Tender For Strengthening/Renovation Of Electrical And Mechanical Equipment Including Painting At Kailash Nagar, Buland Masjid, Krishna Nagar,Ip Extention, Smb Shashtri Park And Laxmi Nagar Pumping Station Under Eee-Ii Shahdara South Zone, Delhi-Delhi
TDR : 54262620
Tender Notice
BOQ
3 Days Left
Delhi
Delhi
Tender For Strengthening/Renovation Of Electrical And Mechanical Equipment Including Painting At Kailash Nagar, Buland Masjid, Krishna Nagar,Ip Extention, Smb Shashtri Park And Laxmi Nagar Pumping Station Under Eee-Ii Shahdara South Zone
Work Name: Strengthening/Renovation of Eiectrical and mechanical equipments including paintingat Kailash Nagar, Buland Masjid, Krishna Nagar,IP Extention, SMB Shashtri Park and Laxmi Nagar Pumping Station under EEE-II Shahdara South Zone
Sl. No.
Item Description
1
Painting with synthetic enamel paint of approved brand and manufacture to give an even shade . Two or more coats on new work
2
Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required.
3
Providing and fixing name board made of MS Sheet 90x60cm, 1mm thick with frame of MS angle 50x50x6mm, two diagonal braces at the back of the sheet of MS flat 40x6mm, total height of the board above ground level 2.40m, length of legs below ground 0.30m embedded in CC block 1:2:4 (1cement: 2coarse sand: 4graded stone aggregate 20mm nominal size) 30x30x45cm including excavation and removal of surplus earth with in 50m lead, applying priming coat of approved steel primer, painting with synthetic enamel paint of approved quality and lettering with enamel paint of approved colour (one side) as per drawing/direction of Engineer-in-Charge.
4
Provising and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:2:4 (1 cement:2 coarse sand (zone-III) derived from natural source : 4 grade stone aggregate 20 mm nominal size derived from natural sources)
5
Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+0.05%), total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling/self tapping screws of size (5.5x55mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
