|
| 1 | Excavation in foundation, trenches etc. earth work in all type of soil such as pick work, jumper work, blasting work kankar,mooram singles including decomposed soft and hard rock etc. upto all heights stacking the excavated earth not more than 3 metres clear from the edge of excavation and then returning the stacked soil in 15cm layers when required into plinths and sides of foundation etc.consolidating each deposited layer by raming and watering and then disposing of all surplus excavated earth upto all leads and lifts as directed by the Engineer in charge complete in all respects. |
| 2 | Excavation in drain and channels etc. in earth work including dressing of side and bed and disposing of excavated earth upto a lead of 20 meters and lift upto 1.50 meters disposed earth to be levelled and neately dressed in pick jumper work complete in all respects. |
| 3 | Providing and laying cement concrete 1:3:6 (1 cement:3 sand:6 graded stone aggregate 20mm nominal size) and curing complete excluding cost of centring and shuttering in: Foundations and plinth including carriage of materials upto all leads and lifts complete in all respects. |
| 4 | Providing and laying cement concrete 1:1½:3 (1 cement: 1½ sand: 3 graded stone aggregate 20mm nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work in. |
| 5 | Foundation footings bases of columns and the like and mass concrete including carriage of materials upto all leads and lifts complete in all respects.. |
| 6 | Walls any thickness (but not less than 0.10meter thickness including attached pilasters,buttresses plinth and string courses etc. from top of foundationlevel upto floor two level including all leads and lifts etc.complete in all respects |
| 7 | Providing form work with mild steel plates 3.15 mm thick welded with angle iron in frame 30x30x5mm so as to give a fair finish including centering, shuttering, strutting and propping etc. with wooden battens and ballies height of propping and centering below supporting floor to ceiling not exceeding 4 meters and removal of the same for insitu reinforced concrete work and plain concrete work in: |
| 8 | Flat surfaces such as soffits of suspended floors, roofs , landing and the like ,i/c all leads and lifts, complete in all respects. |
| 9 | Vertical surface such as wall (any thickness) partitions and the like including attached pilasters, buttresses, plinth and string courses and the like including carriage of materials upto all leads and lifts complete in all respects. . |
| 10 | Providing and laying cement concrete work 1:2:4(1 Cement :2 Sand: 4 graded stone aggregate 20mm nominal size)and curing complete excluding cost of form work & rainforcement for reinforced concrete work in :- |
| 11 | Suspended floor, roofs landings shelves and their supports, balconies, beams, girders, bressumers and cantilevers up to floor two level including carriage of materials with in all leads and lifts, complete in all respects. |
| 12 | Providing tor steel reinforcement for RCC work including bending, binding and placing in position complete upto floor two level including cost of binding wires and carriage of materials upto all leads and lifts complete in all respects. |
| 13 | Providing and fixing SFRC man hole cover and frame (Medium duty) circular type with cleare opening 560mm dia confirming to IS: 12592 part I & II on the topping beam of man hole chambar during conecting of chamber including all leads and fifts complete in all respects. |
| 14 | Laying and Jointing 32 mm dia GMS tube (Light class) for scour , over flow, outlet , inlet , ventilating pipe including all carriage of materials upto all leads and lifts complete in all respects. |
| 15 | Providing and Installing submersible pump confirming to ISS 8034-1976 along with a directly coupled submersible type squirrel cage electric induction motor suitable for operation on 440-V-3 phase 50 CPS AC supply with water lubricated bearings, provided with pivoted segment type thrust bearings to with stand vertical pressure with minimum wear and tear and with device to take up the expansion of water with heating of motor complete in all respects including entire carriage of materials upto all leads and lifts complete in all respect.Discharge : 0.75 LPS Total Head =195.00 metres Dia of Rising main= 32 mm Length of Rising main= 335 meters |
| 16 | Supply and fixing rope wire 4 mm2 dia suitable to wear the weight of submersible motor pumps set and G.I pipe etc complete in all respects. |
| 17 | Supplying and fixing submersible cable 4mm2 3 core submersible cable of L&T/Havell make complete in all respects. |
| 18 | Supply and fixing three phase pannel board of BS/L&T /Havells/BS make with Ampares meter ,Volt meter,Over load relay Kit Kat indicator set MCCBetc.including carriage of material up to all leads and lifts complete in all espects. |
| 19 | Supply and fixing of supporting clamps of suitable size to weir the weight of submersible pump set complete in all respect. |
| 20 | Providing Laying jointing ,testing and lowering in bore 32mm dia pipe PPR column pipe PN 16 SDR 7.4 Three layer standred ISI make including all leads and lifts complete in all respects. |
| 21 | Lifting of Hand Pump and Lowering of submersible motor and pump in the bore well and to the entire satisfaction of the Engineer -in-charge. complete in all respects. |
| 22 | Earthing with G.I earth plate 600mm x 600mm x 6mm thick, including accessories and providing masonary enclosure with cover plate having locking arrangement and watering pipe etc. (but without charcoal or coke and salt ) complete as required Extra for using salt & coke for G.I. or copper plate earth electrode complete as required. |
| 23 | Providing and fixing GI wire with GI Pipe fencing arround the bore well 6 mm2 with gate welding and locking arrangement at site complete in all respects. |
| 24 | Providing and fixing PVC pipe 20 mm dia for laying of PVC submercible cable from control pannel to hand pump and to the entire satisfaction of the Engineer -in-charge . |
| 25 | Providing and fixing of 32 mm dia GI Riser Pipe (Heavy grade) plain ended as per upto date amendments electric resistance welded completed in all respect. (Inside Bore) |
| 26 | Laying and jointing in trenches G.I pipe (Light class) tube fittings & commissiong testing at site (earth work in trenches to be measured and paid for separately) including all carriage of materials up to all leads and lifts complete in all respects. |
| 27 | 20 mm dia |
| 28 | 25 mm dia |
| 29 | 32 mm dia |
| 30 | Providing and fixing Gun metal Gate valve (Medium duty) ISI marked of following dia i/c carriage of materials upto all leads and lifts complete in all respects. |
| 31 | 20 mm dia |
| 32 | 25 mm dia |
| 33 | 32 mm dia Please Enable Macros to View BoQ information |
