|
| 1 | Please Enable Macros to View BoQ information |
| 2 | All in all comprehensive maintenance of various type air conditioners including repair / replacement of compressor, condensing/cooling coil, refrigerant piping, fan motor, remote, charging of refrigerant whenever required and periodical servicing as per OEM'S recommendations and standard terms & conditions of PWD to meet efficient performance of the equipment. |
| 3 | 1.5/1.8/2.0 split type air conditiones |
| 4 | All in all comprehensive maintenance of Water cooler including compressor, condensing/cocling coil water tank withering inciding repas /replacerse of components the membrane, charging of whenever required, dearing servicing OEMS recedetion and standard tw & conditions of PVD to meet wit performance of the equipment. |
| 5 | Up to 60/120 Ltr capacity |
| 6 | All in all annual maintenance and repair charges of various make refrigerator (Fridge) including charging of refrigerant, replacement of compressor, relay, thermostat, Timer, indicating lamp, etc. complete in all respect of following capacity |
| 7 | up to 210 litre capacity |
| 8 | All in all annual maintenance and repair charges of various make ceiling/Exhaust/wall fan including charging of bearing, Oiling, Blades, etc. complete in all respect of following capacity |
| 9 | P&F of 3 speed rotary switch for Desert Cooler complete with testing etc as required |
| 10 | P & Replacement of M.S. Shaft of fan motor for Desert Cooler/ exhaust fan. Replacement of material or components shall be use as per guidelines of OEM of original product. All the scrap material should be retained by the contractor. |
| 11 | P & replacement of supporting legs (4 no.) of vertical pump of desert cooler as required for Desert Cooler/ exhaust fan. Replacement of material or components shall be use as per guidelines of OEM of original product. All the scrap material should be retained by the contractor. |
| 12 | P & F of stud with nuts and washer for Desert Cooler/ exhaust fan. All the scrap material should be retained by the contractor. |
| 13 | Servicing and overhauling of 20\\" sweep desert cooler including oiling, greasing, painting of tank from inside with rubber paint after properly dismantling each assembly and refixing the same as required. |
| 14 | Painting of desert cooler with two coats of rubber paint inside of water tank and two coat of synthetic enameled paint on both side of cooler body, fan body, grills etc. after cleaning with sand paper, complete in all respect as required. |
| 15 | Replacement of cooler pads (heavy) set of 3 no. of size 25\\" x 27\\" |
| 16 | P & F aluminiun blade for 20\\" desert cooler fan as required. |
| 17 | P & Fouter/inner threaded PVC nipple 1/2\\" dia and 2\\" long |
| 18 | P & Replacement of pvc pipe of 1/2\\" size for vertical pump of desert cooler as required. Replacement of material or components shall be use as per guidelines of OEM of original product. All the scrap material should be retained by the contractor. |
| 19 | P&F of submersible pump set suitable for 36 \\"Desert cooler\\" |
| 20 | All in all annual maintenance and repair charges of various make cooler including charging of bearing, Oiling, Blades, ped etc. complete in all respect of following capacity |
| 21 | Supply & fixing of evaporative cooling honey pads of 100mm Thick made out for desert coller impregnated cellulose paper media of imported origin including fixing in Air washer complete in all respect. All as per pre approved by Engineer in-charge. For additional technical parameters of products/ work , refer Annexure \\"A\\" attached with this BSR . |
