|
| 1 | Schedule \"A\" Part-I (B/R itmes)Demolition of cement concrete (unreinforced) in ground floors and pavings not exceeding 15 cm thickness (below or above ground level) including removal the rubbish/ demolished material outside defence land, complete, all as specified and directed by the Engineer-in-Charge. |
| 2 | Material and labour for vibratory rubber moulded coloured precast concrete interlocking paver block, any shape and sizeconforming to IS 15658-2006,ISI marked of 60 mm thickness, grade M-35 with grey cement andpigments over and including a layer of sand cushioning, 25 mm thickcomplete all as specified and as directed by the Engineer-in-Charge. |
| 3 | Material and labour for vibratory rubber moulded precast coloured concrete interlocking paver block, any shape and sizeconforming to IS 15658-2006, ISI marked of 80 mm thickness, grade M-40 with grey cement andpigments over and including a layer of sand cushioning, 25 mm thickcomplete all as specified and as directed by the Engineer-in-Charge. |
| 4 | Material and labour broken stone hardcoreof gauge notexc. 63mm, deposited , spread and levelled in layers n exc 15cm thick each layer, watered and rammed to a true surface, complete all as specified and as directed by the Engineer-in-Charge. |
| 5 | Supply,laying and fixing at or near ground level, factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage, complete, all as specified and as directed by the Engineer-in-Charge. |
| 6 | Material and labour for providing PCC (1:4:8) Type D2 using 40mm graded crushed stone aggregate as in foundationsfilling and mass concrete, complete, all as specified and as directed by the Engineer-in-Charge. |
| 7 | Excavation in trenches, not exc 1.5 m wide and not exc 1.5 m in depth for foundation or laying cable, pipe, etc or for shafts, wells, manholes etc. not exc 10 sqm on plan and not exc 1.5 m in depth and getting out in soft/ loose soil, complete, all as specified and as directed by the Engineer-in-Charge. |
| 8 | Returning, filling in, including spreading, levelling ,watering and well ramming in layers not exceeding 25cm thick each layer, complete, all as specified and as directed by the Engineer-in-Charge. |
| 9 | Removing surplus excavated materialto a distance not exc. 50m and depositing where directedcomplete all as specified and as directed by the Engineer-in-Charge. |
| 10 | Material and labour for PCC (1:3:6), type C-1,using 20 mm gaded crushed stone aggregate as in coping, benching /paving etc., complete all as specified and as directed by the Engr-in-Charge. |
| 11 | Material and labour for plain cement concrete 1:2:4, type B-2 (using 40mm graded mechanically crushed stone aggregate), as in surface channels and drains complete, all as specified and as directed by the Engineer-in-Charge. |
| 12 | Material and labour for 10mm thickfull body vitrified coloured paver tiles (Techstone series) of size 600 x 600mm in floors etc set and jointed in neat cement slurry and pointed in white or coloured cement to match over and including 15mm thick screed bed in cement mortar (1:4) , complete all as specified and as directed by the Engineer-in-Charge. Make: Tech stone series of Somany or equivalent make given in App ‘B’ |
| 13 | Dismantling of posts or struts (wooden or R.C.C) any section , including taking out embedded portion and making good disturbed ground (postsembedded in concrete, brick work, masonry, etc.) complete,all as specified and as directed by the Engineer-in-Charge. |
| 14 | Dismantling of fencing of any type/sizeand in any position, neatly coiledand removing from site complete, all as specified and as directed by the Engineer-in-Charge. |
| 15 | Excavating in post holes (or similar holes) in soft/loosesoil,each not exceeding 0.5 Cum, getting out and removing surplus soil to a distance not exceeding 50m and making good surface complete all as specified and as directed by the Engineer-in-Charge. |
| 16 | Material and labour for PCC (1:3:6), Type C-2, using 40mm graded crushed stone aggregate as in foundations, filling and mass concrete, complete, all as specified and as directed by the Engineer-in-Charge. |
| 17 | Fixing only chain link fencing including line wires, any mesh, size and typeto any type of standards, rails, straining bolts, etc. including provision of binding wire complete, all as specified and as directed by the Engineer-in-Charge. |
| 18 | Supply only chain link MS galvanisedfencing includingany size and type to any type of standards, complete, all as specified and as directed by the Engineer-in-Charge. Note :-Weight of chain link fencing shall be ascertainedby BOO as ordered by GE. |
| 19 | Material and labour for mild steel work in hand rails, half round or other stock section or core for wooden handrail straight portion, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embedding in concrete and screwing etc. wind ties for roof including securing bolts, posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc. flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc, and similar work conforming to Fe 290 Gde E-165, complete, all as specified and as directed by the Engineer-in-Charge. |
| 20 | Supply and fixing,as in repair, galvanized, 2 strand, steel barbed wire 2.24mm diabarbed with 2mm dia barbs at 75mm spacings and straining and fixingto any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanized mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured), complete, all as specified and as directed by the Engineer-in-Charge. |
| 21 | Material and labour forTMT steel bars 10mm dia and over cut to length, bent to shape reqd incl cranking, bending, spirally for hooping for columns, hooking ends and binding with and including mild steel wire annealed not less than 0.9mm dia, complete, all as specified and as directed by the Engineer-in-Charge. |
| 22 | Material and labour for mild steel round bars of 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips quality conforming to Gd I, IS-432 Part I complete all as specified and as directed by the Engr-in-Charge. |
| 23 | Material and labour forTMTsteel bars 6 mm dia and over up to and including 10mm dia in stirrups, spacers etc, cut to length, bent to shape reqd incl cranking, bending, spirally for hooping for columns, hooking ends and binding with and including mild steel wire annealed not less than 0.9mm dia, complete, all as specified and as directed by the Engineer-in-Charge. |
| 24 | Material and labour for reinforced cement concrete (1:1 ½ :3), type A-1, using 20mm graded mechanically crushed stone aggregate in Columns, pillars, piers, posts and struts and the like complete all as specified and directed by Engr-in-Charge. |
| 25 | Material and labour for formwork to sides of pillars, posts, struts, piers, columns and stanchions flat rough finished surfaces of concrete, complete, all as specified and as directed by the Engineer-in-Charge. |
| 26 | Supply & fixing mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, orscrewed both ends, each screwed end to be fittedwith washers and one hexagonal or square nut,exc 15cm but not exc 22.5 cm long , diameter of neck 11 to 15mm,complete all as specified and as directed by the Engineer-in-Charge |
| 27 | Material and labour for MS framed work as in bands, straps, supports or stays for rainwater, ventilating pipes, including bolts, if required; hooks (stay), heavy, for large gates; hook and pintle hinges; largehasps and staples; chains; hand made sliding bolts; clamps; hold fasts; will ties; hooks for hanging fans; plain angle cleats for securing purlins to wood trusses or rafters; knee piece inserts; two way and three way straps, plate washers and similar small articles conforming to Fe410-0 or Fe 310-0 complete all as specified and directed |
| 28 | Material and labour for mild steel work as in grills over compound walls incl of ornamental design as approved by the Eng-in-Charge complete all as specified and directed. |
| 29 | Material and labour for 16 to 18 mm thick granite (of any type) work (table rubbed and polished) in steps, jambs, pillars, window cills, cooking platforms and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite over and including 15mm thick rendering in cemet mortar (1:4),as in repair complete, all as specified and as directed by the Engineer-in-Charge. |
| 30 | Dismantling of brick work built in cement mortar or cement lime mortar including all quoins, arches,pillar, etc. but excluding ashlar facing, dressed stone work and precast concrete articles, complete all as specified and as directed by the Engineer-in-Charge. |
| 31 | Material and labourbrick work with sub class \"B\" old size bricks straight or curved on plan exceeding 6 metre mean radius built in cement mortar (1:4), complete all as specified and as directed by the Engineer-in-Charge. |
| 32 | All as per serial No. 31 here in before but except bricks (the old serviceable bricks asobtained from serial item No30here in before shall be used the rates includesremoving motar, cleaning the bricks with water, etc),complete, all as specified and as directed by the Engineer-in-Charge. |
| 33 | Schedule \"A\" Part-II (E/M itmes)Supply and Laying or fixing or passing through pipe or laid in trenches and testing cableXLPE insulated, armoured heavy duty electric cable with multistranded aluminium conductor 1100 volts grade, 2 core of size 10 Sq.mm, complete all as specified and as directed. (Note:- excavation & earth will shall be measured & paid under respective item ofB/R portion) |
| 34 | Supply and fixingLED post top luminaire 40W- 45W, 5700K, IP-65 made of pressure die-cast aluminium housing & clear glass 240 volt, 50HZ, AC supply completewithall accessories, including electronic driver, internally pre wiredincluding provision of 3 core PVC flexible copper conductor from electric supply source to connector of the light, including disconnecting and taking down existing light fitting and removing old unserviceable fitting, complete all as specified and as directed by the Engineer-in-Charge. Cat Part No.HLPT-04-40CW of Make Halonix or equivalentin make given in Appx \"B\". |
| 35 | Supply & fixingLED Flood lights, 100 watts, IP-66, aluminum die cast housing with unique lens system and toughened glasswith gasket240 volt, 50Hz, AC supplycompletewithall accessories internally pre wiredincluding connecting with flexible copper conductorto connector of the light with necessary fixing arrangements, including disconnecting and taking down existing old unserviceable fitting, complete all as specified and as directed by the Engineer-in-Charge. Cat part No. LFSM-100-C-V3 of make Orient or equivalentin make given in Appx \"B\". |
| 36 | Supply and fixing light grade GI Tubing of 25 mm bore for cable protection / fixing of post top luminaire / fixing of flood lightalong with necessary fixing arrangement on wall / fencing / pole with suitable sie of clamp, nut, bolts, washer etc., complete all as specified and as directedby Engineer-in-Charge |
| 37 | M&L submain wiringwith 2 runs of copper conductor FRLS PVC insulated unsheathed cable 1100 volt grade 1.5 sqmm drawn through PVC conduit medium grade ISI marked25mm dia as per IS specification fixed concealedin wall/ceiling including conduit and conduit accessories and incl provn of PVC insulated 1.5 Sqmm FRLS multistranded copper conductor as earth continuity conductor connected to earth dolly all as specified including dismantling old and making good to the disturbed surface by plastering and two coat of distamper all as directed at site Note : Two runs of 1.5 sqmm cable alongwith one run of 1.5 Sqmm PVC insulated unsheathedcopper conductor as earth wire, conduitand conduit accessories will be measured as one length. |
| 38 | Supply & fixing in replacement Thermoplastic cable junction box with 02 Nos PVC gland, weather proof with IP 65 protection for outdoor installation (with knock outs for cable entry of size 155 x 155 x100 mm hinged type with 2 Nos Aluminium bus bar of size 25mmX6mm and 8 Nos terminals with nut and bolt mounted on bus bars and MCB 10 Amp rating 01 Nos and include connection with existing cable including suitable fittings for fixing in the PCC / wall with nut & bolt, fastners complete all as specified and directed. |
| 39 | Supply and laying well burnt brick class–B laid flat to cover the cable with width equal to the length of cable and abutting each other for protection of cable complete all as specified and as directed. |
| 40 | Material and labour for dry sand cushoning to cable i.e 8 cm before laying cable in trenches and 15 cm after laying the cable and compacting complete all as specified and as directed Note: punned thickness shall be measured for payment. |
| 41 | Note:-Amount of credit ofRs. 40,213.75 for retrieved materials is mentioned in Schedule of Credit Page No.111 of tender documents in pdf form which will be deducted offline while acceptance of tender. |
