaces to its original condition and including cost of diversion for traffic, night signals, fixing caution boards,crossing over trenches for access to houses, fencing etc. complete in all respect whithin all leads and lifts as per direction of the Engineer-in-charge. |
| 4 | Prov. and laying cement concrete 1:4:8 (1cement:4sand:8graded stone agg. 40mm nominal size) and curing complete excluding cost of form work in:-a) Foundation and plinth. |
| 5 | Prov. and laying cement concrete 1:6:12 (1cement:6sand:12graded stone agg.40mm nominal size) and curing complete excluding cost of centring and shuttering in: a) Foundation and plinth. |
| 6 | Providing form work with steel plates 3.15mm thick welded with angle iron in frame 30x30x5mm so as to give a fair finish including centring, shuttering, strutting , strutting and propping etc. with wooden, battens, and ballies, height of propping and centring below supporting floor to ceiling not exceeding 4 mtrs.and removal of the same for insitu reinforced concrete and plain concrete work incomplete in all respect in all leads and lifts and to the entire satisfaction of the Engineer-in-charge. |
| 7 | Foundation footings bases of column and mass concrete. |
| 8 | Vertical surfaces such as walls (any thickness) partitions and the like including attached pillasters, buttresses, plinth and string courses and the like. |
| 9 | Flat surfaces such as soffits of suspended floors,roofs, landings, and the like:-i)Floors etc. upto 200mm in thickness. |
| 10 | Edges of slabs and breaks in Floor and walls :- Under 20cm wide. |
| 11 | Prov. and laying cement concrete work 1:1:2(1cement:1 and:2 graded stone agg. 20mm nominal size) and curing complete excluding cost of form work and reinforcement in reinforced concrete work i/c all leads and lifts complete in all respect.:- |
| 12 | Foundation and plinth. |
| 13 | Walls (any thickness) but not less than 0.1 m thickness) including attached pillasters,buttresses, plinth and string courses etc.from top of foundation level upto floor two level. |
| 14 | Providing and laying cement concrete work 1:2:4(1cement:2sand:4 graded stone agg. 20mm nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work in :- |
| 15 | Suspended floors, roofs, landings,shelves and their supports balconies, beams, girders, bressumers and cantilevers upto floor two level. |
| 16 | Prov. in RCC work smooth finishing of the exposed surfaces with cement mortar 1:3(1cement:3sand). |
| 17 | Prov. Mild steel/Tor steel reinforced for RCC work including bending, binding and placing in position complete upto floor two level i/c all leads and lifts complete in all respect. :- a) Tor steel. |
| 18 | Supplying cast iron cover without frame for man hole (For frames of 500mm internal dia meters C.I.cover medium duty the weight of cover to be not less than 58 kg).complete in all respect. |
| 19 | Prov. 200mm wide cast iron rungs with chequered or ribbed non slip surface including fixing in manholes with 200mmx 200mmx 100mm cement concrete 1:3:6 (1cement:3sand:6graded stone agg. 20mm nominal size).complete in all respect i/c all leads and lifts. |
| 20 | Steel work welded in built up sections, trusses and framed work including cutting hoisting, fixing in position and applying a priming coat of red lead paint i/c all leads and lifts complete in all respect. |
| 21 | In beams, joists, channels, angles, tes, flats with connection plates or angle cleets as in main and cross beams, hip and jack rafters, purlins connected to common rafters and the like. |
| 22 | Providing corrugated G.I. Sheet roofing fixed with galvanised iron J. or L. hooks bolts and nuts 8 mm diameter with bitumen and G.I. Limpet washers filled with white lead complete exculuding the cost of purlins refters and trusses.complete in all respect within all leads and lifts as per direction & to the entire satisfaction of Engineer-in-charge:- 0.63 mm thick G.I. sheet |
| 23 | Providing and fixing of M.S.sliding door bolts brigtht finished or/and black enamelled with bolts,nuts and screws etc. complete. |
| 24 | 250x 16mm. |
| 25 | Providing and fixing of Iron hinges 100x58x1.90mm. Complete in all respect. |
| 26 | Providing and fixing M.S. handles with necessary screws etc. complete i/c all leads and lifts and as per direction of Engineer-in-charge. |
| 27 | 125mm. |
| 28 | Laying and jointing in trenches,galvanised mild steel tubes (Light grade)i/c tube fittings such as Tee, elbow, union & nipple.(earth work in trenches to be measured and paid for separately)i/c all leads and lifts complete in all respect |
| 29 | 15mm dia nominal bore. |
| 30 | 25mm dia nominal bore. |
| 31 | 40mm dia nominal bore. |
| 32 | 50mm dia nominal bore. |
| 33 | Prov. and fixing brass full way valve with wheel of superior quality including all leads and lifts In :- |
| 34 | 15mm dia nominal bore. |
| 35 | 25mm dia nominal bore. |
| 36 | 40mm dia nominal bore. |
| 37 | 50mm dia nominal bore. |
| 38 | Providing and fixing double flanged cast steel Non return valve of 50mm dia Leader make and capable of with standing the normal seat pressure as per ISI mark {Class ASA-300) complete in all respect as per the direction of the Engineer-in-charge. |
| 39 | RISING MAIN:- |
| 40 | Prov.Laying and jointing in trenches galvanised mild steel tube 40mm (Medium grade) of following diameters conforming to IS-1239 as specified below jointed with butt welding according to relevant BIS code 816-1969 including all short pieces bends,tee and other specials etc. made from parent tubes as applicable for the particular reach and of approved specifications as per site conditions including flushing, cleaning and hydraulic testing complete to the best satisfaction of the Engineer-in-charge. The pipe shall be engraved with yst 170 code IS 1978 and supplying firm logo at the two end centre of the pipes. The laying shall confirm to BIS 5822-1970 within all leads and lifts and to the entire satisfaction of the Engineer-In-Charge. The laying of pipes should conform to BIS code 5822-1970 within all leads and lifts complete in all respect. |
| 41 | 50mm dia Medium grade. |
| 42 | Providing of M.S.flanges ISI marked conforming to IS-6392-1971 of different tablecapable of with required standing test pressure of 0.6N/sq.mm welded at both side of 50mm dia GMS pipes ( Medium class) with nuts, bolts and 3mm thick ferrado make gasket. The welding is to confirm to IS -3138-1986 i/c hydraulic testing at site complete in all respect including all leads and lifts. |
| 43 | 40mm dia flange Table.17. |
| 44 | Pumping Machinery:- |
| 45 | Providing and installation of submersible pump 3 HP conforming to IS :9034-1976 alongwith directly coupled submersible type squrrel cage electric induction motor suitable for 3 phase water lubricated bearing and provided with pivoted segment type thrust bearings to with stand non vertical lead with minimum wear and tear and duly fitted with device to take upto the expension of water with heating of motor complete in all respect including entire carriage of material upto all leads and lifts (Make:- KSB/Hindustan) .2 sets of 3 HP Each.). |
| 46 | (I) Discharge (Q):- 0.75 LPS. |
| 47 | (ii) Total Head: - 110.00 Meters. |
| 48 | iii) Capacity:- 2 set of 3 HP. |
| 49 | Automation:- |
| 50 | G3- Single Phase Submersible pump: |
| 51 | G3-Single phase submersible 3 HP. |
| 52 | This comes with the inbuilt panel. |
| 53 | Remotely operated. |
| 54 | Water level controller included. |
| 55 | Level sensors (1 number). |
| 56 | Wiring included from panel to tank (upto 10m). |
| 57 | Annual Subscription (App+ Desktop Monitoring +IOT data charges).Subscription iclusions: |
| 58 | Mobile app to operate and track operations for individual users. |
| 59 | Web application to operate, track operations, data dashbord for overall monitoring purpose. |
| 60 | Pump component maintenance monitoring platform (Controller, Starter/Panel, Motor, Pump). |
| 61 | IOT and Cloud based data services. |
| 62 | No restriction on number of users creation. |
| 63 | Real-time fault alerts- Over/under voltage, Dryrun, Current fluctuations, phase supply missing. |
| 64 | Usage history for pump operation, water distribution and elecgtricity consumption. |
| 65 | Over the air updates for Mobile APP and Web Application For bug fixes and minor customizations. |
| 66 | Remote Support related to Mobile App, Web Application and Conroller functionality understanding and issues. |
| 67 | Automation training services and support for new technicians. Please Enable Macros to View BoQ information |
