|
| 1 | Demolition of brick work built in cement morter including all quoins, arches, pillars etc, complete all as specified and directed. |
| 2 | M&L brick work with sub class \"B\"old size bricks straight or curved on plan exc 6 m mean radis built in CM 1:6 complete all as specified and directed. |
| 3 | All as per item No 2 above but except bricks after cleaning old bricks complete all as specified and directed. Note :- Old serviceable bricks retrived from demolition shall be used under this item. |
| 4 | Demolition of reinforced cement concrete in ground floors and paving not exceeding 15 cm thickness (below or above ground level)complete all as specified and directed |
| 5 | M & L PCC 1:4:8 Type D-2 (using 40mm graded stone aggregate) in foundations, filling and mass concrete complete all as specified and directed. |
| 6 | M&L for cement concrete work in pavement/hardstanding of flexural strength 40 Kg/Per Square centimetre in field using 400 Kg of cement per cubic metre, with using vaccume dewatering plant, floating operation with power floater, finishing the top surface of concrete even and smooth with power trowel (surface vibrator) and needle vibrator including necessary form work to sides and edges of concrete, thickness of concrete as per site requirement and all as specified and directed by Engr-in-Charge. |
| 7 | Add/Deduct to item 6 if Extra/less/kg of cement used for cubic metre complete all as specified and directed. |
| 8 | M&L for PCC 1:2:4 type B-1 (using 20mm graded crushed stone aggregate) as incoping, bed block, kneels, apex stones etcincluding weathering slightly rounded or chamfered including form work complete all as specified and directed. |
| 9 | Finishing surface of concrete roads, pavements,brooming and lining as required complete all as specified and directed |
| 10 | Demolition of reinforced concreteof any description and any poisition not otherwise specifically provide (reinforcement cut to faciliatate demolition) complete all as specified and directed. |
| 11 | S&F mild steel TMT bars No 500D 10mm dia and over, cut to length bent to shape requiredincluding cranking, bending spirally for hooping for columns, hooking ends and binding with and including MSwire (annealed) not less than 0.9mm dia or securing clips complete all as specified and directed. |
| 12 | M&L TMT bars 5mm dia & over upto and including 10mm dia in stirrups spacers & binders etc all as specified and as directed. |
| 13 | M&Lfor RCC Nominal Mix type 1:2:4 B1(using 20mm graded stone aggregate) Walls, retaining walls, basementwalls, ballast walls and the like;any thickness; above top offootings; including attachedpilaster and buttresses etc all as specified and directed. |
| 14 | M&L flat Formwork to faces of walls,retaining walls, abutments,parapets and staircase railingsand similar work includingattached pillasters, buttresses etc. vertical or to batter complete all as specified & directed. |
| 15 | Taking down of cementplaster of any description from brick or stone wall etc. including raking out of joints, hacking for key, scrubbing down with water etc complete all as specified and directed. |
| 16 | M & Lfor applying 15 mm thick rendering using ready mix plaster bags on brick / concrete surfaces of external/internal walls finished even and smooth as per manufacturer instructions, complete all as specified and directed |
| 17 | M& L preparing plastered new surfaces of wall and applying three coats of white wash on wall surface complete all as specified and directed |
| 18 | M& L preparing plastered old surfaces of wall and applying two coats of white wash on wall surface complete all as specified and directed |
