|
| 1 | Brick work with common burnt clay selected F.P.S. (non modular) bricks of class designation 7.5 in exposed brick work including making horizontal and vertical grooves 10 mm wide 12 mm deep complete incement mortar 1:6 (1 cement : 6 coarse sand Above plinth level upto floor V level |
| 2 | 12 mm cement plaster of mix 1:4 (1 cement: 4 coarse sand including of all work complete |
| 3 | Providing and fixing 1mm thick M.S. sheet door with frame of 40x40x6 mm angle iron and 3 mm M.S. gusset plates at the junctions and corners, all necessary fittings complete, including applying a priming coat of approved steel primer.Using M.S. angels 40x40x6 mm for diagonal braces |
| 4 | Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete Hot finished welded type tubes |
| 5 | Supply & Fixing Galvanised Corrugated 1.0mm thick iron roof including all fitting |
| 6 | Excavation in foundation in ordinary soil including lift upto 1.50 M. and lead upto 30 M. and all complete as per S.I. No. 251. |
| 7 | Construction of granular sub base by providing well graded material spreading in uniform layers with motor grader on prepared surface mixing by mix in place method with rotavator at OMC, and compacting with vibratory roller to achive desire density complete as per technical specification clause as per MORD 401 |
| 8 | M-150 Class B/W in 1:4 cement, coarse sand 1.25 F.M motar in foundation and plinth including supply of all materials, labour , T & P etc. As per P.W.D. S.I. No. 305(a) |
| 9 | Construction of un-reinforced plain cement concrete pavement, thickness as per design, over a prepared sub base, with grade cement or any other type as per Clause 1501.2.2 M (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and construction joints, applying debonding strips, primer, sealant, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days,using curing compound (where specified) and water finishing to lines and grade as per drawing and finished with Power Trowel Cum Floter-Trimix Flooring Machine.Technical Specification Clause 1501. |
| 10 | P.C.C work in 1:2:4 Cement, c/ sand, and 20 mm stone grit including supply of all materials, labour , T & P etc. As per S.I.No 279(a) |
| 11 | R.C.C Work 1:1.5:3 in cement,c.sand and 20 mm stone grit in door sills, chaukhat, boundry post etc as per si no 282(a) for Road xing |
| 12 | Providing and applying plaster of paris putty of 2 mm thickness over plastered surface to prepare the surface even and smooth complete |
| 13 | Finishing walls with Acrylic Smooth exterior paint of required shade New work (Two or more coat applied @ 1.67 ltr/10 sqm over and including priming coat of exterior primer applied @ 2.20 kg/10 sqm) |
| 14 | Red sand stone work for gang saw cut stone work for wall lining etc (veneer work) up to 10 mtr height including making of keys of stone all complete including laying& fixing I/c rubbing, grinding, making of joints, curves, corners and eposy jointing and touchups wherever reqd. and fixing of stainless steel 316 clamps 2 Nos. to each derb stone affixed to sub strate using ss dash fastners of bosch / hilti make including all Taxes, labour, T&P etc.(D.S.R 8.14.5.1) |
| 15 | M.s or tor steel in plain such as RCC work i/c its cutting, bending & binding complete As Per DSR 5.22 |
| 16 | FORM WORK_Centering and shuttering including strutting, propping etc. and removal of Lintels, beams, plinth beams, girders, bressumers and cantilevers |
| 17 | Lettering or writing with desired paint on the gate |
| 18 | Providing & fixing of Granite stone with all complete work including all |
| 19 | Add 18 % GST Amount Please Enable Macros to View BoQ information |
