|
| 1 | Excavation in trenches not exceeding 1.5M width and not exceeding 1.5M depth and getting out for laying of pipe etc in soft/loose soil complete all as specified and directed. |
| 2 | Returning, filling including spreading, levelling, watering and well ramming in layers not exceeding 25 cm in in soft/loose soil complete all as specified and directed. |
| 3 | Removing excavated surplus in soft/loose soil to a distance not exceeding 50M and depositing where directed and at a level not exceeding 1.5M above the starting point complete all as specified and directed. |
| 4 | Taking out old unserviceable GI/CI/DI pipe line alongwith fittings from existing connections of size 150 mm dia complete all as specified and directed. |
| 5 | All as per Item No 4.00 but of size 100 mm dia. |
| 6 | All as per Item No 4.00 but of size 80mm dia. |
| 7 | All as per Item No 4.00 but of size 50mm dia. |
| 8 | All as per Item No 4.00 but of size 40 mm dia. |
| 9 | All as per Item No 4.00 but of size 25 mm dia. |
| 10 | All as per Item No 4.00 but of size 20 mm dia. |
| 11 | All as per Item No 4.00 but of size 15 mm dia. |
| 12 | Supply, lay and testing Ductuile iron pipes with flanged ends class K9 confirming to IS:8329 with inside surface of centrifugaly cast cement morter lined suitable for fiber board gasket/rubber joint in any length laid in trenches/fixed on wall/on RCC frame structure of size 150 mm dia complete all as specified and directed. |
| 13 | S&F in replacement for DI pipe line fittings 150 mm flanged joint with complete all as specified and directed. |
| 14 | Supply & Laying in trenches galvanised steel water tubing ofmedium grade with all fittings such as bends, elbows, tees, unions, nipples, short pieces etc as required at site of size 100 mm dia complete all as specified and directed. Note :- (i) Excavation and earth work shall be measured and paid seperately under relevant item of Sch A (ii) The rates quoted inclusive of cutting, jointing and testing of the pipe. |
| 15 | All as per Item No 14.00 but of size 80 mm dia. |
| 16 | All as per Item No 14.00 but of size 50 mm dia. |
| 17 | All as per Item No 14.00 but of size 40 mm dia. |
| 18 | All as per Item No 14.00 but of size 25 mm dia. |
| 19 | All as per Item No 14.00 but of size 20 mm dia. |
| 20 | All as per Item No 14.00 but of size 15 mm dia. |
| 21 | Supply & Fixing galvanised steel water tubing of medium grade with all fittings such as bends, elbows, tees, unions, nipples, short pieces etc and fixed to walls and ceilings or laid in floors all as directed of size 25 mm dia complete all as specified and directed. Note:- The rates quoted inclusive of cutting, jointing and testing of the pipe. |
| 22 | All as per Item No 21.00 but of 20 mm dia. |
| 23 | All as per Item No 21.00 but of 15 mm dia. |
| 24 | S&F in replacement of gun metal gate valves with iron wheel head screwed at both ends for iron pipes at any location of Size 50 mm dia complete all as specified and directed. |
| 25 | All as per Item No 24.00 but of 40 mm dia. |
| 26 | All as per Item No 24.00 but of 25 mm dia. |
| 27 | All as per Item No 24.00 but of 20 mm dia. |
| 28 | M & L for rectification of joint leakage of CI/DI/GI pipeline incl excavation, return filling, leadwool, lead pig, tyton Joint, \"D\" Joint, MS Clamp and short piece of CI/DI pipes as required at site etc of size 80 to 200 mm dia pipe complete all as specified and directed. Note:- Contractor will have to make arrangement for T&P, drain out/ pump out water. Cutting of road/ path/culvert shall be make good as per existing without any extra cost. |
| 29 | Repair to leakage of existing GI pipe line15 mm to 20 mm bore in any positions (joints, fittings etc) on wall ,roof, floor etcincluding replacement of GI fittings such astee ,sockets elbows,unions nipples,reducers etc incl necessaryexcavation and earth work complete all as specified and directed. |
| 30 | All as per Item No 29.00 but of dia 25 mm to 50 mm dia |
| 31 | All as per Item No 29.00 but of dia 80 mm to 100 mm dia |
| 32 | M&L for Servicing Maintenance of Non Clogging/Mono Block Centrifugal pump set coupled with electrical motor AC of capacity 5 to 10 HP, three phase, from pump house and carrying out maintenance check along with following repairs :-(a) Dismantling of centrifugal pump set in presence of MES representative and display all the parts without damage any portion for inspection to ascertain the serviceability of existing parts. (b) Heating, varnishing to stator, rotor with super quality varnish and drying out properly. (c) Cleaning, washing and greasing of ball bearing complete. (d) Checking play of impeller and bushing of pump and repair/replacement of bushes, gland, sleeves etc. (e) Assembling of motor and pump with old serviceable parts and replacement of UNSV parts with new as ordered where necessary. (f) Installation of motor by making connections as per existing and testing on load complete. Note:- Anyrepair and replacement of parts like Shaft, Shaft Sleeve, bearing, gasket, gland packing, Nuts bolts washers etc and labour cost to be included in the quoted rates. |
| 33 | All as per Item No 32.00 but Mono Block Centrifugal pump set for fresh water discharge of capacity 10 to 20 HP complete all as specified and directed. |
| 34 | M&L for Rewinding of motor 5 to 10 HP Three phase dismanteled from Fresh water discharge Centrifugal pump set complete, as per existing gauge/size/turns super enemalled copper winding wire complete all as specified and directed. |
| 35 | All as per Item No 34.00 but of capacity 10 HP to 20 HP complete all as specified and directed. |
| 36 | Supply and fix in repairs fully automatic star delta starter suitable for 05 to 15 HP Centrifugal Pumpset motor 415 volts 50 Hz Panel mounting complete with contactor and suitable thermal relay complete all as specified and directed. |
| 37 | Supply only set of rubber gasket packing suitable for Centrifugal Pump Set 05 to 20 HP complete all as specified and directed. |
| 38 | M & L for construction of valve pit, stone masonry construction complete with mild steel sheet cover 3 mm thick and angle iron frame of size 40 x 40 x 6 mm duly painted with two coats of synthetic enamel paint over a coat of red oxide primer and including locking arrangement and lifting handle all as specified and shown on drawing. All internal surface and external surface upto 15 cm below normal ground level of stone masonry shall be plastered 15 mm thick in cement mortar 1:4, finish even and smooth including necessary excavation and earth work in any type of soil including dismantling of old existing RR masonary valve pit chamber complete all as specified anddirected for the following of inner sizes :- |
| 39 | 1050 mm x 750mmx 1000 mm |
| 40 | 1350mmX1000mmX1200mm |
| 41 | M&L for drilling and tapping in CI/GI water main of 15/20/25mm bore any size in position for branch connection withfittingcomplete all as specified and directed. |
| 42 | Supply, fixing, testing and commissioning of cast iron sluice valve of class PN 1.6 ISI marked confirming to IS 14846, both ends flanged with iron wheel head and brass spindle non rising type including necessary jointing material like nuts, bolts and washers, rubber gasket of following sizes including taking up or down old unserviceable sluice valve complete all as specified and directed.Note :- Cost of any repairs of valve pit for making good shall deemed to be included in quoted rate. No extra be admissible on this a/c. |
| 43 | 150 mm bore |
| 44 | 100 mm bore |
| 45 | 80 mm bore |
| 46 | Supply only set of \"O\" ringssuitable for Centrifugal Pump Set 05 to 20 HP complete all as specified and directed. |
| 47 | M/L for Boring hole under road ,pavement, hard standing by manually or machine for laying CI pipes of 50/40/25/20/15 mm size complete all as specified and directed. |
| 48 | All as per Item No 42.00 but 100 mm bore |
| 49 | All as per Item No 42.00 but 150 mm bore |
| 50 | S&F in replacement for GI pipe line fittings(tee, elbow, Union,bends or any) complete all as specified anddirected. |
| 51 | M&L in replacement MS sheet cover/Angle iron/MS pipe/Nut bolt including fixing arrangement as per site reqmt & two coats of synthetic enamel black paint over one coat of red oxide primer complete all as specified and directed. |
| 52 | Total in Figures |
| 53 | Quoted Amount in Words |
